Cargando…

Properties of Fibrous Concrete Made with Plastic Optical Fibers from E-Waste

This article presents research results relating to the potential for waste utilization in the form of polymer optical fiber (POF) scraps. This material is difficult to recycle due to its diverse construction. Three different volumes of POF were used in concrete in these tests: 1%, 2%, and 3%. The ex...

Descripción completa

Detalles Bibliográficos
Autores principales:	Suchorab, Zbigniew, Franus, Małgorzata, Barnat-Hunek, Danuta
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7288338/ https://www.ncbi.nlm.nih.gov/pubmed/32466157 http://dx.doi.org/10.3390/ma13102414

Ejemplares similares

Mechanical and Physical Properties of Hydrophobized Lightweight Aggregate Concrete with Sewage Sludge
por: Suchorab, Zbigniew, et al.
Publicado: (2016)

Utilization of Recycled Liquid Crystal Display (LCD) Panel Waste in Concrete
por: Góra, Jacek, et al.
Publicado: (2019)

Flexural Behavior of Composite Concrete Slabs Made with Steel and Polypropylene Fibers Reinforced Concrete in the Compression Zone
por: Sadowska-Buraczewska, Barbara, et al.
Publicado: (2020)

Influence of Biodegradable Release Oils on the Physical and Mechanical Properties of Light-Colored Architectural Concrete
por: Barnat-Hunek, Danuta, et al.
Publicado: (2021)

Composite Materials Based on Hemp and Flax for Low-Energy Buildings
por: Brzyski, Przemysław, et al.
Publicado: (2017)

Durability of Hydrophobic/Icephobic Coatings in Protection of Lightweight Concrete with Waste Aggregate
por: Barnat-Hunek, Danuta, et al.
Publicado: (2020)

Utilization of sewage sludge in the manufacture of lightweight aggregate
por: Franus, Małgorzata, et al.
Publicado: (2015)

Influence of Water with Oxygen and Ozone Micro-Nano Bubbles on Concrete Physical Properties
por: Grzegorczyk-Frańczak, Małgorzata, et al.
Publicado: (2022)

A Noninvasive TDR Sensor to Measure the Moisture Content of Rigid Porous Materials
por: Suchorab, Zbigniew, et al.
Publicado: (2018)

Correction: Barnat-Hunek, D., et al. Durability of Hydrophobic/Icephobic Coatings in Protection Lightweight Concrete with Waste Aggregate. Materials 2021, 14, 101
por: Barnat-Hunek, Danuta, et al.
Publicado: (2021)

Influence of Recycled High-Performance Aggregate on Deformation and Load-Carrying Capacity of Reinforced Concrete Beams
por: Sadowska-Buraczewska, Barbara, et al.
Publicado: (2020)

The Microstructure-Mechanical Properties of Hybrid Fibres-Reinforced Self-Compacting Lightweight Concrete with Perlite Aggregate
por: Barnat-Hunek, Danuta, et al.
Publicado: (2018)

Impact of Different Binders on the Roughness, Adhesion Strength, and Other Properties of Mortars with Expanded Cork
por: Barnat-Hunek, Danuta, et al.
Publicado: (2018)

Physical Properties of Mineral and Recycled Aggregates Used to Mineral-Asphalt Mixtures
por: Andrzejuk, Wojciech, et al.
Publicado: (2019)

Effect of Eco-Friendly Cellulose Nanocrystals on Physical Properties of Cement Mortars
por: Barnat-Hunek, Danuta, et al.
Publicado: (2019)

Surface Modification of Lightweight Mortars by Nanopolymers to Improve Their Water-Repellency and Durability
por: Szafraniec, Małgorzata, et al.
Publicado: (2020)

Physical Properties and Durability of Lime-Cement Mortars Prepared with Water Containing Micro-Nano Bubbles of Various Gases
por: Grzegorczyk-Frańczak, Małgorzata, et al.
Publicado: (2021)

