Cargando…

Microstructure Evolution in Cu-Ni-Co-Si-Cr Alloy During Hot Compression by Ce Addition

Cu-Ni-Si alloys are widely used in lead frames and vacuum devices due to their high electrical conductivity and strength. In this paper, a Cu-Ni-Co-Si-Cr-(Ce) alloy was prepared by vacuum induction melting. Hot compression tests of the Cu-Ni-Co-Si-Cr and Cu-Ni-Co-Si-Cr-Ce alloys were carried out usi...

Descripción completa

Detalles Bibliográficos
Autores principales:	Ban, Yijie, Zhang, Yi, Tian, Baohong, Jia, Yanlin, Song, Kexing, Li, Xu, Zhou, Meng, Liu, Yong, Volinsky, Alex A.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7412277/ https://www.ncbi.nlm.nih.gov/pubmed/32708753 http://dx.doi.org/10.3390/ma13143186

Ejemplares similares

Dynamic recrystallization behavior and processing map of the Cu–Cr–Zr–Nd alloy
por: Zhang, Yi, et al.
Publicado: (2016)

Hot Deformation Behavior and Microstructure Evolution of Cu–Ni–Co–Si Alloys
por: Liu, Feng, et al.
Publicado: (2020)

The Influence of Ag on the Microstructure and Properties of Cu-Ni-Si Alloys
por: Krupińska, Beata, et al.
Publicado: (2020)

Microstructure and Wear Resistance of Laser-Clad Ni–Cu–Mo–W–Si Coatings on a Cu–Cr–Zr Alloy
por: Zhao, Xiaojun, et al.
Publicado: (2022)

Effect of Al Element on the Microstructure and Properties of Cu-Ni-Fe-Mn Alloys
por: Yang, Ran, et al.
Publicado: (2018)

Effects of Co Addition on the Properties and Microstructure of Cu-Ni-Si-P-Mg Alloys
por: Cheng, Jianyi, et al.
Publicado: (2021)

Effect of Ni/Si Mass Ratio and Thermomechanical Treatment on the Microstructure and Properties of Cu-Ni-Si Alloys
por: Li, Jiang, et al.
Publicado: (2019)

Effects of Cold Rolling Reduction Rate on the Microstructure and Properties of Cu-1.16Ni-0.36Cr Alloy after Thermo-Mechanical Treatment
por: Sun, Wenming, et al.
Publicado: (2023)

Relationship between Microstructure and Properties of Cu-Cr-Ag-(Ce) Alloy Using Microscopic Investigation
por: Chen, Huiming, et al.
Publicado: (2017)

Effect of Si on Microstructure and Mechanical Properties of FeCrNi Medium Entropy Alloys
por: Ding, Fang, et al.
Publicado: (2023)

Effects of Co Addition on the Microstructure and Properties of Elastic Cu-Ni-Si-Based Alloys for Electrical Connectors
por: Wang, Zheng, et al.
Publicado: (2021)

Influence of the Ni/Co Mass Ratio on the Microstructure and Properties of Quaternary Cu-Ni-Co-Si Alloys
por: Li, Jiang, et al.
Publicado: (2019)

Effects of Nb Additions and Heat Treatments on the Microstructure, Hardness and Wear Resistance of CuNiCrSiCoTiNb(x) High-Entropy Alloys
por: Avila-Salgado, Denis Ariel, et al.
Publicado: (2022)

Investigation of Microstructure and Wear Properties of Precipitates-Strengthened Cu-Ni-Si-Fe Alloy
por: Peng, Chun-Hao, et al.
Publicado: (2023)

Study on Microstructure of Fiber Laser Welding of CoCrCuFeNi High Entropy Alloy
por: Li, Juan, et al.
Publicado: (2022)

Microstructural Evolution and an Improved Dynamic Recrystallization Kinetic Model of a Ni-Cr-Mo Alloy in Hot Deformation
por: Yan, Xintao, et al.
Publicado: (2022)

Effect of Si and C additions on the reaction mechanism and mechanical properties of FeCrNiCu high entropy alloy
por: Wu, Hao, et al.
Publicado: (2019)

Hot Deformation Behavior and Microstructure Evolution of a Novel Al-Zn-Mg-Li-Cu Alloy
por: Wu, Shuaishuai, et al.
Publicado: (2022)

