Cargando…

Thermal Behavior of Ti-64 Primary Material in Electron Beam Melting Process

The Electron Beam Melting (EBM) process has emerged as either an alternative or a complement to vacuum arc remelting of titanium alloys, since it is capable of enhancing the removal of exogenous inclusions by dissolution or sedimentation. The melting of the primary material is a first step of this c...

Descripción completa

Detalles Bibliográficos
Autores principales: Bellot, Jean-Pierre, Jourdan, Julien, Kroll-Rabotin, Jean-Sébastien, Quatravaux, Thibault, Jardy, Alain
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2021
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8199115/
https://www.ncbi.nlm.nih.gov/pubmed/34073561
http://dx.doi.org/10.3390/ma14112853
Descripción
Sumario:The Electron Beam Melting (EBM) process has emerged as either an alternative or a complement to vacuum arc remelting of titanium alloys, since it is capable of enhancing the removal of exogenous inclusions by dissolution or sedimentation. The melting of the primary material is a first step of this continuous process, which has not been studied so far and is investigated experimentally and numerically in the present study. Experiments have been set up in a 100 kW laboratory furnace with the aim of analyzing the effect of melting rate on surface temperature of Ti-64 bars. It was found that melting rate is nearly proportional to the EB power while the overheating temperature remains roughly independent of the melting rate and equal to about 100 °C. The emissivity of molten Ti-64 was found to be 0.22 at an average temperature of about 1760 °C at the tip of the bar. In parallel, a mathematical model of the thermal behavior of the material during melting has been developed. The simulations revealed valuable results about the melting rate, global heat balance and thermal gradient throughout the bar, which agreed with the experimental values to a good extent. The modeling confirms that the overheating temperature of the tip of the material is nearly independent of the melting rate.