Cargando…

Preparation and Characterization of Mg–Al–B Alloy (Mg(0.5)Al(0.5)B(2)) Via High-Temperature Sintering

Boron and its alloys have long been explored as potential fuel and increasingly replace pure aluminum powder in high-energy formulations. The ignition and burning properties of boron can be improved by making boron alloys. In this study, an Mg–Al–B alloy was synthesized from magnesium, aluminum and...

Descripción completa

Detalles Bibliográficos
Autores principales:	Yang, Lin, He, Jie, Ma, Yusong, Zhang, Liang, Ma, Shizhou, Gai, Xiqiang, Zhang, Xinggao
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8269652/ https://www.ncbi.nlm.nih.gov/pubmed/34203374 http://dx.doi.org/10.3390/ma14133608

Ejemplares similares

Ignition and Combustion Characteristic of B·Mg Alloy Powders
por: Ma, Yusong, et al.
Publicado: (2022)

Crystal chemistry and compressibility of Fe(0.5)Mg(0.5)Al(0.5)Si(0.5)O(3) and FeMg(0.5)Si(0.5)O(3) silicate perovskites at pressures up to 95 GPa
por: Koemets, Iuliia, et al.
Publicado: (2023)

Li(0.5)Al(0.5)Mg(2)(MoO(4))(3)
por: Ennajeh, Ines, et al.
Publicado: (2013)

Hot Deformation Behavior, Processing Maps and Microstructural Evolution of the Mg-2.5Nd-0.5Zn-0.5Zr Alloy
por: Ma, Junfei, et al.
Publicado: (2022)

Characterization and Properties of Mg-xGd-1.5Nd-0.5Zn-0.5Zr Alloys for Biodegradation Applications
por: Gui, Zhenzhen, et al.
Publicado: (2020)

Structural and Mechanical Changes of AlMgSi(0.5) Alloy during Extrusion by ECAP Method
por: Harničárová, Marta, et al.
Publicado: (2022)

Estimation of mechanical properties of Mg-5Zn-0.5Al-xSn alloy based on virtual crystal approximation
por: Zhang, Yu, et al.
Publicado: (2022)

Annealing-Dependent Morphotropic Phase Boundary in the BiMg(0.5)Ti(0.5)O(3)–BiZn(0.5)Ti(0.5)O(3) Perovskite System
por: Cardoso, João Pedro V., et al.
Publicado: (2022)

Study of the Influence of Zirconium, Titanium and Strontium on the Properties and Microstructure of AlSi7Mg0.3Cu0.5 Alloy
por: Bolibruchová, Dana, et al.
Publicado: (2022)

Investigation of Effect of Preliminary Annealing on Superplasticity of Ultrafine-Grained Conductor Aluminum Alloys Al-0.5%Mg-Sc
por: Gryaznov, Mikhail, et al.
Publicado: (2021)

Improving the Mechanical Properties of Mg-5Al-2Ca-1Mn-0.5Zn Alloy through Rotary Swaging
por: Li, Bin, et al.
Publicado: (2023)

Magnetic properties of the complex concentrated alloy system CoFeNi(0.5)Cr(0.5)Al(x)
por: Morley, N. A., et al.
Publicado: (2020)

Effect of Final Thermomechanical Treatment on the Mechanical Properties and Microstructure of T Phase Hardened Al-5.8Mg-4.5Zn-0.5Cu Alloy
por: Tao, Kai, et al.
Publicado: (2023)

Effect of Mg Contents on the Microstructure, Mechanical Properties and Cytocompatibility of Degradable Zn-0.5Mn-xMg Alloy
por: Yang, Lingbo, et al.
Publicado: (2023)

Effect of heat treatment on corrosion behavior of Mg–5Gd–3Y–0.5Zr alloy
por: Zhang, Qian, et al.
Publicado: (2020)

Crystal structure of MgK(0.5)[B(6)O(10)](OH)(0.5)·0.5H(2)O, poly[dimagnesium potassium bis(hexaborate) hydroxide monohydrate]
por: Qiu, Qi-Ming, et al.
Publicado: (2022)

Electrochemical Analysis and In Vitro Assay of Mg-0.5Ca-xY Biodegradable Alloys
por: Istrate, Bogdan, et al.
Publicado: (2020)

Exchange bias effect in polycrystalline Bi(0.5)Sr(0.5)Fe(0.5)Cr(0.5)O(3) bulk
por: Li, S. Z., et al.
Publicado: (2023)

Microwave Sintering and Microwave Dielectric Properties of (1–x)Ca(0.61)La(0.26)TiO(3)-xNd(Mg(0.5)Ti(0.5))O(3) Ceramics
por: Yang, Shuwei, et al.
Publicado: (2021)

