Cargando…

Impact of Na Doping on the Carrier Transport Path in Polycrystalline Flexible Cu(2)ZnSn(S,Se)(4) Solar Cells

It is well‐known that the alkali doping of polycrystalline Cu(2)ZnSn(S,Se)(4) (CZTSSe) and Cu(In,Ga)(Se,S)(2) has a beneficial influence on the device performance and there are various hypotheses about the principles of performance improvement. This work clearly explains the effect of Na doping on t...

Descripción completa

Detalles Bibliográficos
Autores principales:	Jeong, Woo‐Lim, Kim, Kyung‐Pil, Kim, Juran, Park, Ha Kyung, Min, Jung‐Hong, Lee, Je‐Sung, Mun, Seung‐Hyun, Kim, Sung‐Tae, Jang, Jae‐Hyung, Jo, William, Lee, Dong‐Seon
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	John Wiley and Sons Inc. 2020
Materias:	Full Papers
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7610331/ https://www.ncbi.nlm.nih.gov/pubmed/33173721 http://dx.doi.org/10.1002/advs.201903085

Ejemplares similares

Improving Ultraviolet Responses in Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells Using Quantum Dot-Based Luminescent Down-Shifting Layer
por: Jeong, Woo-Lim, et al.
Publicado: (2021)

Inkjet‐Printed Cu(2)ZnSn(S, Se)(4) Solar Cells
por: Lin, Xianzhong, et al.
Publicado: (2015)

Flexible Cu(2)ZnSn(S,Se)(4) solar cells with over 10% efficiency and methods of enlarging the cell area
por: Yang, Kee-Jeong, et al.
Publicado: (2019)

Performance Enhancement in Powder-Fabricated Cu(2)(ZnSn)Se(4) Solar Cell by Roll Compression
por: Park, Jaehyun, et al.
Publicado: (2023)

Exploring the Effect of Selenidation Time on the Ni-Doped Cu(2)ZnSn(S,Se)(4) Solar Cell
por: Zeng, Fancong, et al.
Publicado: (2022)

Solution-Processed Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells Using Elemental Cu, Zn, Sn, S, and Se Powders as Source
por: Guo, Jing, et al.
Publicado: (2015)

Influence of alkali metals (Na, Li, Rb) on the performance of electrostatic spray-assisted vapor deposited Cu(2)ZnSn(S,Se)(4) solar cells
por: Altamura, Giovanni, et al.
Publicado: (2016)

Mapping Shunting Paths at the Surface of Cu(2)ZnSn(S,Se)(4) Films via Energy-Filtered Photoemission Microscopy
por: Tiwari, Devendra, et al.
Publicado: (2018)

Nanoscale observation of surface potential and carrier transport in Cu(2)ZnSn(S,Se)(4) thin films grown by sputtering-based two-step process
por: Kim, Gee Yeong, et al.
Publicado: (2014)

Efficient (Cu(1−x)Ag(x))(2)ZnSn(S,Se)(4) solar cells on flexible Mo foils
por: Yu, Xue, et al.
Publicado: (2018)

Insight into the Effect of Selenization Temperature for Highly Efficient Ni-Doped Cu(2)ZnSn(S,Se)(4) Solar Cells
por: Zeng, Fancong, et al.
Publicado: (2022)

A Study on the Effects of Selenization Temperature on the Properties of Na-Doped Cu(2)ZnSn(S,Se)(4) Thin Film and Its Correlation with the Performance of Solar Cells
por: Wang, Zhanwu, et al.
Publicado: (2021)

Band-gap-graded Cu(2)ZnSn(S(1-x),Se(x))(4) Solar Cells Fabricated by an Ethanol-based, Particulate Precursor Ink Route
por: Woo, Kyoohee, et al.
Publicado: (2013)

Sulfurization induced surface constitution and its correlation to the performance of solution-processed Cu(2)ZnSn(S,Se)(4) solar cells
por: Zhong, Jie, et al.
Publicado: (2014)

Reducing series resistance in Cu(2)ZnSn(S,Se)(4) nanoparticle ink solar cells on flexible molybdenum foil substrates
por: Xu, Xinya, et al.
Publicado: (2018)

Analytical Modeling and Optimization of Cu(2)ZnSn(S,Se)(4) Solar Cells with the Use of Quantum Wells under the Radiative Limit
por: Rodriguez-Osorio, Karina G., et al.
Publicado: (2023)

Aqueous-Solution-Processed Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells via an Improved Successive Ion-Layer-Adsorption–Reaction Sequence
por: Suryawanshi, Mahesh P., et al.
Publicado: (2017)

