Cargando…

Intergranular Corrosion and Microstructural Evolution in a Newly Designed Al-6Mg Alloy

In this work, the microstructure and corrosion behavior of a novel Al-6Mg alloy were investigated. The alloy was prepared by casting from pure Al and Mg+Al(2)Ca master alloy. The ingots were homogenized at 420 °C for 8 h, hot-extruded and cold-rolled with 20% reduction (CR20 alloy) and 50% reduction...

Descripción completa

Detalles Bibliográficos
Autores principales:	Choi, Kweon-Hoon, Kim, Bong-Hwan, Lee, Da-Bin, Yang, Seung-Yoon, Kim, Nam-Seok, Ha, Seong-Ho, Yoon, Young-Ok, Lim, Hyun-Kyu, Kim, Shae-Kwang
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8232665/ https://www.ncbi.nlm.nih.gov/pubmed/34203845 http://dx.doi.org/10.3390/ma14123314

Ejemplares similares

Microstructure Evolution and Mechanical Properties of Al–Cu–Mg Alloys with Si Addition
por: Shah, Abdul Wahid, et al.
Publicado: (2023)

Investigating the Influence of Mg Content Variations on Microstructures, Heat-Treatment, and Mechanical Properties of Al-Cu-Mg Alloys
por: Shah, Abdul Wahid, et al.
Publicado: (2023)

Effect of Al(2)Ca Addition and Heat Treatment on the Microstructure Modification and Tensile Properties of Hypo-Eutectic Al–Mg–Si Alloys
por: Shah, Abdul Wahid, et al.
Publicado: (2021)

Influence of Minor Zn Addition on Precipitation Behavior and Intergranular Corrosion Properties of Al-Mg-Si Alloy
por: Chi, Shuiqing, et al.
Publicado: (2020)

Effect of Sc and Zr Additions on Recrystallization Behavior and Intergranular Corrosion Resistance of Al-Zn-Mg-Cu Alloys
por: Xia, Peng, et al.
Publicado: (2021)

Mitigating the susceptibility to intergranular corrosion of alloy 625 by friction-stir welding
por: Lemos, Guilherme Vieira Braga, et al.
Publicado: (2022)

Proton irradiation-decelerated intergranular corrosion of Ni-Cr alloys in molten salt
por: Zhou, Weiyue, et al.
Publicado: (2020)

The Influence of Stored Energy on Grain Boundary Chemistry and Intergranular Corrosion Development in AA2024-T3 Alloy
por: Zhang, Xinxin, et al.
Publicado: (2018)

On the Competition between Intergranular and Transgranular Failure within 7xxx Al Alloys with Tailored Microstructures
por: Han, Sutao, et al.
Publicado: (2023)

Microstructure and Salt Fog Corrosion of Wrought Mg-Al-Zn and Mg-RE Alloys
por: Kamoutsi, Helen, et al.
Publicado: (2023)

Effects of the Mg Content on Microstructural and Corrosion Characteristics of Hot-Dip Al–Si–Mg Alloy-Coated Steel Sheets
por: Jin, Kwang-Hyeok, et al.
Publicado: (2023)

Influence of Alloyed Ga on the Microstructure and Corrosion Properties of As-Cast Mg–5Sn Alloys
por: Ren, Jing, et al.
Publicado: (2019)

Effect of Zn/Mg Ratios on Microstructure and Stress Corrosion Cracking of 7005 Alloy
por: Wang, Shuai, et al.
Publicado: (2019)

Microstructure and Corrosion Resistance of LaNi(5-x)Mg(x) Alloys
por: Giza, Krystyna, et al.
Publicado: (2022)

Effect of the Zn/Mg Ratio on Microstructures, Mechanical Properties and Corrosion Performances of Al-Zn-Mg Alloys
por: Jiang, Keda, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of an Al–Mg–Si–Zr Alloy Processed by L-PBF and Subsequent Heat Treatments
por: Yang, Wonseok, et al.
Publicado: (2022)

Microstructure and Corrosion Behavior of Laser-Welded Al–Mn–Zr Alloy for Heat Exchanger
por: Lim, Jeong-Min, et al.
Publicado: (2023)

Crystallographic Evaluation of Susceptibility to Intergranular Corrosion in Austenitic Stainless Steel with Various Degrees of Sensitization
por: Fujii, Tomoyuki, et al.
Publicado: (2020)

