Spike of interstitial PO(2) produced by a twitch in rhythmically contracted muscle

Oxygen (O(2)) exchange between capillaries and muscle cells in exercising muscles is of great interest for physiology and kinesiology. However, methodical limitations prevent O(2) measurements on the millisecond scale. To bypass the constraints of quasi‐continuous recording, progressive measurements of O(2) partial pressure (PO(2)) in rhythmically contracting skeletal muscle were compiled to describe the O(2) kinetics surrounding and including a single muscle contraction. Phosphorescence quenching microscopy measured PO(2) in the interstitium of the rat spinotrapezius muscle. Measurements were triggered by contraction‐inducing electrical pulses. For the first 60 seconds, measurement preceeded stimulation. After 60, measurement followed with a progressive 20 ms increment. Thus, the first 60 measurements describe the overall PO(2) response to electrical stimulation initiated after a 10 second rest period, while 61–100 (stroboscopic mode) were compiled into a single 800 ms profile of the PO(2) transient surrounding muscle contraction. Thirty seconds of stimulated contractions decreased interstitial PO(2) from a baseline of 71 ± 1.4 mmHg to an “active” steady‐state of 43 ± 1.5 mmHg. The stroboscopic mode compilation revealed an unexpected post‐contractile rise in PO(2) as a 205 ms spike with a maximum amplitude of 58 ± 3.8 mmHg at 68 ms, which restored 58% of the PO(2) drop from baseline. Interpretation of this phenomenon is based on classical experiments by G.V. Anrep (1935), who discovered the rapid thrust of blood flow associated with muscle contraction. In addition to the metabolic implications during exercise, the physiological impact of these PO(2) spikes may grow with an increased rate of rhythmical contractions in muscle or heart. NEW&NOTEWORTHY: The principal finding is a spike of interstitial PO(2), produced by a twitch in a rhythmically contracting muscle. A possible mechanism is flushing capillaries with arterial blood by mechanical forces. A technical novelty is the PO(2) measurement with a “stroboscopic mode” and progressively increasing delay between stimulator pulse and PO(2) measuring. That permitted a 20 ms time resolution for a 205 ms spike duration, using an excitation flash rate one per second.