Optimization of the Selenization Temperature on the Mn-Substituted Cu(2)ZnSn(S,Se)(4) Thin Films and Its Impact on the Performance of Solar Cells
por: Wang, Zhanwu, et al.
Publicado: (2022)

Cu(2)ZnSn(S,Se)(4) thin-films prepared from selenized nanocrystals ink
por: Aruna-Devi, R., et al.
Publicado: (2019)

Polycrystalline SnSe with a thermoelectric figure of merit greater than the single crystal
por: Zhou, Chongjian, et al.
Publicado: (2021)

Optimizing the average power factor of p-type (Na, Ag) co-doped polycrystalline SnSe
por: Wang, Si, et al.
Publicado: (2019)

Improving carrier mobility of polycrystalline Ge by Sn doping
por: Moto, Kenta, et al.
Publicado: (2018)

Doping of Sb into Cu(2)ZnSn(S,Se)(4) absorber layer via Se&Sb(2)Se(3) co-selenization strategy for enhancing open-circuit voltage of kesterite solar cells
por: Zhao, Benhui, et al.
Publicado: (2022)

Substitution of Ag for Cu in Cu(2)ZnSn(S,Se)(4): Toward Wide Band Gap Absorbers with Low Antisite Defects for Thin Film Solar Cells
por: Wu, Yanjie, et al.
Publicado: (2020)

Enhanced efficiency of Cu(2)ZnSn(S,Se)(4) solar cells via anti-reflectance properties and surface passivation by atomic layer deposited aluminum oxide
por: Zhang, Bingye, et al.
Publicado: (2018)

Enhancing the Performance of Aqueous Solution-Processed Cu(2)ZnSn(S,Se)(4) Photovoltaic Materials by Mn(2+) Substitution
por: He, Wenjie, et al.
Publicado: (2020)

Thermoelectric Properties of Hot-Pressed Bi-Doped n-Type Polycrystalline SnSe
por: Nguyen, Van Quang, et al.
Publicado: (2018)

Defect Engineering in Solution-Processed Polycrystalline SnSe Leads to High Thermoelectric Performance
por: Liu, Yu, et al.
Publicado: (2021)

A Route to Phase Controllable Cu(2)ZnSn(S(1−x)Se(x))(4) Nanocrystals with Tunable Energy Bands
por: Ji, Shulin, et al.
Publicado: (2013)

Enhanced Thermoelectric Properties of Polycrystalline SnSe via LaCl(3) Doping
por: Li, Fu, et al.
Publicado: (2018)

Heavy Doping by Bromine to Improve the Thermoelectric Properties of n‐type Polycrystalline SnSe
por: Li, Shan, et al.
Publicado: (2018)

DMF‐Based Large‐Grain Spanning Cu(2)ZnSn(S (x) ,Se(1‐) (x) )(4) Device with a PCE of 11.76%
por: Cui, Yubo, et al.
Publicado: (2022)

Growth of Epitaxial ZnSn(x)Ge(1−x)N(2) Alloys by MBE
por: Shing, Amanda M., et al.
Publicado: (2017)

Field modulation in Na-incorporated Cu(In,Ga)Se(2 )(CIGS) polycrystalline films influenced by alloy-hardening and pair-annihilation probabilities
por: Jeong, Yonkil, et al.
Publicado: (2011)

Enhanced Thermoelectric Properties of Te Doped Polycrystalline Sn(0.94)Pb(0.01)Se
por: Li, Fujin, et al.
Publicado: (2022)

Spectroscopy and Theoretical Modeling of Phonon Vibration Modes and Band Gap Energy of Cu(2)ZnSn(S(x)Se(1–x))(4) Bulk Crystals and Thin Films
por: Babichuk, Ivan S., et al.
Publicado: (2021)

Magnetotransport and conductivity mechanisms in Cu(2)ZnSn(x)Ge(1−x)S(4) single crystals
por: Lähderanta, Erkki, et al.
Publicado: (2018)

Photovoltages in Polycrystalline Mosaic Solar Cells
por: Dinca, S. A., et al.
Publicado: (2021)

Degenerated Hole Doping and Ultra‐Low Lattice Thermal Conductivity in Polycrystalline SnSe by Nonequilibrium Isovalent Te Substitution
por: He, Xinyi, et al.
Publicado: (2022)

Hydrothermal transformation of SnSe crystal to Se nanorods in oxalic acid solution and the outstanding thermoelectric power factor of Se/SnSe composite
por: Ju, Hyun, et al.
Publicado: (2017)

Cannot write session to /tmp/vufind_sessions/sess_8736q81b980hobd21e3fnbj48p