Cargando…
Analysis and Modeling of the Micro-Cutting Process of Ti-6Al-4V Titanium Alloy with Single Abrasive Grain
Modeling of material displacements in the microcutting zone is complex due to the number and interdependence of factors affecting the results of the process. An important problem in the modeling process is the selection of the constitutive model and its parameters, which will correctly describe the...
Autores principales: | Rypina, Łukasz, Lipiński, Dariusz, Bałasz, Błażej, Kacalak, Wojciech, Szatkiewicz, Tomasz |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2020
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7767466/ https://www.ncbi.nlm.nih.gov/pubmed/33371402 http://dx.doi.org/10.3390/ma13245835 |
Ejemplares similares
-
Influence of the Geometrical Features of the Cutting Edges of Abrasive Grains on the Removal Efficiency of the Ti6Al4V Titanium Alloy
por: Rypina, Łukasz, et al.
Publicado: (2022) -
Analysis of the Cutting Abilities of the Multilayer Grinding Wheels—Case of Ti-6Al-4V Alloy Grinding
por: Lipiński, Dariusz, et al.
Publicado: (2021) -
Preliminary Studies into Cutting of a Novel Two Component 3D-Printed Stainless Steel–Polymer Composite Material by Abrasive Water Jet
por: Szatkiewicz, Tomasz, et al.
Publicado: (2023) -
Methodology for Selecting the Operating Conditions of a Vibration Generator Used in the Hot-Dip Galvanizing Process
por: Kacalak, Wojciech, et al.
Publicado: (2021) -
A Method and Device for Automated Grinding of Small Ceramic Elements
por: Kacalak, Wojciech, et al.
Publicado: (2021)