Cargando…
Application of 3D Scanning as an Indirect Method to Analyze and Eliminate Errors on the Manufactured Yoke-Type Forgings Forged in SMED Device on Modernized Crank Press
This article proposes an indirect measurement method based on a dimensional and shape analysis of forgings for the evaluation of the manufacture and the proper operation of the key elements of the crank press, in which after modernization, a quick tool assembly based on SMED (Single Minute Exchange...
Autores principales: | Ziemba, Jacek, Hawryluk, Marek, Rychlik, Marcin |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2020
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7794871/ https://www.ncbi.nlm.nih.gov/pubmed/33396909 http://dx.doi.org/10.3390/ma14010137 |
Ejemplares similares
-
Wear Analysis of Forging Tools Used in an Industrial Production Process—Hot Forging in Closed Dies of the “Head-Disk” of an Engine Valve Forging
por: Hawryluk, Marek, et al.
Publicado: (2021) -
Forging of Mg-Al-Zn Magnesium Alloys on Screw Press and Forging Hammer
por: Gontarz, Andrzej, et al.
Publicado: (2020) -
The Impact of the Lubricant Dose on the Reduction of Wear Dies Used in the Forging Process of the Valve Forging
por: Dworzak, Łukasz, et al.
Publicado: (2021) -
Application of a Prototype Thermoplastic Treatment Line in Order to Design a Thermal Treatment Process of Forgings with the Use of the Heat from the Forging Process
por: Hawryluk, Marek, et al.
Publicado: (2020) -
Wear Mechanisms of the Forging Tool Used in Pre-Forming in a Double Forging System of Truck Parts
por: Krawczyk, Janusz, et al.
Publicado: (2022)