Cargando…

Dendrite Morphology Evolution of Al(6)Mn Phase in Suction Casting Al–Mn Alloys

The effects of solute element content and cooling rate on the morphology of Al(6)Mn phase in suction casting Al–Mn alloys were investigated by transmission electron microscope, scanning electron microscope, and X-ray diffractometer. Results show that Al(6)Mn dendrite morphology with different degree...

Descripción completa

Detalles Bibliográficos
Autores principales:	Chen, Zhongwei, Hou, Yue, Xie, Bin, Zhang, Qi
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7288217/ https://www.ncbi.nlm.nih.gov/pubmed/32455932 http://dx.doi.org/10.3390/ma13102388

Ejemplares similares

Heat Treatment of Cast and Cold Rolled Al–Yb and Al–Mn–Yb–Zr Alloys
por: Kodetová, Veronika, et al.
Publicado: (2021)

Microstructure and Mechanical Properties of High Vacuum Die-Cast AlSiMgMn Alloys at as-Cast and T6-Treated Conditions
por: Liu, Fei, et al.
Publicado: (2019)

The Al(61.49)Mn(11.35)Ni(4) phase in the Al–Mn–Ni system
por: Hu, Qifa, et al.
Publicado: (2022)

Study on the Microstructure of Mg-4Zn-4Sn-1Mn-xAl As-Cast Alloys
por: Liu, Junlin, et al.
Publicado: (2023)

Effects of Mn, Zn Additions and Cooling Rate on Mechanical and Corrosion Properties of Al-4.6Mg Casting Alloys
por: Wu, Chih-Ting, et al.
Publicado: (2020)

Crystal structure of the Al(20)Mn(5.37)Ni(1.31) phase in the Al–Mn–Ni system
por: Hu, Qifa, et al.
Publicado: (2021)

Effect of Mn on the Properties of Powder Metallurgy Ti-2.5Al-xMn Alloys
por: Alshammari, Yousef, et al.
Publicado: (2023)

Microstructure and Mechanical Properties of As-Aged Mg-Zn-Sn-Mn-Al Alloys
por: Hou, Caihong, et al.
Publicado: (2022)

Comparative study of mechanical properties of cast and forged Al-3Mg-MnO(2) and Al-8Mg-MnO(2) composites
por: Narain, Vikas, et al.
Publicado: (2020)

High Temperature Deformation of Twin-Roll Cast Al-Mn-Based Alloys after Equal Channel Angular Pressing
por: Málek, Přemysl, et al.
Publicado: (2015)

Tailored Adhesion Properties of Acrylate Adhesives on Al Alloys by the Addition of Mn-Al–LDH
por: Tomić, Natasa Z., et al.
Publicado: (2021)

Influence of Al Addition on the Microstructure and Mechanical Properties of Mg-Zn-Sn-Mn-Ca Alloys
por: Yan, Shujuan, et al.
Publicado: (2023)

Effect of Mechanical Vibration on the Mechanical Properties and Solidification Feeding in Low-Pressure Sand Casting of Al-Cu-Mn-Ti Alloy
por: Chen, Wei, et al.
Publicado: (2022)

Effect of Mn and Fe on the Formation of Fe- and Mn-Rich Intermetallics in Al–5Mg–Mn Alloys Solidified Under Near-Rapid Cooling
por: Liu, Yulin, et al.
Publicado: (2016)

Influence of cerium content on the microstructure and thermal expansion properties of suction cast Al-Cu-Fe alloys
por: Wang, Juan, et al.
Publicado: (2021)

Magnetic States in Ensemble of Ferromagnetic Nanoparticles in Cu-Mn-Al Alloy
por: Konoplyuk, S. M., et al.
Publicado: (2016)

Effect of Thermomagnetic Treatment on Structure and Properties of Cu–Al–Mn Alloy
por: Titenko, A. N., et al.
Publicado: (2017)

Hot Deformation Behavior of a New Al–Mn–Sc Alloy
por: Kang, Weiqi, et al.
Publicado: (2019)

