Cargando…

The Effect of Temperature and Sputtered Particles on the Wettability of Al/Al(2)O(3)

Two kinds of Al(2)O(3) ceramic samples with and without Al film deposited were designed respectively. The influences of temperature and high kinetic energy sputtering particles on the wettability and interface strength of Al/Al(2)O(3) were studied by comparing the wetting behavior of molten aluminum...

Descripción completa

Detalles Bibliográficos
Autores principales:	Li, Yang, Shang, Hailong, Ma, Bingyang, Guo, Xuqiang, Li, Rongbin, Li, Geyang
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8122281/ https://www.ncbi.nlm.nih.gov/pubmed/33921965 http://dx.doi.org/10.3390/ma14092110

Ejemplares similares

Microstructure and Mechanical Properties of AlN/Al Joints Brazing by a Sputtering Al/Cu Bilayer Film Solder
por: Ran, Zhun, et al.
Publicado: (2022)

Wettability of Nanostructured Transition-Metal Oxide (Al(2)O(3), CeO(2), and AlCeO(3)) Powder Surfaces
por: Alheshibri, Muidh, et al.
Publicado: (2022)

Nanostructured Al-ZnO/CdSe/Cu(2)O ETA solar cells on Al-ZnO film/quartz glass templates
por: Wang, Xianghu, et al.
Publicado: (2011)

Microstructure control of the wettability and adhesion of Al alloy surfaces
por: Wang, Yonghua, et al.
Publicado: (2020)

Effect of Al(2)O(3) Buffer Layers on the Properties of Sputtered VO(2) Thin Films
por: Zhang, Dainan, et al.
Publicado: (2017)

Influence of the Al-Doped ZnO Sputter-Deposition Temperature on Cu(In,Ga)Se(2) Solar Cell Performance
por: Park, Hyeonwook, et al.
Publicado: (2022)

Influence of AlN(0001) Surface Reconstructions on the Wettability of an Al/AlN System: A First-Principle Study
por: Cao, Junhua, et al.
Publicado: (2018)

Diffusion Barrier Performance of AlCrTaTiZr/AlCrTaTiZr-N High-Entropy Alloy Films for Cu/Si Connect System
por: Jiang, Chunxia, et al.
Publicado: (2020)

Substrate Temperature Dependent Properties of Sputtered AlN:Er Thin Film for In-Situ Luminescence Sensing of Al/AlN Multilayer Coating Health
por: Fang, Liping, et al.
Publicado: (2018)

Wettability of Y(2)O(3): A Relative Analysis of Thermally Oxidized, Reactively Sputtered and Template Assisted Nanostructured Coatings
por: Barshilia, Harish C., et al.
Publicado: (2012)

Glancing Angle Deposition Effect on Structure and Light-Induced Wettability of RF-Sputtered TiO(2) Thin Films
por: Vrakatseli, Vasiliki E., et al.
Publicado: (2018)

Effect of ZrO(2) Nanomaterials on Wettability and Interfacial Characteristics of Al-19Cu-11Si-2Sn Filler Metal for Low Temperature Al to Cu Dissimilar Brazing
por: Jung, Do-Hyun, et al.
Publicado: (2018)

Mechanical Properties and Corrosion Resistance of NbTiAlSiZrN(x) High-Entropy Films Prepared by RF Magnetron Sputtering
por: Xing, Qiuwei, et al.
Publicado: (2019)

Influence of Impurities on the Front Velocity of Sputter Deposited Al/CuO Thermite Multilayers
por: Dulmaa, Altangerel, et al.
Publicado: (2021)

Investigation of AlGaN/GaN Heterostructures Grown on Sputtered AlN Templates with Different Nucleation Layers
por: Liu, Chuan-Yang, et al.
Publicado: (2019)

Ellipsometric Study on the Uniformity of Al:ZnO Thin Films Deposited Using DC Sputtering at Room Temperature over Large Areas
por: Guillén, Cecilia, et al.
Publicado: (2023)

Effects of NIR annealing on the characteristics of al-doped ZnO thin films prepared by RF sputtering
por: Jun, Min-Chul, et al.
Publicado: (2012)