Probing intergranular mixed transgranular stress corrosion cracking under the high constant load
por: Zhu, Longkui
Publicado: (2022)

Effects of Beryllium Addition on Microstructure, Mechanical and Corrosion Performance of Al-Mg-Li Alloys
por: Huang, Yang, et al.
Publicado: (2023)

Microstructure and Mechanical Properties of Intergranular Boride Precipitation-Toughened HfMoNbTaTiZr Refractory High-Entropy Alloy
por: Ko, Ping-Hsu, et al.
Publicado: (2022)

Biodegradability engineering of biodegradable Mg alloys: Tailoring the electrochemical properties and microstructure of constituent phases
por: Cha, Pil-Ryung, et al.
Publicado: (2013)

Effect of Homogenization on Microstructure Characteristics, Corrosion and Biocompatibility of Mg-Zn-Mn-xCa Alloys
por: Zhang, Yuan, et al.
Publicado: (2018)

Microstructural and Corrosion Properties of Hydroxyapatite Containing PEO Coating Produced on AZ31 Mg Alloy
por: Pezzato, Luca, et al.
Publicado: (2021)

Annealing of Al-Zn-Mg-Cu Alloy at High Pressures: Evolution of Microstructure and the Corrosion Behavior
por: Suo, Chuanjun, et al.
Publicado: (2021)

New Zn3Mg-xY Alloys: Characteristics, Microstructural Evolution and Corrosion Behavior
por: Panaghie, Catalin, et al.
Publicado: (2021)

Microstructure, Mechanical Properties and Corrosion Behaviors of Al–Li–Cu–Mg–Ag–Zn Alloys
por: Wu, Mingdong, et al.
Publicado: (2022)

Effect of Microstructure Refinement on the Corrosion Behavior of the Bioresorbable Mg-1Zn-0.2Ca and Mg-1Ca Alloys
por: Kulyasova, Olga B., et al.
Publicado: (2022)

Corrosion Behavior of an Mg(2)Sn Alloy
por: Gabalcová, Zuzana, et al.
Publicado: (2022)

Effect of Sn Addition on Microstructure and Corrosion Behavior of As-Extruded Mg–5Zn–4Al Alloy
por: Ding, Jian, et al.
Publicado: (2019)

Effects of Second Phases on Microstructure, Microhardness, and Corrosion Behavior of Mg-3Sn-(1Ca) Alloys
por: Wang, Chunming, et al.
Publicado: (2019)

Microstructure, Mechanical Properties, and in Vitro Corrosion Behavior of Biodegradable Zn-1Fe-xMg Alloy
por: Xue, Penghao, et al.
Publicado: (2020)

Effect of Er on Microstructure and Corrosion Behavior of Al–Zn–Mg–Cu–Sc–Zr Aluminum Alloys
por: Xing, Qingyuan, et al.
Publicado: (2022)

Microstructure and Corrosion Behavior of Sn–Zn Alloys
por: Gerhátová, Žaneta, et al.
Publicado: (2022)

The effects of Co on the enhancement of magnetic properties by modifying the intergranular phase in Nd-Fe-B alloys
por: Liang, Y., et al.
Publicado: (2019)

Microstructural Evolution and Mechanical Properties in Superlight Mg-Li Alloy Processed by High-Pressure Torsion
por: Su, Qian, et al.
Publicado: (2018)

Influence of Alloying Materials Al, Cu, and Ca on Microstructures, Mechanical Properties, And Corrosion Resistance of Mg Alloys for Industrial Applications: A Review
por: Murugesan, Rajadurai, et al.
Publicado: (2023)

Microstructure and Corrosion Resistance of PEO Coatings Formed on KBM10 Mg Alloy Pretreated with Nd(NO(3))(3)
por: Lu, Junpeng, et al.
Publicado: (2018)

Microstructural Assessment, Mechanical and Corrosion Properties of a Mg-Sr Alloy Processed by Combined Severe Plastic Deformation
por: Nafikov, Ruslan K., et al.
Publicado: (2023)

Microstructure and Corrosion Characterization of a MgO/Hydroxyapatite Bilayer Coating by Plasma Electrolytic Oxidation Coupled with Flame Spraying on a Mg Alloy
por: Mardali, Marzieh, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_16b29rjh7udn8ukkpftnp05h7o