Precipitation Strengthening of Cu–Ni–Si Alloy
por: Krupińska, Beata, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of Cast Al-Si-Cu-Mg-Ni-Cr Alloys: Effects of Time and Temperature on Two-Stage Solution Treatment and Ageing
por: Xiao, Lairong, et al.
Publicado: (2023)

Effect of Ni Content on Microstructure and Characterization of Cu-Ni-Sn Alloys
por: Du, Sanming, et al.
Publicado: (2018)

In Situ and Ex Situ Characterization of the Microstructure Formation in Ni-Cr-Si Alloys during Rapid Solidification—Toward Alloy Design for Laser Additive Manufacturing
por: Li, Xiaoshuang, et al.
Publicado: (2020)

Relationship between Microstructure and Properties of Cu–Cr–Ag Alloy
por: Liang, Dong, et al.
Publicado: (2020)

Effect of Ag on Properties, Microstructure, and Thermostability of Cu–Cr Alloy
por: Sun, Yuqing, et al.
Publicado: (2020)

The Effect of Cu Addition on the Precipitation Sequence in the Al-Si-Mg-Cr Alloy
por: Chen, Bin, et al.
Publicado: (2022)

Effect of Sn Addition on Microstructure, Aging Properties and Softening Resistance of Cu-Cr Alloy
por: Xu, Gaolei, et al.
Publicado: (2022)

Microstructure, Phase Evolution, and Chemical Behavior of CrCuFeNiTiAlx High Entropy Alloys Processed by Mechanical Alloying
por: del Ángel-González, Anay, et al.
Publicado: (2023)

Microstructure and Mechanical Properties of Spark Plasma Sintered CoCrFeNiNbX High-Entropy Alloys with Si Addition
por: Karlík, Miroslav, et al.
Publicado: (2023)

Microstructural Evolution and Dynamic Softening Mechanisms of Al-Zn-Mg-Cu Alloy during Hot Compressive Deformation
por: Shi, Cangji, et al.
Publicado: (2014)

Experimental and Numerical Studies on Hot Compressive Deformation Behavior of a Cu–Ni–Sn–Mn–Zn Alloy
por: Zhang, Yufang, et al.
Publicado: (2023)

Research Progress on Cu–15Ni–8Sn Alloys: The Effect of Microalloying and Heat Treatment on Microstructure and Properties
por: Yang, Shaodan, et al.
Publicado: (2023)

The Precipitation Behavior of a Cu-Ni-Si Alloy with Cr Addition Prepared by Heating-Cooling Combined Mold (HCCM) Continuous Casting
por: Meng, Xianghao, et al.
Publicado: (2022)

Microstructure Evolution and Mechanical Properties of Al–Cu–Mg Alloys with Si Addition
por: Shah, Abdul Wahid, et al.
Publicado: (2023)

Phases, Microstructures and Mechanical Properties of CoCrNiCuZn High-Entropy Alloy Prepared by Mechanical Alloying and Spark Plasma Sintering
por: Sun, Yuchen, et al.
Publicado: (2019)

Effect of Hot Rolling on the Microstructure and Properties of Nanostructured 15Cr ODS Alloys with Al and Zr Addition
por: Li, Zhengyuan, et al.
Publicado: (2020)

Microstructure Transformation in Laser Additive Manufactured NiTi Alloy with Quasi-In-Situ Compression
por: Yang, Xiao, et al.
Publicado: (2022)

Microstructural Evolution of AlCoCrFeNiSi High-Entropy Alloy Powder during Mechanical Alloying and Its Coating Performance
por: Tian, Lihui, et al.
Publicado: (2018)

Precipitation Characteristics of the Metastable γ″ Phase in a Cu-Ni-Be Alloy
por: Zhu, Zhiyuan, et al.
Publicado: (2018)

Effect and Mechanism of Solidified Microstructure on Deformation Behavior, Mechanical Properties, and Residual Stress of Cu-Ni-Si Alloy
por: Liao, Wanneng, et al.
Publicado: (2022)

Influences of Cold Rolling and Aging on Microstructure and Property of CuCrSn Alloy
por: Chen, Tao, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_m4pf2n8por3oq648ii27i0ak4o