Cargando…

Can a Semi-Active Energy Harvesting Shock Absorber Mimic a Given Vehicle Passive Suspension?

Energy harvesting shock absorbers (EHSA) have made great progress in recent years, although there are still no commercial solutions for this technology. This paper addresses the question of whether, and under what conditions, an EHSA can completely replace a conventional one. In this way, any conven...

Descripción completa

Detalles Bibliográficos
Autores principales: Reyes-Avendaño, Jorge A., Moreno-Ramírez, Ciro, Gijón-Rivera, Carlos, Gonzalez-Hernandez, Hugo G., Olazagoitia, José Luis
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2021
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8271985/
https://www.ncbi.nlm.nih.gov/pubmed/34206734
http://dx.doi.org/10.3390/s21134378
Descripción
Sumario:Energy harvesting shock absorbers (EHSA) have made great progress in recent years, although there are still no commercial solutions for this technology. This paper addresses the question of whether, and under what conditions, an EHSA can completely replace a conventional one. In this way, any conventional suspension could be replicated at will, while recovering part of the wasted energy. This paper focuses on mimicking the original passive damper behavior by continuously varying the electrical parameters of the regenerative damper. For this study, a typical ball-screw EHSA is chosen, and its equivalent suspension parameters are tried to be matched to the initial damper. The methodology proposes several electrical control circuits that optimize the dynamic behavior of the regenerative damper from the continuous variation of a load resistance. The results show that, given a target damper curve, the regenerative damper can adequately replicate it when there is a minimum velocity in the damper. However, when the damper velocity is close to zero, the only way to compensate for inertia is through the introduction of external energy to the system.