Cargando…
Personalized three-dimensional printed polyether-ether-ketone prosthesis for reconstruction after subtotal removal of chronic clavicle osteomyelitis: A case report
RATIONALE: Three-dimensional (3D) printing has attracted wide attention for its potential and abilities in the assistance of surgical planning and the development of personalized prostheses. We herewith report a unique case of chronic clavicle osteomyelitis treated with a two-stage subtotal clavicle...
Autores principales: | , , , , , |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
Lippincott Williams & Wilkins
2021
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8083998/ https://www.ncbi.nlm.nih.gov/pubmed/33907152 http://dx.doi.org/10.1097/MD.0000000000025703 |
Sumario: | RATIONALE: Three-dimensional (3D) printing has attracted wide attention for its potential and abilities in the assistance of surgical planning and the development of personalized prostheses. We herewith report a unique case of chronic clavicle osteomyelitis treated with a two-stage subtotal clavicle reconstruction using a 3D printed polyether-ether-ketone (PEEK) prosthesis. PATIENT CONCERNS: A 23-year-old Chinese female presented to our clinic complaining about a progressive pain of her right clavicle for about 1 year. DIAGNOSES: Chronic clavicle osteomyelitis confirmed by percutaneous biopsy and lesion biopsy. INTERVENTIONS: This patient accepted a long-term conservative treatment, which did not gain satisfactory outcomes. Thus, a subtotal removal and two-stage reconstruction of the right clavicle with a 3D-printed polyether-ether-ketone prosthesis stabilized by screw fixation system was performed. OUTCOMES: At 2-year follow-up, complete pain relief and satisfactory functional recovery of her right shoulder were observed. LESSONS: Personalized 3D printed prosthesis is an effective and feasible method for reconstruction of complex bone defects. |
---|