The Wastes of Sanitary Ceramics as Recycling Aggregate to Special Concretes
por: Ogrodnik, Paweł, et al.
Publicado: (2018)

Effect of Glass Fiber-Reinforced Plastic Waste on the Mechanical Properties of Concrete and Evaluation of Its Feasibility for Reuse in Concrete Applications
por: Zhao, Tianhao, et al.
Publicado: (2023)

Axial and Shear Buckling Analysis of Multiscale FGM Carbon Nanotube Plates Using the MTSDT Model: A Numerical Approach
por: Kumar, Ravi, et al.
Publicado: (2022)

A Critical Review on Modification Methods of Cement Composites with Nanocellulose and Reaction Conditions during Nanocellulose Production
por: Szafraniec, Małgorzata, et al.
Publicado: (2022)

Investigation of the effectiveness of CFRP strengthening of concrete made with recycled waste PET fine plastic aggregate
por: Qaidi, Shaker, et al.
Publicado: (2022)

Static Analysis of Skew Functionally Graded Plate Using Novel Shear Deformation Theory
por: Singh, Jitendra, et al.
Publicado: (2022)

Textile Pressure Sensor Made of Flexible Plastic Optical Fibers
por: Rothmaier, Markus, et al.
Publicado: (2008)

Evaluating Soil Moisture Status Using an e-Nose
por: Bieganowski, Andrzej, et al.
Publicado: (2016)

Heat Losses Caused by the Temporary Influence of Wind in Timber Frame Walls Insulated with Fibrous Materials
por: Kosiński, Piotr, et al.
Publicado: (2020)

Processes of Fatigue Destruction in Nanopolymer-Hydrophobised Ceramic Bricks
por: Fic, Stanisław, et al.
Publicado: (2017)

Transition Zone Enhancement with Waste Limestone Powder as a Reason for Concrete Compressive Strength Increase
por: Kępniak, Maja, et al.
Publicado: (2021)

Technogenic Fiber Wastes for Optimizing Concrete
por: Klyuev, Sergey, et al.
Publicado: (2022)

Effect of Polysiloxanes on Roughness and Durability of Basalt Fibres–Reinforced Cement Mortar
por: Barnat-Hunek, Danuta, et al.
Publicado: (2018)

Flexural and Free Vibration Analysis of CNT-Reinforced Functionally Graded Plate
por: Ansari, Md Irfan, et al.
Publicado: (2018)

Application of Recycled Ceramic Aggregates for the Production of Mineral-Asphalt Mixtures
por: Andrzejuk, Wojciech, et al.
Publicado: (2018)

Overview of Concrete Performance Made with Waste Rubber Tires: A Step toward Sustainable Concrete
por: Ahmad, Jawad, et al.
Publicado: (2022)

Performance Evaluation of Plastic Concrete Modified with E-Waste Plastic as a Partial Replacement of Coarse Aggregate
por: Ahmad, Farhan, et al.
Publicado: (2021)

Hygrothermal Analysis of Laminated Composite Skew Conoids
por: Chaubey, Abhay, et al.
Publicado: (2019)

Effects of Polypropylene Fibers on the Frost Resistance of Natural Sand Concrete and Machine-Made Sand Concrete
por: Tan, Yan, et al.
Publicado: (2022)

Low-Cost Fiber Chopped Strand Mat Composites for Compressive Stress and Strain Enhancement of Concrete Made with Brick Waste Aggregates
por: Joyklad, Panuwat, et al.
Publicado: (2022)

Bi-Axial Buckling of Laminated Composite Plates Including Cutout and Additional Mass
por: Anish,, et al.
Publicado: (2019)

Dynamic Response of Angle Ply Laminates with Uncertainties Using MARS, ANN-PSO, GPR and ANFIS
por: Mishra, Bharat Bhushan, et al.
Publicado: (2021)

Properties of Concrete Made with Low-Emission Cements CEM II/C-M and CEM VI
por: Król, Anna, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_28r1o4n1h8terbe0q41kgvsu9o