Cargando…

Study on the Microstructure, Mechanical Properties, and Erosive Wear Behavior of HVOF Sprayed Al(2)O(3)-15 wt.%TiO(2) Coating with NiAl Interlayer on Al-Si Cast Alloy

Alumina oxide coatings are widely used in many industrial applications to improve corrosion protection, wear and erosion resistances, and thermal insulation of metallic surfaces. The paper presents study of the microstructure, mechanical, and wear properties of HVOF (high velocity oxy-fuel process)...

Descripción completa

Detalles Bibliográficos
Autores principales:	Ksiazek, Marzanna, Boron, Lukasz, Tchorz, Adam
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7560332/ https://www.ncbi.nlm.nih.gov/pubmed/32948062 http://dx.doi.org/10.3390/ma13184122

Ejemplares similares

Investigation on Microstructure, Mechanical and Wear Properties of HVOF Sprayed Composite Coatings (WC–Co + CR) On Ductile Cast Iron
por: Ksiazek, Marzanna, et al.
Publicado: (2021)

Characterization of Al(2)O(3) Matrix Composites Fabricated via the Slip Casting Method Using NiAl-Al(2)O(3) Composite Powder
por: Zygmuntowicz, Justyna, et al.
Publicado: (2022)

Characterization of Al(2)O(3) Samples and NiAl–Al(2)O(3) Composite Consolidated by Pulse Plasma Sintering
por: Konopka, Katarzyna, et al.
Publicado: (2021)

First-Principles Study on Interlayer Spacing and Structure Stability of NiAl-Layered Double Hydroxides
por: Wang, Xiaoliang, et al.
Publicado: (2022)

Structural Dynamics of Al(2)O(3)/NiAl(110) During Film Growth in NO(2)
por: Mom, Rik V., et al.
Publicado: (2017)

Preparation and Performance Evolution of Plasma Sprayed Abradable CuAl/PHB–NiAl Layered Seal Coatings
por: Zhang, Shuting, et al.
Publicado: (2022)

Corrosion and Erosion Wear Behaviors of HVOF-Sprayed Fe-Based Amorphous Coatings on Dissolvable Mg-RE Alloy Substrates
por: Yang, Jun, et al.
Publicado: (2023)

Microstructure and Mechanical Characterization of Novel Al(2)O(3)–(NiAl–Al(2)O(3)) Composites Fabricated via Pulse Plasma Sintering
por: Zygmuntowicz, Justyna, et al.
Publicado: (2023)

High Temperature Oxidation Behaviors of BaO/TiO(2) Binary Oxide-Enhanced NiAl-Based Composites
por: Li, Bo, et al.
Publicado: (2021)

Pulse Plasma Sintering of NiAl-Al(2)O(3) Composite Powder Produced by Mechanical Alloying with Contribution of Nanometric Al(2)O(3) Powder
por: Konopka, Katarzyna, et al.
Publicado: (2022)

Preparation and Study of Composite Materials of the NiAl-Cr-Mo-Nanoparticles (ZrO(2), MgAl(2)O(4)) System
por: Agureev, Leonid, et al.
Publicado: (2022)

Microstructure and Mechanical Properties of the 6 wt% Mn-Doped Martensitic Steel Strengthened by Cu/NiAl Nanoparticles
por: Jiang, Yan, et al.
Publicado: (2022)

Effect of Microstructure and Hardness on Cavitation Erosion and Dry Sliding Wear of HVOF Deposited CoNiCrAlY, NiCoCrAlY and NiCrMoNbTa Coatings
por: Szala, Mirosław, et al.
Publicado: (2021)

Adsorption of an Au atom and dimer on a thin θ-Al(2)O(3)/NiAl(100) film: dependence on the thickness of the θ-Al(2)O(3) film
por: Hsia, Ching-Lun, et al.
Publicado: (2018)

Shift of Creep Mechanism in Nanocrystalline NiAl Alloy
por: Sun, Zhihui, et al.
Publicado: (2019)

Impact Wear of the Protective Cr(3)C(2)-Based HVOF-Sprayed Coatings
por: Daniel, Josef, et al.
Publicado: (2020)

A Study of Erosion–Corrosion Behaviour of Friction Stir-Processed Chromium-Reinforced NiAl Bronze Composite
por: Dutta, Varun, et al.
Publicado: (2022)

Preparation of NiAl(2)O(4)-Based Flexible Substrates for Metamaterials with Negative Dielectric Properties
por: Rahman, Md Atiqur, et al.
Publicado: (2018)

