Cargando…

In-Situ Laser Polishing Additive Manufactured AlSi10Mg: Effect of Laser Polishing Strategy on Surface Morphology, Roughness and Microhardness

Laser polishing is a widely used technology to improve the surface quality of the products. However, the investigation on the physical mechanism is still lacking. In this paper, the established numerical transient model reveals the rough surface evolution mechanism during laser polishing. Mass trans...

Descripción completa

Detalles Bibliográficos
Autores principales: Zhou, Jiantao, Han, Xu, Li, Hui, Liu, Sheng, Shen, Shengnan, Zhou, Xin, Zhang, Dongqi
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2021
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7830785/
https://www.ncbi.nlm.nih.gov/pubmed/33466941
http://dx.doi.org/10.3390/ma14020393
Descripción
Sumario:Laser polishing is a widely used technology to improve the surface quality of the products. However, the investigation on the physical mechanism is still lacking. In this paper, the established numerical transient model reveals the rough surface evolution mechanism during laser polishing. Mass transfer driven by Marangoni force, surface tension and gravity appears in the laser-induced molten pool so that the polished surface topography tends to be smoother. The AlSi10Mg samples fabricated by laser-based powder bed fusion were polished at different laser hatching spaces, passes and directions to gain insight into the variation of the surface morphologies, roughness and microhardness in this paper. The experimental results show that after laser polishing, the surface roughness of Ra and Sa of the upper surface can be reduced from 12.5 μm to 3.7 μm and from to 29.3 μm to 8.4 μm, respectively, due to sufficient wetting in the molten pool. The microhardness of the upper surface can be elevated from 112.3 HV to 176.9 HV under the combined influence of the grain refinement, elements distribution change and surface defects elimination. Better surface quality can be gained by decreasing the hatching space, increasing polishing pass or choosing apposite laser direction.