Cargando…

Co-introduction of precipitate hardening and TRIP in a TWIP high-entropy alloy using friction stir alloying

Tuning deformation mechanisms is imperative to overcome the well-known strength-ductility paradigm. Twinning-induced plasticity (TWIP), transformation-induced plasticity (TRIP) and precipitate hardening have been investigated separately and have been altered to achieve exceptional strength or ductil...

Descripción completa

Detalles Bibliográficos
Autores principales:	Wang, Tianhao, Shukla, Shivakant, Gwalani, Bharat, Sinha, Subhasis, Thapliyal, Saket, Frank, Michael, Mishra, Rajiv S.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Nature Publishing Group UK 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7810985/ https://www.ncbi.nlm.nih.gov/pubmed/33452417 http://dx.doi.org/10.1038/s41598-021-81350-0

Ejemplares similares

Interfacial reaction during friction stir assisted scribe welding of immiscible Fe and Mg alloy system
por: Das, Hrishikesh, et al.
Publicado: (2021)

Dynamic Shear Deformation of a Precipitation Hardened Al(0.7)CoCrFeNi Eutectic High-Entropy Alloy Using Hat-Shaped Specimen Geometry
por: Gwalani, Bharat, et al.
Publicado: (2020)

Influence of ordered L1(2) precipitation on strain-rate dependent mechanical behavior in a eutectic high entropy alloy
por: Gwalani, Bharat, et al.
Publicado: (2019)

Analysis and Comparison of Friction Stir Welding and Laser Assisted Friction Stir Welding of Aluminum Alloy
por: Campanelli, Sabina Luisa, et al.
Publicado: (2013)

Deformation mechanisms to ameliorate the mechanical properties of novel TRIP/TWIP Co-Cr-Mo-(Cu) ultrafine eutectic alloys
por: Kim, J. T., et al.
Publicado: (2017)

On the Fatigue Performance of Friction-Stir Welded Aluminum Alloys
por: Malopheyev, Sergey, et al.
Publicado: (2020)

Enhanced strength and ductility in a friction stir processing engineered dual phase high entropy alloy
por: Nene, S. S., et al.
Publicado: (2017)

Friction Stir Welding of 5754 Aluminum Alloy with Cover Sheet
por: Ren, Daxin, et al.
Publicado: (2019)

A New Approach in Surface Modification and Surface Hardening of Aluminum Alloys Using Friction Stir Process: Cu-Reinforced AA5083
por: Papantoniou, Ioannis G., et al.
Publicado: (2020)

Assessment of the Corrosion Behavior of Friction-Stir-Welded Dissimilar Aluminum Alloys
por: Alfattani, Rami, et al.
Publicado: (2021)

Mitigating the susceptibility to intergranular corrosion of alloy 625 by friction-stir welding
por: Lemos, Guilherme Vieira Braga, et al.
Publicado: (2022)

Joining of Dissimilar Al and Mg Metal Alloys by Friction Stir Welding
por: Sidhu, Ramandeep Singh, et al.
Publicado: (2022)

High-entropy alloy strengthened by in situ formation of entropy-stabilized nano-dispersoids
por: Gwalani, Bharat, et al.
Publicado: (2018)

Determination of Aluminum in Precipitation Hardening Stainless Steel and High Temperature Alloys
por: Machlan, Lawrence A., et al.
Publicado: (1960)

Development of Precipitation Hardening Parameters for High Strength Alloy AA 7068
por: Osten, Julia, et al.
Publicado: (2020)

Correlating work hardening with co-activation of stacking fault strengthening and transformation in a high entropy alloy using in-situ neutron diffraction
por: Frank, M., et al.
Publicado: (2020)

Microstructure and Tensile Properties of Friction Stir Processed Mg–Sn–Zn Alloy
por: Chen, Xiaoyang, et al.
Publicado: (2018)

Embrittlement Due to Excess Heat Input into Friction Stir Processed 7075 Alloy
por: Ku, Ming-Hsiang, et al.
Publicado: (2019)

