Cargando…

Investigation of Ib-Values for Determining Fracture Modes in Fiber-Reinforced Composite Materials by Acoustic Emission

This study analyzed failure behavior using Ib-values obtained from acoustic emission (AE) signals. Carbon fiber/epoxy specimens were fabricated and tested under tensile loads, during which AE signals were collected. The dominant peak frequency exhibited a specific range according to fracture mode, d...

Descripción completa

Detalles Bibliográficos
Autores principales:	Jung, Doyun, Yu, Woong-Ryeol, Na, Wonjin
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8269700/ https://www.ncbi.nlm.nih.gov/pubmed/34209999 http://dx.doi.org/10.3390/ma14133641

Ejemplares similares

Application of Acoustic Emission on the Characterization of Fracture in Textile Reinforced Cement Laminates
por: Blom, J., et al.
Publicado: (2014)

Manufacture of antibacterial carbon fiber-reinforced plastics (CFRP) using imine-based epoxy vitrimer for medical application
por: Kim, Wonbin, et al.
Publicado: (2023)

Mechanical properties and acoustic emission analysis of desert sand concrete reinforced with steel fiber
por: Qu, Changwei, et al.
Publicado: (2022)

Investigation on Mode I Fracture Toughness of Woven Carbon Fiber-Reinforced Polymer Composites Incorporating Nanomaterials
por: Truong, Gia Toai, et al.
Publicado: (2020)

Acoustic Emission Signal Entropy as a Means to Estimate Loads in Fiber Reinforced Polymer Rods
por: Shateri, Mohammadhadi, et al.
Publicado: (2021)

Acoustic Emission-Based Analysis of Damage Mechanisms in Filament Wound Fiber Reinforced Composite Tubes
por: Ghahremani, Parsa, et al.
Publicado: (2023)

Monitoring of Carbon Fiber-Reinforced Old Timber Beams via Strain and Multiresonant Acoustic Emission Sensors
por: Rescalvo, Francisco J., et al.
Publicado: (2018)

Investigation on the Continuous Wave Mode and the ms Pulse Mode Fiber Laser Drilling Mechanisms of the Carbon Fiber Reinforced Composite
por: Li, Xiao, et al.
Publicado: (2020)

The Acoustic Emission Method Implementation Proposition to Confirm the Presence and Assessment of Reinforcement Quality and Strength of Fiber–Cement Composites
por: Adamczak-Bugno, Anna, et al.
Publicado: (2020)

Deformation and Failure Mechanism of Particulate Filled and Short Fiber Reinforced Thermoplastics: Detection and Analysis by Acoustic Emission Testing
por: Ferdinánd, Milán, et al.
Publicado: (2021)

Acoustic Emission Characteristics and Damage Mechanisms Investigation of Basalt Fiber Concrete with Recycled Aggregate
por: Li, Guodong, et al.
Publicado: (2020)

Denouement of the Energy-Amplitude and Size-Amplitude Enigma for Acoustic-Emission Investigations of Materials
por: Kamel, Sarah M., et al.
Publicado: (2022)

Detection of delamination of steel–polymer sandwich composites using acoustic emission and development of a forming limit diagram considering delamination
por: Yang, Jewook, et al.
Publicado: (2023)

Investigation of the Failure Modes of Textile-Reinforced Concrete and Fiber/Textile-Reinforced Concrete under Uniaxial Tensile Tests
por: Mattarollo, Giorgio, et al.
Publicado: (2023)

An Investigation on Fatigue Resistance of Notched Long Fiber-Reinforced Composite Materials
por: Cao, Lili, et al.
Publicado: (2022)

Road Performance Investigation on Fiber-Reinforced Recycled Cement Base Material
por: Ji, Yongcheng, et al.
Publicado: (2022)

Fracture Analysis of Short-Scale Corroded/Healthy Reinforced Concrete Beams under Bending Using Acoustic Emission
por: Seye, Mouhamadou Mountakhah, et al.
Publicado: (2023)

