Cargando…

The Effect of the β-Al(5)FeSi Phases on Microstructure, Mechanical and Fatigue Properties in A356.0 Cast Alloys with Higher Fe Content without Additional Alloying of Mn

Secondary-cast aluminum alloys have increasing industrial applications. Their biggest deficiency is their impurity content, especially Fe, which has low solubility in Al and almost all the content creates intermetallic phases. This work examines the effect of higher Fe content on the microstructure...

Descripción completa

Detalles Bibliográficos
Autores principales:	Kuchariková, Lenka, Medvecká, Denisa, Tillová, Eva, Belan, Juraj, Kritikos, Michaela, Chalupová, Mária, Uhríčik, Milan
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8069112/ https://www.ncbi.nlm.nih.gov/pubmed/33924571 http://dx.doi.org/10.3390/ma14081943

Ejemplares similares

The Hardness Evolution of Cast and the High-Cycle Fatigue Life Change of Wrought Ni-Base Superalloys after Additional Heat Treatment
por: Belan, Juraj, et al.
Publicado: (2021)

Structural and Magnetic Properties of Inverse-Heusler Mn(2)FeSi Alloy Powder Prepared by Ball Milling
por: Životský, Ondřej, et al.
Publicado: (2022)

FeMn and FeMnAg biodegradable alloys: An in vitro and in vivo investigation
por: Saliba, Luke, et al.
Publicado: (2023)

The Fe-FeSi phase diagram at Mercury’s core conditions
por: Edmund, E., et al.
Publicado: (2022)

Upgrade Recycling of Cast Iron Scrap Chips towards β-FeSi(2) Thermoelectric Materials
por: Laila, Assayidatul, et al.
Publicado: (2014)

Release of Si from Silicon, a Ferrosilicon (FeSi) Alloy and a Synthetic Silicate Mineral in Simulated Biological Media
por: Herting, Gunilla, et al.
Publicado: (2014)

In-Vitro Analysis of FeMn-Si Smart Biodegradable Alloy
por: Roman, Ana Maria, et al.
Publicado: (2022)

Magnetic moments induce strong phonon renormalization in FeSi
por: Krannich, S., et al.
Publicado: (2015)

Effect of Nanostructuring on the Thermoelectric Properties of β-FeSi(2)
por: Abbassi, Linda, et al.
Publicado: (2021)

Effects of C Addition on the Microstructures of As-Cast Cu–Fe–P Alloys
por: Chen, Wei, et al.
Publicado: (2019)

Enhancing Methane Removal Efficiency of ZrMnFe Alloy by Partial Replacement of Fe with Co
por: Chen, Shumei, et al.
Publicado: (2023)

FeSi(2): a two-dimensional ferromagnet containing planar hexacoordinate Fe atoms
por: Zhao, Ying, et al.
Publicado: (2021)

Modelling the Mechanical Attributes (Roughness, Strength, and Hardness) of Al-alloy A356 during Sand Casting
por: Ishfaq, Kashif, et al.
Publicado: (2020)

The Applicability of Die Cast A356 Alloy to Additive Friction Stir Deposition at Various Feeding Speeds
por: Alzahrani, Bandar, et al.
Publicado: (2021)

Effects of Temperature on the Evolution of Yield Surface and Stress Asymmetry in A356–T7 Cast Aluminium Alloy
por: Natesan, Elanghovan, et al.
Publicado: (2021)

Creep Behavior of A356 Aluminum Alloy Reinforced with Multi-Walled Carbon Nanotubes by Stir Casting
por: Shan, L., et al.
Publicado: (2022)

Thermo-Mechanical Fatigue Behavior and Resultant Microstructure Evolution in Al-Si 319 and 356 Cast Alloys
por: Liu, Kun, et al.
Publicado: (2023)

Corrosion Resistance of AISI 316L Stainless Steel Biomaterial after Plasma Immersion Ion Implantation of Nitrogen
por: Zatkalíková, Viera, et al.
Publicado: (2021)