Stress Corrosion Cracking of Friction Stir-Welded AA-2024 T3 Alloy
por: Cabrini, Marina, et al.
Publicado: (2020)

Optimizing Friction Stir Welding of Dissimilar Grades of Aluminum Alloy Using WASPAS
por: Rajesh, Pinnavasal Venukrishnan, et al.
Publicado: (2022)

Microstructure Evolution of Al6061 Alloy Made by Additive Friction Stir Deposition
por: Zeng, Congyuan, et al.
Publicado: (2022)

Corrosion Behavior of Friction Stir Welded AA8090-T87 Aluminum Alloy
por: Shyamlal, Chandrasekaran, et al.
Publicado: (2022)

The Effect of Al and Ti Additions on Solid Solution Strengthening and Precipitation Hardening in CoNiFe Medium-Entropy Alloys
por: Bała, Piotr, et al.
Publicado: (2023)

Investigation of Mechanical and Microstructural Properties of Welded Specimens of AA6061-T6 Alloy with Friction Stir Welding and Parallel-Friction Stir Welding Methods
por: Ghiasvand, Amir, et al.
Publicado: (2021)

Microstructural Assessment of a Multiple-Intermetallic-Strengthened Aluminum Alloy Produced from Gas-Atomized Powder by Hot Extrusion and Friction Extrusion
por: Wang, Tianhao, et al.
Publicado: (2020)

Microscopic mechanisms contributing to the synchronous improvement of strength and plasticity (SISP) for TWIP copper alloys
por: Liu, R., et al.
Publicado: (2015)

Orientation Dependent Hardening by <001> Rod-Shaped Misfitting Precipitates in Aluminium Alloys
por: Liu, Jianbin, et al.
Publicado: (2022)

Dataset for interpreting the Circos figures used in the review of friction stir welding of titanium alloys
por: Gangwar, Kapil, et al.
Publicado: (2018)

Nugget Formation and Mechanical Behaviour of Friction Stir Welds of Three Dissimilar Aluminum Alloys
por: Manuel, Neves, et al.
Publicado: (2020)

Effect of Deformation on the Corrosion Behavior of Friction Stir Welded Joints of 2024 Aluminum Alloy
por: Pang, Qiu, et al.
Publicado: (2022)

Evolution of Microstructure and Properties of Air-Cooled Friction-Stir-Processed 7075 Aluminum Alloy
por: Iwaszko, Józef, et al.
Publicado: (2022)

A Comprehensive Review of Friction Stir Additive Manufacturing (FSAM) of Non-Ferrous Alloys
por: Hassan, Adeel, et al.
Publicado: (2023)

Real-time observations of TRIP-induced ultrahigh strain hardening in a dual-phase CrMnFeCoNi high-entropy alloy
por: Chen, Sijing, et al.
Publicado: (2020)

Estimation of Phase Ratio in Bulk, Textured TWIP/TRIP Steels from Pole Figures
por: Benke, Marton, et al.
Publicado: (2021)

Group precipitation and age hardening of nanostructured Fe-based alloys with ultra-high strengths
por: Jiao, Z. B., et al.
Publicado: (2016)

Effect of Boron Doping on Cellular Discontinuous Precipitation for Age-Hardenable Cu–Ti Alloys
por: Semboshi, Satoshi, et al.
Publicado: (2015)

Assessment of hardening due to non-coherent precipitates in tungsten-rhenium alloys at the atomic scale
por: Bonny, G., et al.
Publicado: (2019)

On the effect of β phase on the microstructure and mechanical properties of friction stir welded commercial brass alloys
por: Heidarzadeh, Akbar, et al.
Publicado: (2015)

Effect of Load on the Corrosion Behavior of Friction Stir Welded AA 7075-T6 Aluminum Alloy
por: Cabrini, Marina, et al.
Publicado: (2020)

Microstructure and Properties of Nano-Hydroxyapatite Reinforced WE43 Alloy Fabricated by Friction Stir Processing
por: Cao, Genghua, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_f1hrdf3ckrgfsn7tb2ona64led