Mechanical and Acoustic Properties of Jute Fiber-Reinforced Polypropylene Composites
por: Shen, Jiahui, et al.
Publicado: (2021)

Novel Fiber-Optic Ring Acoustic Emission Sensor
por: Wei, Peng, et al.
Publicado: (2018)

Experimental investigation on fracturing effects in hydraulic sand fracturing with acoustic emission and 3d laser scanning
por: Zhang, Shuhui, et al.
Publicado: (2023)

Experimental Investigation of Wave Propagation Characteristics in Entangled Metallic Wire Materials by Acoustic Emission
por: Ma, Yanhong, et al.
Publicado: (2023)

Mechanical Properties and Fracture Behavior of Crumb Rubber Basalt Fiber Concrete Based on Acoustic Emission Technology
por: Liu, Hanbing, et al.
Publicado: (2020)

Frost resistance investigation of fiber reinforced recycled brick aggregate cementitious materials
por: Ji, Yongcheng, et al.
Publicado: (2022)

Basalt Fibers Reinforced Concrete: Strength and Failure Modes
por: AL-Kharabsheh, Buthainah Nawaf, et al.
Publicado: (2022)

Coherent Fiber-Optic Sensor for Ultra-Acoustic Crack Emissions
por: Di Luch, Ilaria, et al.
Publicado: (2021)

Acoustic, electromagnetic, neutron emissions from fracture and earthquakes
por: Carpinteri, Alberto, et al.
Publicado: (2015)

Criticality Hidden in Acoustic Emissions and in Changing Electrical Resistance during Fracture of Rocks and Cement-Based Materials
por: Niccolini, Gianni, et al.
Publicado: (2020)

Stress–strain and acoustic emission characteristics of cement-based materials used to simulate soft rock with fractures
por: Liu, Han-dong, et al.
Publicado: (2022)

Standard Practice for Acoustic Emission Examination of Reinforced Thermosetting Resin Pipe (RTRP)
por: American Society for Testing and Materials. Philadelphia
Publicado: (2011)

Acoustic Emission Monitoring of Multicell Reinforced Concrete Box Girders Subjected to Torsion
por: Bagherifaez, Marya, et al.
Publicado: (2014)

Damage Source Identification of Reinforced Concrete Structure Using Acoustic Emission Technique
por: Panjsetooni, Alireza, et al.
Publicado: (2013)

Acoustic Emission Analysis of Corroded Reinforced Concrete Columns under Compressive Loading
por: Li, Qiang, et al.
Publicado: (2020)

Investigation of Workability and Mechanical Properties of PVA Fiber-Reinforced Phosphogypsum-Based Composite Materials
por: Huang, Ronggui, et al.
Publicado: (2023)

Investigation on Fracture Behavior of Cementitious Composites Reinforced with Aligned Hooked-End Steel Fibers
por: Khan, Sujjaid, et al.
Publicado: (2022)

Expanding Puck and Schürmann Inter Fiber Fracture Criterion for Fiber Reinforced Thermoplastic 3D-Printed Composite Materials
por: Dutra, Thiago Assis, et al.
Publicado: (2020)

Polymer Composite Materials Fiber-Reinforced for the Reinforcement/Repair of Concrete Structures
por: Soupionis, George, et al.
Publicado: (2020)

Stress analysis of fiber-reinforced composite materials
por: Hyer, M. W.
Publicado: (1998)

Fiber-reinforced composites: materials, manufacturing, and design
por: Mallick, P K
Publicado: (1993)

Fiber-reinforced composites: materials, manufacturing, and design
por: Mallick, P K
Publicado: (2007)

The Application of Fiber-Reinforced Materials in Disc Repair
por: Pei, Bao-Qing, et al.
Publicado: (2013)

Cannot write session to /tmp/vufind_sessions/sess_pji471a9kuenl19rgdram7me0p