Cargando…

Effect of infection control barriers on the light output from a multi-peak light curing unit

OBJECTIVES: Curing lights cannot be sterilized and should be covered with an infection control barrier. This study evaluated the effect of barriers when applied correctly and incorrectly on the radiant power (mW), irradiance (mW/cm(2)), emission spectrum (mW/nm), and beam profile from a multi-peak l...

Descripción completa

Detalles Bibliográficos
Autores principales:	Soares, Carlos José, Braga, Stella Sueli Lourenço, Ribeiro, Maria Tereza Hordones, Price, Richard Bengt
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Elsevier Ltd. 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7569381/ https://www.ncbi.nlm.nih.gov/pubmed/33091553 http://dx.doi.org/10.1016/j.jdent.2020.103503

Ejemplares similares

Intensity output and effectiveness of light curing units in dental offices
por: Omidi, Baharan-Ranjbar, et al.
Publicado: (2018)

Assessing Dental Light-curing Units’ Output Using Radiometers: A Narrative Review
por: Assaf, Cendrella, et al.
Publicado: (2020)

Power output from 12 brands of contemporary LED light-curing units measured using 2 brands of radiometers
por: Maucoski, Cristiane, et al.
Publicado: (2022)

Infection Control Barrier and Curing Time as Factors Affecting the Irradiance of Light-Cure Units
por: Ajaj, Reem A., et al.
Publicado: (2018)

A clinical survey of the output intensity of 200 light curing units in dental offices across Maharashtra
por: Hegde, Vivek, et al.
Publicado: (2009)

Effectiveness of light emitting diode and halogen light curing units for curing microhybrid and nanocomposites
por: Choudhary, Shwetha, et al.
Publicado: (2013)

Curing Efficacy of Light Emitting Diodes of Dental Curing Units
por: Mousavinasab, Seyed Mostafa, et al.
Publicado: (2009)

Comparison of Light-Emitting Diode-Curing Unit and Halogen-Based Light-Curing Unit for the Polymerization of Orthodontic Resins: An In vitro Study
por: Guram, Guneet, et al.
Publicado: (2018)

Evaluation of effect of different disposable infection control barriers on light intensity of light-curing unit and microhardness of composite - An in vitro study
por: Khode, Rajiv Tarachand, et al.
Publicado: (2017)

Spectrophotometric and colorimetric evaluation of staining of the light cured composite after exposure with different intensities of light curing units
por: Chandrasekhar, Veeramachaneni, et al.
Publicado: (2011)

Influence of light curing units on failure of directcomposite restorations
por: Jadhav, Sameer, et al.
Publicado: (2011)

Comparison of light transmittance in different thicknesses of zirconia under various light curing units
por: Cekic-Nagas, Isil, et al.
Publicado: (2012)

The Finsen Light Cure
por: Stewart, H. John
Publicado: (1904)

Curing efficiency of dual-cure resin cement under zirconia with two different light curing units
por: Gultekin, Pınar, et al.
Publicado: (2015)

The Effect of Irradiation Distance on Microhardness of Resin Composites Cured with Different Light Curing Units
por: Cekic-Nagas, Isil, et al.
Publicado: (2010)

Comparison of the bonding strengths of second- and third-generation light-emitting diode light-curing units
por: Lee, Hee-Min, et al.
Publicado: (2016)

Utilizing Light Cure Units: A Concise Narrative Review
por: Hasanain, Fatin A., et al.
Publicado: (2021)

Evaluation of a Novel “Quad” Wavelength Light Curing Unit
por: Adams, Kevin R., et al.
Publicado: (2022)

Light intensity output of visible light communication units and clinicians' knowledge and attitude among Riyadh private clinics
por: Alqabbaa, Lama Mana, et al.
Publicado: (2018)

Heat Development in the Pulp Chamber During Curing Process of Resin-Based Composite Using Multi-Wave LED Light Curing Unit
por: Nilsen, Bo Wold, et al.
Publicado: (2020)

Light curing of dual cure resin cement
por: Chang, Hoon-Sang
Publicado: (2013)

Influence of Wrapping on the Light Output of BGO
por: Schwarz, Ronan Arvid, et al.
Publicado: (2019)

The Effect of Two Different Light-Curing Units and Curing Times on Bulk-Fill Restorative Materials
por: Bayrak, Gokcen Deniz, et al.
Publicado: (2022)

Influence of Tip Diameter and Light Spectrum of Curing Units on the Properties of Bulk-Fill Resin Composites
por: Cardoso, Igor Oliveiros, et al.
Publicado: (2021)

Bonding to Different PEEK Compositions: The Impact of Dental Light Curing Units
por: Lümkemann, Nina, et al.
Publicado: (2017)

Dentine sensitivity caused by illumination of intraoral scanner and light curing unit
por: Natongkham, Prawnapa, et al.
Publicado: (2022)

Pulp Temperature Rise Induced by Light-Emitting Diode Light-Curing Units Using an Ex Vivo Model
por: Vinagre, Alexandra, et al.
Publicado: (2019)

A switchable light-input, light-output system modelled and constructed in yeast
por: Sorokina, Oxana, et al.
Publicado: (2009)

Off-Peak 594-nm Light Surpasses On-Peak 532-nm Light in Silencing Distant ArchT-Expressing Neurons In Vivo
por: Setsuie, Rieko, et al.
Publicado: (2020)

Effect of Aspect Ratio on the Light Output of Scintillators
por: Pauwels, Kristof, et al.
Publicado: (2012)

The effects of halogen and light-emitting diode light curing on the depth of cure and surface microhardness of composite resins
por: Yaman, Batu Can, et al.
Publicado: (2011)

Effect of cross infection control barriers used on the light-curing device tips on the cure depth of a resin composite
por: de Moraes Porto, Isabel Cristina Celerino, et al.
Publicado: (2013)

Shear bond strength of a bracket-bonding system cured with a light-emitting diode or halogen-based light-curing unit at various polymerization times
por: Gupta, Sanjay Prasad, et al.
Publicado: (2018)

EFFECT OF LIGHT-CURING UNITS AND ACTIVATION MODE ON POLYMERIZATION SHRINKAGE AND SHRINKAGE STRESS OF COMPOSITE RESINS
por: Lopes, Lawrence Gonzaga, et al.
Publicado: (2008)

Effects of Different Light Curing Units/Modes on the Microleakage of Flowable Composite Resins
por: Yazici, A. Ruya, et al.
Publicado: (2008)

INFLUENCE OF THE DISTANCE OF THE CURING LIGHT SOURCE AND COMPOSITE SHADE ON HARDNESS OF TWO COMPOSITES
por: Thomé, Thaís, et al.
Publicado: (2007)

The effect of curing time by conventional quartz tungsten halogens and new light-emitting diodes light curing units on degree of conversion and microhardness of a nanohybrid resin composite
por: Tanthanuch, Saijai, et al.
Publicado: (2019)

Influence of Air-Barrier and Curing Light Distance on Conversion and Micro-Hardness of Dental Polymeric Materials
por: Ciocan, Lucian Toma, et al.
Publicado: (2022)

Micro-leakage of a Fissure Sealant Cured Using Quartz-tungsten-halogen and Plasma Arc Light Curing Units
por: Bahrololoomi, Zahra, et al.
Publicado: (2014)

Thickness-Dependent Light Transmittance and Temperature Rise in Dual-Cure Bioactive and Light-Cure Bulk-Fill Composite Resins
por: Alharbi, Reema, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_bes5pkd3v35318kn3p61aa83hc