Cargando…

Improvement of Corrosion Resistance of TiO(2) Layers in Strong Acidic Solutions by Anodizing and Thermal Oxidation Treatment

By anodization and thermal oxidation at 600 °C, an oxide layer on Ti with excellent corrosion resistance in strong acid solutions was prepared. The structural properties of TiO(2) films before and after thermal oxidation were investigated with methods of Scanning electron microscope (SEM), X-ray pho...

Descripción completa

Detalles Bibliográficos
Autores principales:	Minhas, Badar, Dino, Sahib, Zuo, Yu, Qian, Hongchang, Zhao, Xuhui
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7959320/ https://www.ncbi.nlm.nih.gov/pubmed/33802436 http://dx.doi.org/10.3390/ma14051188

Ejemplares similares

Laser-induced crystallization of anodic TiO(2) nanotube layers
por: Sopha, Hanna, et al.
Publicado: (2020)

Photoelectrochemical Properties of Annealed Anodic TiO(2) Layers Covered with CuO(x)
por: Syrek, Karolina, et al.
Publicado: (2022)

Atomic Layer Deposition Al(2)O(3) Coatings Significantly Improve Thermal, Chemical, and Mechanical Stability of Anodic TiO(2) Nanotube Layers
por: Zazpe, Raul, et al.
Publicado: (2017)

Fabrication of ideally ordered TiO(2) through-hole membranes by two-layer anodization
por: Yanagishita, Takashi, et al.
Publicado: (2020)

Gradient Control of the Adhesive Force between Ti/TiO(2) Nanotubular Arrays Fabricated by Anodization
por: Zhao, Minghui, et al.
Publicado: (2014)

The effect of dye-sensitized solar cell based on the composite layer by anodic TiO(2) nanotubes
por: Yang, Jun Hyuk, et al.
Publicado: (2014)

ALD Al(2)O(3)-Coated TiO(2) Nanotube Layers as Anodes for Lithium-Ion Batteries
por: Sopha, Hanna, et al.
Publicado: (2017)

Photoelectrocatalytic Degradation of Paraquat by Pt Loaded TiO(2) Nanotubes on Ti Anodes
por: Özcan, Levent, et al.
Publicado: (2018)

Morphology and Microstructure of As-Synthesized Anodic TiO(2) Nanotube Arrays
por: Cao, Chunbin, et al.
Publicado: (2010)

Impact of the anodization time on the photocatalytic activity of TiO(2) nanotubes
por: Díaz-Real, Jesús A, et al.
Publicado: (2018)

Synthesis and Spectroelectrochemical Investigation of Anodic Black TiO(x) Nanotubes
por: Kotarba, Sebastian, et al.
Publicado: (2023)

Substrate Grain-Dependent Chemistry of Carburized Planar Anodic TiO(2) on Polycrystalline Ti
por: Rüdiger, Celine, et al.
Publicado: (2018)

Substrate Grain-Dependent Chemistry of Carburized Planar Anodic TiO(2) on Polycrystalline Ti
por: Rüdiger, Celine, et al.
Publicado: (2017)

Atomic layer deposition of ZnO/TiO(2) nanolaminates as ultra-long life anode material for lithium-ion batteries
por: Cao, Yan-Qiang, et al.
Publicado: (2019)

Structural analysis and corrosion studies on an ISO 5832-9 biomedical alloy with TiO(2) sol–gel layers
por: Burnat, B., et al.
Publicado: (2013)

Synthesis of TiO(2) Nanobelt Bundles Decorated with TiO(2) Nanoparticles and Aggregates and Their Use as Anode Materials for Lithium-Ion Batteries
por: Luo, Wenpo, et al.
Publicado: (2023)

A Photoelectrochemical Sensor Based on Anodic TiO(2) for Glucose Determination
por: Syrek, Karolina, et al.
Publicado: (2019)

Anodic TiO(2) Nanotubes: Tailoring Osteoinduction via Drug Delivery
por: Park, Jung, et al.
Publicado: (2021)

Solution-processable and photopolymerisable TiO(2) nanorods as dielectric layers for thin film transistors
por: Cheng, Fei, et al.
Publicado: (2020)

