Cargando…

Development and first biomechanical validation of a score to predict bone implant interface stability based on clinical qCT scans

Sufficient implant anchoring in osteoporotic bone is one major challenge in trauma and orthopedic surgery. In these cases, preoperative planning of osteosynthesis is becoming increasingly important. This study presents the development and first biomechanical validation of a bone-implant-anchorage sc...

Descripción completa

Detalles Bibliográficos
Autores principales:	Wähnert, Dirk, Frank, Andre, Ueberberg, Johanna, Heilmann, Lukas F., Sauzet, Odile, Raschke, Michael J., Gehweiler, Dominic
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Nature Publishing Group UK 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7870929/ https://www.ncbi.nlm.nih.gov/pubmed/33558603 http://dx.doi.org/10.1038/s41598-021-82788-y

Ejemplares similares

A modified and enhanced test setup for biomechanical investigations of the hindfoot, for example in tibiotalocalcaneal arthrodesis
por: Evers, Julia, et al.
Publicado: (2016)

Removal of cement-augmented screws in distal femoral fractures and the effect of retained screws and cement on total knee arthroplasty: a biomechanical investigation
por: Wähnert, Dirk, et al.
Publicado: (2021)

Local bone quality measure and construct failure prediction: a biomechanical study on distal femur fractures
por: Gehweiler, Dominic, et al.
Publicado: (2021)

Material properties of human vertebral trabecular bone under compression can be predicted based on quantitative computed tomography
por: Gehweiler, Dominic, et al.
Publicado: (2021)

3D geometry of femoral reaming for bone graft harvesting
por: Gehweiler, Dominic, et al.
Publicado: (2021)

Validation of HR-pQCT against micro-CT for morphometric and biomechanical analyses: A review
por: Ohs, Nicholas, et al.
Publicado: (2020)

Local heat generation during screw insertion into diaphyseal bone: a biomechanical study on different conditions (e.g. screw type, material, mode of insertion)
por: Paul, Berit, et al.
Publicado: (2021)

Biomechanical evaluation of combined short segment fixation and augmentation of incomplete osteoporotic burst fractures
por: Hartensuer, René, et al.
Publicado: (2013)

Complex biomechanical properties of non-augmented and augmented pedicle screws in human vertebrae with reduced bone density
por: Schulze, Martin, et al.
Publicado: (2020)

Periprosthetic fracture fixation in Vancouver B1 femoral shaft fractures: A biomechanical study comparing two plate systems
por: Wähnert, Dirk, et al.
Publicado: (2020)

Implant Augmentation: Adding Bone Cement to Improve the Treatment of Osteoporotic Distal Femur Fractures: A Biomechanical Study Using Human Cadaver Bones
por: Wähnert, Dirk, et al.
Publicado: (2014)

The Glenolabral Articular Disruption Lesion Is a Biomechanical Risk Factor for Recurrent Shoulder Instability
por: Wermers, Jens, et al.
Publicado: (2021)

Münsteraner Fahrradunfälle im Wandel der Zeit: Analyse der Entwicklung der Fahrradunfälle in den letzten 10 Jahren
por: Schlautmann, Désirée, et al.
Publicado: (2023)

The impact of motion induced artifacts in the evaluation of HR-pQCT scans of the scaphoid bone: an assessment of inter- and intraobserver variability and quantitative parameters
por: Benedikt, Stefan, et al.
Publicado: (2022)

Influence of demographic factors on the occurrence of motion artefacts in HR-pQCT
por: Benedikt, Stefan, et al.
Publicado: (2023)

Biomechanical Value of a Protective Proximal Humeral Cerclage in Reverse Total Shoulder Arthroplasty
por: Michel, Philipp A., et al.
Publicado: (2021)

Interlaboratory comparison of femur surface reconstruction from CT data compared to reference optical 3D scan
por: Soodmand, Ehsan, et al.
Publicado: (2018)

Biomechanical Analysis of Coracoid Stability After Coracoplasty: How Low Can You Go?
por: Heilmann, Lukas F., et al.
Publicado: (2022)

