Cargando…

Improved Interlaminar Fracture Toughness and Electrical Conductivity of CFRPs with Non-Woven Carbon Tissue Interleaves Composed of Fibers with Different Lengths

Non-woven carbon tissue (NWCT) with different fiber lengths was prepared with a simple surfactant-assistant dispersion and filtration method and used as interleaving to enhance both delamination resistance and electrical conductivity of carbon fiber reinforced plastics (CFRPs) laminates. The toughin...

Descripción completa

Detalles Bibliográficos
Autores principales:	Xu, Feng, Yang, Bo, Feng, Lijie, Huang, Dedong, Xia, Min
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7240603/ https://www.ncbi.nlm.nih.gov/pubmed/32260088 http://dx.doi.org/10.3390/polym12040803

Ejemplares similares

Simultaneous enhancement of electrical conductivity and interlaminar fracture toughness of carbon fiber/epoxy composites using plasma-treated conductive thermoplastic film interleaves
por: Li, Wei, et al.
Publicado: (2018)

Interlaminar Fracture Behavior of Carbon Fiber/Polyimide Composites Toughened by Interleaving Thermoplastic Polyimide Fiber Veils
por: Lan, Bangwei, et al.
Publicado: (2021)

Experimental Analysis of the Influence of Drill Point Angle and Wear on the Drilling of Woven CFRPs
por: Feito, Norberto, et al.
Publicado: (2014)

Improving Interlaminar Fracture Toughness and Impact Performance of Carbon Fiber/Epoxy Laminated Composite by Using Thermoplastic Fibers
por: Chen, Ling, et al.
Publicado: (2019)

Efficient Improvement in Fracture Toughness of Laminated Composite by Interleaving Functionalized Nanofibers
por: Razavi, Seyed Mohammad Javad, et al.
Publicado: (2021)

Composite Interlaminar Fracture Toughness Enhancement Using Electrospun PPO Fiber Veils Regulated by Functionalized CNTs
por: Huang, Yuan, et al.
Publicado: (2023)

Rubbery-Modified CFRPs with Improved Mode I Fracture Toughness: Effect of Nanofibrous Mat Grammage and Positioning on Tanδ Behaviour
por: Maccaferri, Emanuele, et al.
Publicado: (2021)

Enhanced Surface Energetics of CNT-Grafted Carbon Fibers for Superior Electrical and Mechanical Properties in CFRPs
por: Badakhsh, Arash, et al.
Publicado: (2020)

A Review of Electrospun Nanofiber Interleaves for Interlaminar Toughening of Composite Laminates
por: Mahato, Biltu, et al.
Publicado: (2023)

Investigation on Mode I Fracture Toughness of Woven Carbon Fiber-Reinforced Polymer Composites Incorporating Nanomaterials
por: Truong, Gia Toai, et al.
Publicado: (2020)

Improvement of the mode II interface fracture toughness of glass fiber reinforced plastics/aluminum laminates through vapor grown carbon fiber interleaves
por: Ning, Huiming, et al.
Publicado: (2014)

Flash Thermography to Evaluate Porosity in Carbon Fiber Reinforced Polymer (CFRPs)
por: Meola, Carosena, et al.
Publicado: (2014)

Rubber-enhanced polyamide nanofibers for a significant improvement of CFRP interlaminar fracture toughness
por: Maccaferri, Emanuele, et al.
Publicado: (2022)

Effect of Interlaminar Toughness on the Residual Compressive Capacity of Carbon Fiber Laminates with Different Types of Delamination
por: Zhang, Yao, et al.
Publicado: (2022)

Mode-I Fracture Behavior of CFRPs: Numerical Model of the Experimental Results
por: Barile, Claudia, et al.
Publicado: (2019)

Heat as a Conductivity Factor of Electrically Conductive Yarns Woven into Fabric
por: Penava, Željko, et al.
Publicado: (2022)

Experimental Characterization and Analysis of the In-Plane Elastic Properties and Interlaminar Fracture Toughness of a 3D-Printed Continuous Carbon Fiber-Reinforced Composite
por: Santos, Jonnathan D., et al.
Publicado: (2022)