Effect of Growth Temperature and Atmosphere Exposure Time on Impurity Incorporation in Sputtered Mg, Al, and Ca Thin Films
por: Aliramaji, Shamsa, et al.
Publicado: (2023)

The Effect of Nitridation on Sputtering AlN on Composited Patterned Sapphire Substrate
por: Zhang, Yi, et al.
Publicado: (2023)

Effect of annealing temperature on wettability of TiO(2) nanotube array films
por: Yang, Lei, et al.
Publicado: (2014)

Phase Formation and High-Temperature Stability of Very Thin Co-Sputtered Ti-Al and Multilayered Ti/Al Films on Thermally Oxidized Si Substrates
por: Seifert, Marietta, et al.
Publicado: (2020)

Coarsening Behavior of Particles in Fe-O-Al-Ca Melts
por: Wang, Linzhu, et al.
Publicado: (2019)

Sputtering by particle bombardment
por: Hauffe, E, et al.
Publicado: (1991)

Sputtering by particle bombardment
por: Behrisch, Rainer, et al.
Publicado: (2007)

Sputtering by particle bombardment
por: Betz, G, et al.
Publicado: (1983)

Sputtering by particle bombardment
por: Andersen, Hans Henrik, et al.
Publicado: (1981)

Room Temperature Radiolytic Synthesized Cu@CuAlO(2)-Al(2)O(3) Nanoparticles
por: Abedini, Alam, et al.
Publicado: (2012)

Influence of Anodizing Parameters on Tribological Properties and Wettability of Al(2)O(3) Layers Produced on the EN AW-5251 Aluminum Alloy
por: Niedźwiedź, Mateusz, et al.
Publicado: (2022)

Ni Porous Preforms Compacted with Al(2)O(3) Particles and Al Binding Agent
por: Opálek, Andrej, et al.
Publicado: (2023)

Growth of nanostructured Cu(3)Al alloy films by magnetron sputtering for non-enzymatic glucose-sensing applications
por: Yin, Yuqing, et al.
Publicado: (2023)

Wettability of Sn-3.0Ag-0.5Cu Solder Reinforced with TiO(2) and Al(2)O(3) Nanoparticles at Different Reflow Times
por: Mohamed Muzni, Nur Haslinda, et al.
Publicado: (2023)

Nucleation and Ostwald Growth of Particles in Fe-O-Al-Ca Melt
por: Wang, Linzhu, et al.
Publicado: (2018)

Location-Optoelectronic Property Correlation in ZnO:Al Thin Film by RF Magnetron Sputtering and Its Photovoltaic Application
por: Lai, Fang-I, et al.
Publicado: (2021)

Effects of Residual Stress Distribution on Interfacial Adhesion of Magnetron Sputtered AlN and AlN/Al Nanostructured Coatings on a (100) Silicon Substrate
por: Ali, Rashid, et al.
Publicado: (2018)

Muonium in Al$_{2}$O$_{3}$ powder at low temperature
por: Kiefl, R F, et al.
Publicado: (1982)

Equilibrium Phase Relations of a SiO(2)–Al(2)O(3)–FeO(x) System with 10 wt % CaO Addition for the Production of Continuous Basalt Fibers
por: Li, Yandong, et al.
Publicado: (2021)

Effects of Y(2)O(3) and LiAl(5)O(8) on the Microstructure and Optical Properties of Reactively Sintered AlON Based Transparent Ceramics
por: Yang, Guojian, et al.
Publicado: (2022)

Improvement of High-Temperature Stability of Al(2)O(3)/Pt/ZnO/Al(2)O(3) Film Electrode for SAW Devices by Using Al(2)O(3) Barrier Layer
por: Liu, Xingpeng, et al.
Publicado: (2017)

Effect of Al(2)TiO(5) Content and Sintering Temperature on the Microstructure and Residual Stress of Al(2)O(3)–Al(2)TiO(5) Ceramic Composites
por: Fan, Kunyang, et al.
Publicado: (2021)

Si-rich Al(2)O(3) films grown by RF magnetron sputtering: structural and photoluminescence properties versus annealing treatment
por: Korsunska, Nadiia, et al.
Publicado: (2013)

Cannot write session to /tmp/vufind_sessions/sess_29sucmvjhsrg3lfim2qb6bugts