Diet Quality and Bone Measurements Using HRpQCT and pQCT in Older Community-Dwelling Adults from the Hertfordshire Cohort Study
por: Shaw, S. C., et al.
Publicado: (2018)

Impact of posttraumatic steps on the intra-articular pressure of the lateral tibial plateau after fracture reconstruction: A biomechanical human cadaver study
por: Oeckenpöhl, Simon, et al.
Publicado: (2017)

A Digital Model to Simulate Effects of Bone Architecture Variations on Texture at Spatial Resolutions of CT, HR-pQCT, and μCT Scanners
por: Lowitz, T., et al.
Publicado: (2014)

Cortical parameters predict bone strength at the tibial diaphysis, but are underestimated by HR‐pQCT and μCT compared to histomorphometry
por: Schmidutz, Florian, et al.
Publicado: (2020)

An unusual cause of ankle pain: fracture of a talocalcaneal coalition as a differential diagnosis in an acute ankle sprain: a case report and literature review
por: Wähnert, Dirk, et al.
Publicado: (2013)

Global and Spatial Compartmental Interrelationships of Bone Density, Microstructure, Geometry and Biomechanics in the Distal Radius in a Colles’ Fracture Study Using HR-pQCT
por: Shiraishi, Kazuteru, et al.
Publicado: (2021)

Comparison of QCT and DXA: Osteoporosis Detection Rates in Postmenopausal Women
por: Li, Na, et al.
Publicado: (2013)

MDCT-QCT, QUS, and DXA in healthy adults: An intermodality comparison
por: Malekzadeh, Malakeh, et al.
Publicado: (2019)

Biomechanical investigation of an alternative concept to angular stable plating using conventional fixation hardware
por: Windolf, Markus, et al.
Publicado: (2010)

Long-term stability of angle-stable versus conventional locked intramedullary nails in distal tibia fractures
por: Wähnert, Dirk, et al.
Publicado: (2013)

Differentiation of Traumatic Osteoporotic and Non-Osteoporotic Vertebral AO A3 Fractures by Analyzing the Posterior Edge Morphology—A Retrospective Feasibility Study
por: Vordemvenne, Thomas, et al.
Publicado: (2020)

Cerclage performance analysis – a biomechanical comparison of different techniques and materials
por: Hägerich, L. M., et al.
Publicado: (2022)

Material Mapping of QCT-Derived Scapular Models: A Comparison with Micro-CT Loaded Specimens Using Digital Volume Correlation
por: Knowles, Nikolas K., et al.
Publicado: (2019)

Bone Mechanoregulation Allows Subject-Specific Load Estimation Based on Time-Lapsed Micro-CT and HR-pQCT in Vivo
por: Walle, Matthias, et al.
Publicado: (2021)

Leave it or fix it? How fixation of a small posterior malleolar fragment neutralizes rotational forces in trimalleolar fractures
por: Evers, Julia, et al.
Publicado: (2021)

Radiomics score predicts acute respiratory distress syndrome based on the initial CT scan after trauma
por: Röhrich, Sebastian, et al.
Publicado: (2021)

An in vivo comparison of hip structure analysis (HSA) with measurements obtained by QCT
por: Ramamurthi, K., et al.
Publicado: (2011)

Assessment of trabecular bone structure using MDCT: comparison of 64- and 320-slice CT using HR-pQCT as the reference standard
por: Issever, Ahi S., et al.
Publicado: (2009)

Effect of Bone Morphogenetic Protein-2 in the Treatment of Long Bone Non-Unions
por: Fuchs, Thomas, et al.
Publicado: (2021)

Correction to: Radiomics score predicts acute respiratory distress syndrome based on the initial CT scan after trauma
por: Röhrich, Sebastian, et al.
Publicado: (2021)

Bias in cohort-based comparisons of immigrants’ health outcomes between countries: a simulation study
por: Sauzet, Odile, et al.
Publicado: (2019)

Generalised weibull model-based approaches to detect non-constant hazard to signal adverse drug reactions in longitudinal data
por: Sauzet, Odile, et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_1csht2cpie6s9au684srgu5b8r