Synthesis, physico-mechanical and microstructural characterization of Al6063/SiC/PKSA hybrid reinforced composites

The utilization of agro-residues ash as complementary reinforcing materials continues to gain prominence for metal matrix composite (MMCs) development. A rarely investigated but largely available ash among these agro-residues is the palm kernel shell ash (PKSA). Thus, the present study investigates the influence of PKSA particulates hybridized with SiC on the physico-mechanical properties and microstructure of Al6063 metal composites. The composites are synthesized using the double stir-casting technique with SiC held constant at 2 wt.%, while the PKSA contents are varied from 0 to 8 wt.%. The phases present and morphology of the composites are investigated using X-ray diffractometer (XRD) and scanning electron microscopy (SEM), respectively. The density, porosity, hardness, tensile and fracture toughness tests are carried out on the hybrid composites. X-ray diffractometer revealed that for Al 6063, only Al cubic crystal system was identifiable within the matrix. However, for the reinforced composites, major phases identified are Al, Fe(3)Si, SiC, MgO, and SiO(2). The SEM images show that the particulates reinforcements (SiC and PKSA) were uniformly dispersed in the matrix. The percentage porosity for the composites ranged from 2.06 to 2.39%. In addition, hardness, yield strength and ultimate tensile strength of the composites are about 10.3%, 18.5% and 10.4%, respectively better than for Al 6063. However, the percent elongation and fracture toughness are lower for the hybrid composites than for Al 6063 and SiC reinforced composite with values decreasing with increase in ash content. Hence, the MMCs produced will be applicable for light-weight engineering applications.