Cargando…

Enhanced Mechanical Properties and Microstructure of Accumulative Roll-Bonded Co/Pb Nanocomposite

Lead composites have been used as anodes in the electrowinning process to produce metals such as copper and zinc. Manufacturing stable lead anodes with appropriate mechanical and chemical properties is required to improve the performance of the electrowinning process. In this study, an accumulative...

Descripción completa

Detalles Bibliográficos
Autores principales:	Karbasi, Maryam, Keshavarz Alamdari, Eskandar, Amirkhani Dehkordi, Elahe, Khan, Zulfiqar A., Tavangarian, Fariborz
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8147126/ https://www.ncbi.nlm.nih.gov/pubmed/33946419 http://dx.doi.org/10.3390/nano11051190

Ejemplares similares

Microstructure and Mechanical Properties of Ultrafine-Grained Copper by Accumulative Roll Bonding and Subsequent Annealing
por: Liu, Xueran, et al.
Publicado: (2020)

Evolution of Microstructure, Texture and Mechanical Properties for Multilayered Al Matrix Composites by Accumulative Roll Bonding
por: Wang, Wen-Jing, et al.
Publicado: (2021)

Microstructure and Mechanical Properties of Al-Mg-Si Similar Alloy Laminates Produced by Accumulative Roll Bonding
por: Li, Zhigang, et al.
Publicado: (2021)

Microstructural Characterization of Al/CNTs Nanocomposites after Cold Rolling
por: Carneiro, Íris, et al.
Publicado: (2023)

Further Investigations and Parametric Analysis of Microstructural Alterations under Rolling Contact Fatigue
por: Abdullah, Muhammad Usman, et al.
Publicado: (2022)

Fabrication of ultra-thin nanostructured bimetallic foils by Accumulative Roll Bonding and Asymmetric Rolling
por: Yu, Hailiang, et al.
Publicado: (2013)

Anisotropic Behavior of Al1050 through Accumulative Roll Bonding
por: Sattarpanah Karganroudi, Sasan, et al.
Publicado: (2021)

Annealing Effects in Twin-Roll Cast AA8006 Aluminium Sheets Processed by Accumulative Roll-Bonding
por: Cieslar, Miroslav, et al.
Publicado: (2014)

Fabrication of Al/Mg/Al Composites via Accumulative Roll Bonding and Their Mechanical Properties
por: Nie, Jinfeng, et al.
Publicado: (2016)

Microstructure Evolution and Mechanical Properties of Al-TiB(2)/TiC In Situ Aluminum-Based Composites during Accumulative Roll Bonding (ARB) Process
por: Nie, Jinfeng, et al.
Publicado: (2017)

Microstructure, mechanical properties, and electrical conductivity of Mg–8Li–2Y–Zn/Al multilayered composites fabricated by cross asynchronous accumulative roll bonding
por: Hu, Hao, et al.
Publicado: (2022)

Effect of Asymmetric Accumulative Roll-Bonding process on the Microstructure and Strength Evolution of the AA1050/AZ31/AA1050 Multilayered Composite Materials
por: Mroz, Sebastian, et al.
Publicado: (2020)

Influence of Accumulative Roll Bonding on the Texture and Tensile Properties of an AZ31 Magnesium Alloy Sheets
por: Trojanová, Zuzanka, et al.
Publicado: (2018)

Interfacial Bonding and Fracture Behaviors of AZ63 Magnesium Alloy Sheet Processed by Accumulative Roll Bonding
por: Guo, Junqing, et al.
Publicado: (2023)

Effect of Processing Route on Microstructure and Mechanical Properties in Single-Roll Angular-Rolling
por: Lee, Hak Hyeon, et al.
Publicado: (2020)

Fabrication, Mechanical Properties and In-Vitro Behavior of Akermanite Bioceramic
por: Tavangarian, Fariborz, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of Hot- Rolled and Cold-Rolled Medium-Mn TRIP Steels
por: Liu, Chunquan, et al.
Publicado: (2018)

Abnormal texture evolution of accumulative roll bonded Al–Cu by adding alumina particles
por: Yousefi Mehr, Vahid, et al.
Publicado: (2022)