The Effect of the β-Al(5)FeSi Phases on Microstructure, Mechanical and Fatigue Properties in A356.0 Cast Alloys with Higher Fe Content without Additional Alloying of Mn
por: Kuchariková, Lenka, et al.
Publicado: (2021)

Influence of Homogenization on Microstructural Response and Mechanical Property of Al-Cu-Mn Alloy
por: Wang, Jian, et al.
Publicado: (2018)

Effect of Al Element on the Microstructure and Properties of Cu-Ni-Fe-Mn Alloys
por: Yang, Ran, et al.
Publicado: (2018)

Corrosion and Oxidation Behavior of a Fe-Al-Mn-C Duplex Alloy
por: Barella, Silvia, et al.
Publicado: (2019)

Modulation of Multiple Precipitates for High Strength and Ductility in Al-Cu-Mn Alloy
por: Liu, Linxiang, et al.
Publicado: (2021)

Influence of nano-VC on the structural and magnetic properties of MnAlC-alloy
por: Shtender, Vitalii, et al.
Publicado: (2021)

Influence of Manganese Content on Martensitic Transformation of Cu-Al-Mn-Ag Alloy
por: Liverić, Lovro, et al.
Publicado: (2023)

Preparation of Al(3)Ti-Al(2)O(3)/Al Inoculant and Its Inoculation Effect on Al-Cu-Mn Alloy
por: Ding, Jinhua, et al.
Publicado: (2023)

Influence of Preparation Technology on Microstructural and Magnetic Properties of Fe(2)MnSi and Fe(2)MnAl Heusler Alloys
por: Jirásková, Yvonna, et al.
Publicado: (2019)

Microstructures and Phases in Electron Beam Additively Manufactured Ti-Al-Mo-Zr-V/CuAl9Mn2 Alloy
por: Zykova, Anna, et al.
Publicado: (2023)

Improving Mechanical Properties of Mg-Al-RE Alloys with the Formed Dimples of Al(10)Mn(2)RE Particles and Activated Pyramidal <a> Slip with Mn Additions
por: Yang, Jiandong, et al.
Publicado: (2023)

Investigations of High-Strength Mg–Al–Ca–Mn Alloys with a Broad Range of Ca+Al Contents
por: Gneiger, Stefan, et al.
Publicado: (2021)

Microstructure and Properties of Mg-Al-Ca-Mn Alloy with High Ca/Al Ratio Fabricated by Hot Extrusion
por: Chu, Aimin, et al.
Publicado: (2021)

Fabrication of MnCuNiFe–CuAlNiFeMn Gradient Alloy by Laser Engineering Net Shaping System
por: Yan, Kuo, et al.
Publicado: (2022)

Composition Optimization and Mechanical Properties of Mg-Al-Sn-Mn Alloys by Orthogonal Design
por: Guan, Maosheng, et al.
Publicado: (2018)

Effect of Multidirectional Forging on the Grain Structure and Mechanical Properties of the Al–Mg–Mn Alloy
por: Kishchik, Mikhail S., et al.
Publicado: (2018)

The Influence of Cu-Additions on the Microstructure, Mechanical and Magnetic Properties of MnAl-C Alloys
por: Jürries, Florian, et al.
Publicado: (2020)

Effect of Zn Content on the Microstructure and Mechanical Properties of Mg–Al–Sn–Mn Alloys
por: Zhao, Tianshuo, et al.
Publicado: (2019)

The Microstructure and Corrosion Resistance of Fe-B-W-Mn-Al Alloy in Liquid Zinc
por: Luo, Zixiang, et al.
Publicado: (2022)

The Texture and Structure of the Melt-Spun Co(2)MnAl-Type Heusler Alloy
por: Diko, Pavel, et al.
Publicado: (2021)

Coupled Effects of Temperature and Humidity on Fracture Toughness of Al–Mg–Si–Mn Alloy
por: Alqahtani, Ibrahim, et al.
Publicado: (2023)

Microstructure and Corrosion Behavior of Laser-Welded Al–Mn–Zr Alloy for Heat Exchanger
por: Lim, Jeong-Min, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_b40h3qi9k3i8g0mv7bq997j5qi