Surgical Outcomes of a New Technique Using a Convex Rod Rotation Maneuver for Adolescent Idiopathic Scoliosis

INTRODUCTION: Because of adolescent idiopathic scoliosis (AIS), most surgeons use rod rotation on the concave side for Lenke types 1 and 2 curves. Nevertheless, the accurate placement of pedicle screws within dysplastic pedicles, especially on the concave side, is sometimes challenging. Conversely, there is a concern that apical rotation might be exacerbated after convex rod rotation maneuver (RRM) because the rod is rotated in the same direction as vertebral rotation. This study aims to demonstrate the surgical technique and outcomes of a convex RRM with direct vertebral rotation (DVR) for the correction of AIS. TECHNICAL NOTE: Multilevel pedicle screws were inserted into the vertebrae. The pre-bent pure titanium rod was set on the convex side and then derotated to nearly 90°. DVR was conducted for the desired vertebrae. Another pre-bent titanium alloy rod, for placement on the concave side, was contoured the same as the rod on the convex side. Using a reduction tube that allowed easier capture of the rod, the rod was connected to the concave side screws. DVR was again conducted for the desired vertebrae. Among the 59 patients, the correction rate of the main thoracic curve in Lenke types 1 and 2 AIS was 75.1% and 65.0%, respectively. The absolute value of the change in apical vertebral rotation between pre- and post-operative computed tomography (CT) scans in Lenke types 1 and 2 curves was 4.8° and 4.2°, respectively. CONCLUSIONS: The convex RRM improved vertebral rotation in Lenke types 1 and 2 AIS. This procedure should be regarded as one of the surgical options for AIS, especially in patients with a narrow pedicle width on the concave side.