Cargando…
The Study of Physico-Mechanical Properties of Polylactide Composites with Different Level of Infill Produced by the FDM Method
The aim of this study was to evaluate the changes in physical-mechanical properties of the samples manufactured by 3D printing technology with the addition of varying degrees of polylactide (PLA) infill (50, 70, 85 and 100%). Half of the samples were soaked in physiological saline. The material used...
Autores principales: | Gaweł, Anna, Kuciel, Stanisław |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2020
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7767082/ https://www.ncbi.nlm.nih.gov/pubmed/33419345 http://dx.doi.org/10.3390/polym12123056 |
Ejemplares similares
-
Examination of Low-Cyclic Fatigue Tests and Poisson’s Ratio Depending on the Different Infill Density of Polylactide (PLA) Produced by the Fused Deposition Modeling Method
por: Gaweł, Anna, et al.
Publicado: (2023) -
The Influence of the Gradient Infill of PLA Samples Produced with the FDM Technique on Their Mechanical Properties
por: Maszybrocka, Joanna, et al.
Publicado: (2022) -
The Effects of Combined Infill Patterns on Mechanical Properties in FDM Process
por: Lalegani Dezaki, Mohammadreza, et al.
Publicado: (2020) -
Hybrid Composites of Polylactide with Basalt and Carbon Fibers and Their Thermal Treatment
por: Kuciel, Stanisław, et al.
Publicado: (2018) -
Physico-Mechanical Properties of the Poly(oxymethylene) Composites Reinforced with Glass Fibers under Dynamical Loading
por: Kuciel, Stanisław, et al.
Publicado: (2019)