Evaluation of Mechanical Properties and Cell Viability of Poly (3-Hydroxybutyrate)-Chitosan/Al(2)O(3) Nanocomposite Scaffold for Cartilage Tissue Engineering
por: Toloue, Elahe Bahremandi, et al.
Publicado: (2019)

Development of interface-dominant bulk Cu/V nanolamellar composites by cross accumulative roll bonding
por: Zeng, L. F., et al.
Publicado: (2017)

Cyclic Deformation of Ultra-Fine Grained Commercial Purity Aluminum Processed by Accumulative Roll-Bonding
por: Kwan, Charles C.F., et al.
Publicado: (2013)

Fabrication of Flexible Polymer Molds for Polymer Microstructuring by Roll-to-Roll Hot Embossing
por: Kodihalli Shivaprakash, Nischay, et al.
Publicado: (2019)

Fabrication and Characterization of Polyvinylpyrrolidone-Eggshell Membrane-Reduced Graphene Oxide Nanofibers for Tissue Engineering Applications
por: Ghorbanzadeh Sheish, Shahnaz, et al.
Publicado: (2021)

Effect of Rolling Route on Microstructure and Tensile Properties of Twin-Roll Casting AZ31 Mg Alloy Sheets
por: Luo, Dan, et al.
Publicado: (2016)

Assembly of PbTe/Pb-based nanocomposite and photoelectric property
por: Zong, Zhaocun, et al.
Publicado: (2013)

Effects of Deep Cryogenic Treatment on the Microstructure and Properties of Rolled Cu Foil
por: Dong, Zhichao, et al.
Publicado: (2021)

Influence of Asymmetric Rolling Process on the Microstructure Properties of Bimetallic Sheet Metals
por: Stradomski, Grzegorz, et al.
Publicado: (2022)

Effect of Rolling Temperature on Microstructure and Properties of Al-Mg-Li Alloy
por: Li, Weiwei, et al.
Publicado: (2022)

Microstructure and Properties of Polypropylene/Carbon Nanotube Nanocomposites
por: Bikiaris, Dimitrios
Publicado: (2010)

Effect of Carbon Content on Microstructure, Properties and Texture of Ultra-Thin Hot Rolled Strip Produced by Endless Roll Technology
por: Tian, Peng, et al.
Publicado: (2021)

Effect of Rolling Treatment on Microstructure, Mechanical Properties, and Corrosion Properties of WE43 Alloy
por: Deng, Bo, et al.
Publicado: (2022)

Softened Microstructure and Properties of 12 μm Thick Rolled Copper Foil
por: Feng, Rui, et al.
Publicado: (2022)

Influences of Cold Rolling and Aging on Microstructure and Property of CuCrSn Alloy
por: Chen, Tao, et al.
Publicado: (2023)

Effects on the Microstructure Evolution and Properties of Graphene/Copper Composite during Rolling Process
por: Yang, Ziyue, et al.
Publicado: (2023)

Effects of Calcium Hypochlorite and Sodium Hypochlorite, as Root Canal Irrigants, on the Bond Strength of Glass Fiber Posts Cemented with Self-Adhesive Resin Cement
por: Khoroushi, Maryam, et al.
Publicado: (2019)

A Multiscale Overview of Modelling Rolling Cyclic Fatigue in Bearing Elements
por: Abdullah, Muhammad U., et al.
Publicado: (2022)

Effect of Cold Rolling and Annealing on the Microstructure and Texture of Erbium Metal
por: Chen, Shiying, et al.
Publicado: (2022)

Crystallographic Anisotropy Dependence of Interfacial Sliding Phenomenon in a Cu(16)/Nb(16) ARB (Accumulated Rolling Bonding) Nanolaminate
por: Sahay, Rahul, et al.
Publicado: (2022)

Microstructure and Mechanical Properties of a Cold-Rolled Ultrafine-Grained Dual-Phase Steel
por: Pan, Zhiyi, et al.
Publicado: (2018)

The Effect of ECAP Temperature on the Microstructure and Properties of a Rolled Rare Earth Magnesium Alloy
por: Tan, Yun, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_7c4b1f203bo7amkao2nq4d4kdt