Investigation of Ti/Al(2)O(3) + TiO(2) and Ti + TiO(2)/Al(2)O(3) + TiO(2) hybrid coatings as protection of ultra-light Mg–(Li)–Al–RE alloys against corrosion
por: Staszuk, Marcin, et al.
Publicado: (2022)

Preparation of TiO(2) Superhydrophobic Composite Coating and Studies on Corrosion Resistance
por: Zhou, Chaogang, et al.
Publicado: (2022)

Surface protection against corrosion of Ni turbine blades by electrophoretic deposition of MnO(2), TiO(2) and TiO(2)–C nanocoating
por: Yousif, Qahtan. A., et al.
Publicado: (2022)

Anodic TiO(2) Nanotube Layers for Wastewater and Air Treatments: Assessment of Performance Using Sulfamethoxazole Degradation and N(2)O Reduction
por: Sihor, Marcel, et al.
Publicado: (2022)

Diversity of TiO(2): Controlling the Molecular and Electronic Structure of Atomic-Layer-Deposited Black TiO(2)
por: Ali-Löytty, Harri, et al.
Publicado: (2019)

Comparison of the Corrosion Behavior of Brass in TiO(2) and Al(2)O(3) Nanofluids
por: Xie, Siyu, et al.
Publicado: (2020)

On Growth and Morphology of TiO(2) Nanotubes on CP-Ti by Anodic Oxidation in Ethylene Glycol Electrolyte: Influence of Electrolyte Aging and Anodization Parameters
por: Ribeiro, Bruno, et al.
Publicado: (2022)

CNT@TiO(2) nanohybrids for high-performance anode of lithium-ion batteries
por: Wen, Zhenhai, et al.
Publicado: (2013)

The effect of polyaniline on TiO(2) nanoparticles as anode materials for lithium ion batteries
por: Zheng, Haitao, et al.
Publicado: (2016)

Extraordinary Performance of Carbon‐Coated Anatase TiO(2) as Sodium‐Ion Anode
por: Tahir, Muhammad Nawaz, et al.
Publicado: (2015)

Influence of Anodization-Electrolyte Aging on the Photocatalytic Activity of TiO(2) Nanotube Arrays
por: Suhadolnik, Luka, et al.
Publicado: (2020)

Hierarchical TiO(2) Layers Prepared by Plasma Jets
por: Zouzelka, Radek, et al.
Publicado: (2021)

Resistance of Superhydrophobic Surface-Functionalized TiO(2) Nanotubes to Corrosion and Intense Cavitation
por: Hua, Weidi, et al.
Publicado: (2018)

Impact of atomic layer deposited TiO(2) on the photocatalytic efficiency of TiO(2)/w-VA-CNT nanocomposite materials
por: Oliveira, Inês E., et al.
Publicado: (2022)

Self-ordered TiO(2 )quantum dot array prepared via anodic oxidation
por: Drbohlavova, Jana, et al.
Publicado: (2012)

Transparent TiO(2) nanotube array photoelectrodes prepared via two-step anodization
por: Kim, Jin Young, et al.
Publicado: (2014)

Improved Lithium Storage Performance of a TiO(2) Anode Material Doped by Co
por: Cai, Li, et al.
Publicado: (2023)

Strongly bound excitons in anatase TiO(2) single crystals and nanoparticles
por: Baldini, E., et al.
Publicado: (2017)

Tunable Photodetectors via In Situ Thermal Conversion of TiS(3) to TiO(2)
por: Ghasemi, Foad, et al.
Publicado: (2020)

On Growth and Morphology of TiO(2) Nanotubes on Ti6Al4V by Anodic Oxidation in Ethylene Glycol Electrolyte: Influence of Microstructure and Anodization Parameters
por: Ribeiro, Bruno, et al.
Publicado: (2021)

Solution-Processed Hybrid Light-Emitting Devices Comprising TiO(2) Nanorods and WO(3) Layers as Carrier-Transporting Layers
por: Tsai, Tsung-Yan, et al.
Publicado: (2016)

Cannot write session to /tmp/vufind_sessions/sess_neem05ln8p21t4jur195alvdco