Cargando…
Thermo-Mechanical Modeling of Wire-Fed Electron Beam Additive Manufacturing
The primary objective of this research was to develop a finite element model specifically designed for electron beam additive manufacturing (EBAM) of Ti-6Al-4V to understand metallurgical and mechanical aspects of the process. Multiple single-layer and 10-layer build Ti-6Al-4V samples were fabricate...
Autores principales: | Sikan, Fatih, Wanjara, Priti, Gholipour, Javad, Kumar, Amit, Brochu, Mathieu |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2021
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7919022/ https://www.ncbi.nlm.nih.gov/pubmed/33671941 http://dx.doi.org/10.3390/ma14040911 |
Ejemplares similares
-
In Envelope Additive/Subtractive Manufacturing and Thermal Post-Processing of Inconel 718
por: Atabay, Sila Ece, et al.
Publicado: (2022) -
Effect of Heat Treatment on the Microstructure and Mechanical Properties of 18Ni-300 Maraging Steel Produced by Additive–Subtractive Hybrid Manufacturing
por: Osman, Mahmoud, et al.
Publicado: (2023) -
Linear Friction Welding of an AZ91 Magnesium Alloy and the Effect of Ca Additions on the Weld Characteristics
por: Villegas-Armenta, Luis Angel, et al.
Publicado: (2021) -
Thermo-mechanical modeling of additive manufacturing
por: Gouge, Michael, et al.
Publicado: (2017) -
Joining of Dissimilar Alloys Ti-6Al-4V and Ti-6Al-2Sn-4Zr-2Mo-0.1Si Using Linear Friction Welding
por: Rajan, Sidharth, et al.
Publicado: (2020)