Numerical and Experimental Analysis of the Mode I Interlaminar Fracture Toughness in Multidirectional 3D-Printed Thermoplastic Composites Reinforced with Continuous Carbon Fiber
por: Santos, Jonnathan D., et al.
Publicado: (2023)

The Impact of Elongation on Change in Electrical Resistance of Electrically Conductive Yarns Woven into Fabric
por: Knezić, Željko, et al.
Publicado: (2021)

Performance control study of interleaved meltblown non-woven materials based on statistical analysis and predictive modeling
por: Xu, Hao, et al.
Publicado: (2023)

Introduction of SWCNTs as a Method of Improvement of Electrical and Mechanical Properties of CFRPs Based on Thermoplastic Acrylic Resin
por: Demski, Szymon, et al.
Publicado: (2023)

A Mixing Model for Describing Electrical Conductivity of a Woven Structure
por: Tokarska, Magdalena
Publicado: (2022)

Improved Strength and Toughness of Carbon Woven Fabric Composites with Functionalized MWCNTs
por: Soliman, Eslam, et al.
Publicado: (2014)

Stretchable fabric generates electric power from woven thermoelectric fibers
por: Sun, Tingting, et al.
Publicado: (2020)

Mixed-Mode Interlaminar Fracture Toughness of Glass and Carbon Fibre Powder Epoxy Composites—For Design of Wind and Tidal Turbine Blades
por: Floreani, Christophe, et al.
Publicado: (2021)

Characterization of Mode I and Mode II Interlaminar Fracture Toughness in CNT-Enhanced CFRP under Various Temperature and Loading Rates
por: Yenigun, Burak, et al.
Publicado: (2023)

Lengths for Which Fourth Degree PP Interleavers Lead to Weaker Performances Compared to Quadratic and Cubic PP Interleavers
por: Trifina, Lucian, et al.
Publicado: (2020)

Enhanced Open-Hole Strength and Toughness of Sandwich Carbon-Kevlar Woven Composite Laminates
por: Khan, Mohammad K. A., et al.
Publicado: (2023)

Sequentially bridged graphene sheets with high strength, toughness, and electrical conductivity
por: Wan, Sijie, et al.
Publicado: (2018)

The Impact of Carbon Nanofibres on the Interfacial Properties of CFRPs Produced with Sized Carbon Fibres
por: Zhang, Zhenxue, et al.
Publicado: (2021)

Enhancement of the Electrical Conductivity and Interlaminar Shear Strength of CNT/GFRP Hierarchical Composite Using an Electrophoretic Deposition Technique
por: Haghbin, Amin, et al.
Publicado: (2017)

Electrothermally Self-Healing Delamination Cracks in Carbon/Epoxy Composites Using Sandwich and Tough Carbon Nanotube/Copolymer Interleaves
por: Ouyang, Qin, et al.
Publicado: (2022)

Digital Image Correlation Comparison of Damaged and Undamaged Aeronautical CFRPs During Compression Tests
por: Barile, Claudia, et al.
Publicado: (2019)

Effect of SWCNT-Tuball Paper on the Lightning Strike Protection of CFRPs and Their Selected Mechanical Properties
por: Dydek, Kamil, et al.
Publicado: (2021)

Mechanical Properties, Surface Assessment, and Structural Analysis of Functionalized CFRPs after Accelerated Weathering
por: Semitekolos, Dionisis, et al.
Publicado: (2021)

Study on the Tensile Behavior of Woven Non-Woven PLA/OLA/MgO Electrospun Fibers
por: Leonés, Adrián, et al.
Publicado: (2023)

Investigation of the performance of okra fiber in woven fabric
por: Islam, Md. Rafiqul, et al.
Publicado: (2022)

Electromagnetic Shielding Effectiveness of Woven Fabrics with High Electrical Conductivity: Complete Derivation and Verification of Analytical Model
por: Neruda, Marek, et al.
Publicado: (2018)

Transparent, Conductive Hydrogels with High Mechanical Strength and Toughness
por: Xu, Xiuru, et al.
Publicado: (2021)

Fracture toughness of titanium–cement interfaces: effects of fibers and loading angles
por: Khandaker, Morshed, et al.
Publicado: (2014)

Cannot write session to /tmp/vufind_sessions/sess_5n8l0c0a1n28rr0cig81fqnka1