Mn and Fe impurities in Si$_{1-x}$Ge$_{x}$ alloys
por: Weyer, G, et al.
Publicado: (2003)

Design for Fe-high Mn alloy with an improved combination of strength and ductility
por: Lee, Seung-Joon, et al.
Publicado: (2017)

Corrosion Behavior of Sensitized AISI 304 Stainless Steel in Acid Chloride Solution
por: Zatkalíková, Viera, et al.
Publicado: (2022)

Origin of Magnetism in γ-FeSi(2)/Si(111) Nanostructures
por: Geng, Liwei D., et al.
Publicado: (2021)

Effect of Initial Fe Content on Microstructure and Mechanical Properties of Recycled Al-7.0Si-Fe-Mn Alloys with Constant Mn/Fe Ratio
por: Song, Dongfu, et al.
Publicado: (2022)

A Study of the Localized Ceria Coating Deposition on Fe-Rich Intermetallics in an AlSiFe Cast Alloy
por: Sainis, Salil, et al.
Publicado: (2021)

Influence of Preparation Technology on Microstructural and Magnetic Properties of Fe(2)MnSi and Fe(2)MnAl Heusler Alloys
por: Jirásková, Yvonna, et al.
Publicado: (2019)

Effect of Mn and Fe on the Formation of Fe- and Mn-Rich Intermetallics in Al–5Mg–Mn Alloys Solidified Under Near-Rapid Cooling
por: Liu, Yulin, et al.
Publicado: (2016)

Preliminary Study of New Low-Temperature Hard Abrasion Resistant Fe-P and Fe-P-X (X = C or/and B) Casting Alloys
por: Zorc, Matija, et al.
Publicado: (2023)

The effect of alloying elements on the properties of pressed and non-pressed biodegradable Fe–Mn–Ag powder metallurgy alloys
por: Caligari Conti, Malcolm, et al.
Publicado: (2019)

Fabrication of MnCuNiFe–CuAlNiFeMn Gradient Alloy by Laser Engineering Net Shaping System
por: Yan, Kuo, et al.
Publicado: (2022)

Effect of Al Element on the Microstructure and Properties of Cu-Ni-Fe-Mn Alloys
por: Yang, Ran, et al.
Publicado: (2018)

Corrosion and Oxidation Behavior of a Fe-Al-Mn-C Duplex Alloy
por: Barella, Silvia, et al.
Publicado: (2019)

Ab Initio Study of Elastic and Mechanical Properties in FeCrMn Alloys
por: Razumovskiy, Vsevolod I., et al.
Publicado: (2019)

Phase Equilibrium and Microstructure Examinations of Eutectic Fe-C-Mn-B Alloys
por: Pashechko, Mykhaylo, et al.
Publicado: (2022)

Impact of Mn Alloying on Phase Stabilities, Magnetic Properties and Electronic Structures in Fe
por: Yang, Hao, et al.
Publicado: (2023)

Effect of Zr Microalloying on the Microstructures and Strengthening Mechanism of As-Cast Al-Fe-Zr Alloys
por: Ye, Jieyun, et al.
Publicado: (2020)

Electronic Structure of B20 (FeSi-Type) Transition-Metal Monosilicides
por: Pshenay-Severin, Dmitry A., et al.
Publicado: (2019)

Nanostructurization of Fe-Ni Alloy
por: Danilhenko, Vitaliy E.
Publicado: (2017)

Deformation and Fatigue Behaviour of A356-T7 Cast Aluminium Alloys Used in High Specific Power IC Engines
por: Natesan, Elanghovan, et al.
Publicado: (2019)

Nitrogen Interstitial Alloying of CoCrFeMnNi High Entropy Alloy through Reactive Powder Milling
por: Moravcik, Igor, et al.
Publicado: (2019)

Investigation of the Microstructure and Compressibility of Biodegradable Fe-Mn-Cu/W/Co Nanostructured Alloy Powders Synthesized by Mechanical Alloying
por: Ammar, Hany R., et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_ek4c3epbbso7knrhciv7jmukc0