NiAl-Cr-Mo Medium Entropy Alloys: Microstructural Verification, Solidification Considerations, and Sliding Wear Response
por: Mathiou, Christina, et al.
Publicado: (2020)

Promoted activity of annealed Rh nanoclusters on thin films of Al(2)O(3)/NiAl(100) in the dehydrogenation of Methanol-d(4)
por: Hung, Ting-Chieh, et al.
Publicado: (2021)

Fabrication and wear behaviour of Mg-3wt.%Al-x wt. % SiC composites
por: Jayasathyakawin, S., et al.
Publicado: (2023)

Properties and Microstructure Evaluation in NiAl-xWC (x = 0 − 90 wt.%) Intermetallic-Based Composites Prepared by Mechanical Alloying
por: Piechowiak, Daria, et al.
Publicado: (2023)

Left-handed metamaterial inspired by joint T-D geometry on flexible NiAl(2)O(4) substrate
por: Ahamed, Eistiak, et al.
Publicado: (2018)

Tribo-Mechanical Properties of HVOF Deposited Fe(3)Al Coatings Reinforced with TiB(2) Particles for Wear-Resistant Applications
por: Amiriyan, Mahdi, et al.
Publicado: (2016)

Sessile dislocations by reactions in NiAl severely deformed at room temperature
por: Geist, D., et al.
Publicado: (2015)

Synthesis of NiAl Intermetallic Compound under Shock-Wave Extrusion
por: Malakhov, Andrey, et al.
Publicado: (2022)

Fe(3)O(4)@SiO(2)@NiAl-LDH microspheres implication in separation, kinetic and structural properties of phenylalanine dehydrogenase
por: Amirahmadi, Mozhgan, et al.
Publicado: (2023)

Effect of Adjusted Gas Nitriding Parameters on Microstructure and Wear Resistance of HVOF-Sprayed AISI 316L Coatings
por: Kutschmann, Pia, et al.
Publicado: (2019)

Improved Water–Gas Shift Performance of Au/NiAl LDHs Nanostructured Catalysts via CeO(2) Addition
por: Gabrovska, Margarita, et al.
Publicado: (2021)

The Effect of the Cu Interlayer on the Interfacial Microstructure and Mechanical Properties of Al/Fe Bimetal by Compound Casting
por: Liu, Shiyuan, et al.
Publicado: (2023)

Comparison of Different Cermet Coatings Sprayed on Magnesium Alloy by HVOF
por: Jonda, Ewa, et al.
Publicado: (2021)

Role of 5 wt.% Mg Alloying in Al on Corrosion Characteristics of Al-Mg Coating Deposited by Plasma Arc Thermal Spray Process
por: Jeong, Hwa-Rang, et al.
Publicado: (2023)

The influence of sulphide on the ultrasonic cavitation erosion-corrosion behaviors of HVOF-sprayed WC-Cr(3)C(2)-Ni coating
por: Shi, Xinlu, et al.
Publicado: (2023)

Fabricating Superior NiAl Bronze Components through Wire Arc Additive Manufacturing
por: Ding, Donghong, et al.
Publicado: (2016)

Influence of a Zn Interlayer on the Interfacial Microstructures and Mechanical Properties of Arc-Sprayed Al/AZ91D Bimetals Manufactured by the Solid–Liquid Compound Casting Process
por: He, Ke, et al.
Publicado: (2019)

Microstructure and Properties of Atmospheric Plasma Sprayed (Al,Cr)(2)O(3)–TiO(2) Coatings from Blends
por: Grimm, Maximilian, et al.
Publicado: (2021)

Wear studies on plasma-sprayed Al(2)O(3) and 8mole% of Yttrium-stabilized ZrO(2) composite coating on biomedical Ti-6Al-4V alloy for orthopedic joint application
por: Ganapathy, Perumal, et al.
Publicado: (2015)

Effect of Al(2)TiO(5) Content and Sintering Temperature on the Microstructure and Residual Stress of Al(2)O(3)–Al(2)TiO(5) Ceramic Composites
por: Fan, Kunyang, et al.
Publicado: (2021)

Wear Comfort Characteristics of Al(2)O(3)/ATO/TiO(2)-Embedded Multi-Functional PET Fabrics
por: Kim, Hyun-Ah
Publicado: (2022)

Theoretical Insights into 1D Transition-Metal Nanoalloys Grown on the NiAl(110) Surface
por: Zornio, Bruno Fedosse, et al.
Publicado: (2018)

Cannot write session to /tmp/vufind_sessions/sess_7lke3auqudo96bvabgmgi4gmct