Latissimus dorsi tendon transfer in reverse shoulder arthroplasty: transfer location affects strength

BACKGROUND: The optimal insertion location of a latissimus dorsi tendon transfer to restore external rotation after reverse shoulder arthroplasty (RSA) is not well established. The aim of this biomechanical study was to determine the effect of tendon transfer location on external rotation torque, in conjunction with varying RSA humeral component lateralization. We hypothesized that proximal tendon transfers, along with increasing humeral lateralization, would maximize external rotation torque. METHODS: Eight fresh-frozen cadaveric shoulders underwent RSA and were tested on an in vitro shoulder simulator. A latissimus dorsi tendon transfer was tested at three insertion locations (lateral greater tuberosity [Lat-GT]; teres minor footprint [Tm-FP]; lateral shaft [Lat-Shft]), and external rotation torque was measured. Additional test conditions included varying humeral component lateralization (-5, 0, +5, +10, +15 mm), abduction angle (0°, 45°, 90°), and internal/external rotation (-60°, -30°, 0°, 30°, 60°). RESULTS: The Lat-GT and Tm-FP insertions of the latissimus dorsi transfer both generated significantly greater torques (P < .001) than the Lat-Shft. When comparing Lat-GT to Tm-FP, there were no significant differences (P = .362). At 60˚ of external rotation, RSA humeral component lateralization from -5 to +15 mm significantly increased the external rotation torque of Lat-GT by 67% (P = .035), Tm-FP by 43% (P = .001), and of Lat-Shft by 42% (P = .002). CONCLUSION: Latissimus dorsi tendon transfer to the proximal lateral aspect of the greater tuberosity and to the insertion site of the teres minor generated significantly more external rotation torque than transfer to the lateral humeral shaft. In addition, the use of a humeral component with greater offset also substantially increases the torque generated by the tendon transfer.