Surface Modification of Biomedical MgCa(4.5) and MgCa(4.5)Gd(0.5) Alloys by Micro-Arc Oxidation
por: Sakiewicz, Piotr, et al.
Publicado: (2021)

Low-Temperature Sintering of Bi(Ni(0.5)Ti(0.5))O(3)-BiFeO(3)-Pb(Zr(0.5)Ti(0.5))O(3) Ceramics and Their Performance
por: Wang, Wuyang, et al.
Publicado: (2023)

Achieving High Yield Strength and Ductility in As-Extruded Mg-0.5Sr Alloy by High Mn–Alloying
por: Zhou, Shibo, et al.
Publicado: (2020)

Microstructural Design of Ba(0.5)La(0.5)Co(0.5)Fe(0.5)O(3) Perovskite Ceramics
por: Gierszewska, Daria, et al.
Publicado: (2021)

Enhancing Degradation Resistance of Biomedical Mg-6Zn-0.5Zr Alloy by the Incorporation of Nanodiamond
por: Liu, Long, et al.
Publicado: (2022)

Annealing Temperature Effects on Humidity Sensor Properties for Mg(0.5)W(0.5)Fe(2)O(4) Spinel Ferrite
por: Petrila, Iulian, et al.
Publicado: (2022)

Comparing the frequency of isotretinoin-induced hair loss at <0.5-mg/kg/d versus ≥0.5-mg/kg/d dosing in acne patients: A systematic review
por: Lytvyn, Yuliya, et al.
Publicado: (2022)

Structural Insight into La(0.5)Ca(0.5)Mn(0.5)Co(0.5)O(3) Decomposition in the Methane Combustion Process
por: Nikolaeva, Olga, et al.
Publicado: (2021)

A clinical comparison between 0.5% levobupivacaine and 0.5% levobupivacaine with dexamethasone 8 mg combination in brachial plexus block by the supraclavicular approach
por: Pani, Nibedita, et al.
Publicado: (2017)

Selective electron beam melting of Al0.5CrMoNbTa0.5 high entropy alloys using elemental powder blend
por: Popov, Vladimir V., et al.
Publicado: (2019)

Corrosion Resistance of Al(0.5)CoCrFeNiCu(x)Ag(y) (x = 0.25, 0.5; y = 0, 0.1) High-Entropy Alloys in 0.5M H(2)SO(4) Solution
por: Samoilova, Olga, et al.
Publicado: (2023)

Precipitation Behavior of Mg-7Gd-3Y-2Zn-0.5Zr Alloy during Isothermal Aging
por: Yuan, Jiawei, et al.
Publicado: (2021)

Effect of Rolling Parameters on Room-Temperature Stretch Formability of Mg–2Zn–0.5Ca Alloy
por: Li, Wei, et al.
Publicado: (2023)

Near-infrared emitting CdTe(0.5)Se(0.5)/Cd(0.5)Zn(0.5)S quantum dots: synthesis and bright luminescence
por: Yang, Ping, et al.
Publicado: (2012)

Effect of Microwave Sintering on the Properties of 0.95(Ca(0.88)Sr(0.12))TiO(3)–0.05(Bi(0.5)Na(0.5))TiO(3) Ceramics
por: Tian, Lei, et al.
Publicado: (2019)

Grain Growth Kinetics of 0.65Ca(0.61)La(0.26)TiO(3)-0.35Sm(Mg(0.5)Ti(0.5))O(3) Dielectric Ceramic
por: Liu, Jin, et al.
Publicado: (2020)

Free and bound excitonic effects in Al(0.5)Ga(0.5)N/Al(0.35)Ga(0.65)N MQWs with different Si-doping levels in the well layers
por: He, Chenguang, et al.
Publicado: (2015)

Al(0.5)Nb(1.5)(PO(4))(3)
por: Zhao, Dan, et al.
Publicado: (2011)

Anestesia espinal con bupivacaina al 0.5% combinada con nalbufina versus bupivacaina al 0.5% para cirugía ortopédica en ancianos
por: López Ceballos, Trinidad
Publicado: (2000)

Effect of Al-5Ti-0.25C-0.25B and Al-5Ti-1B Master Alloys on the Microstructure and Mechanical Properties of Al-9.5Si-1.5Cu-0.8Mn-0.6Mg Alloy
por: Wen, Yihan, et al.
Publicado: (2023)

New insights into defects and magnetic interactions inducing lattice disordering in Co(2)Fe(0.5)Cr(0.5)Al
por: Yadav, Ravi Kumar, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_162dpcln7r3ioot1pgelbjo3ap