Nanofiltration Process for Enhanced Treatment of RO Brine Discharge

Brine discharge of reverse osmosis (RO) desalination plants represents a challenge for both inland and coastal desalination plants. Zero-liquid discharge (ZLD) can be accomplished by using additional stages of RO, which can recycle that brine water, but the key challenge is the high concentration of divalent salts. These divalent salts (especially calcium and magnesium salts) forms a scaling layer on the RO membrane surfaces and hence shorten the life-time of the membranes. In this study, the nanofiltration (NF) procedure was used to remove divalent ions from the brine discharge to minimize the load on additional stages of RO membranes. One of the most critical considerations influencing the selection of an effective NF is the water type, which is expected here by calculation of some hydrochemical parameters (major ions, hypothetical soluble salts (electrolyte), and saturation indices). NF experiments were undertaken on a lab-scale using a low-pressure hand-made system of 4–7 bar. Synthetic single salts solutions and two real brine water discharge (brackish (BWRO) and seawater (SWRO) desalination plants) were used as a feed solution for NF system. The chemical characteristics of the RO-feed, RO-brine, NF-permeate, and NF-reject in were investigated. Electrolyte concentrations and saturation indices were determined based on the concentration of the major ions and the NETPATH software package, respectively. Calculations reveal that the brine concentrate samples contained mostly MgSO(4) and MgCl(2) soluble salts. The results show that 79–89% of the total dissolved salts (TDS) and 96–98% of the total hardness (TH) were retained using the NF process. The salt rejection of the NF membrane follows the order of CaSO(4), Na(2)SO(4), MgSO(4), MgCl(2), and NaCl with a percent of 97.4, 97.3, 95.2, 93.4, and 79%, respectively.