Cargando…

The Fatigue Behaviors of a Medium-Carbon Pearlitic Wheel-Steel with Elongated Sulfides in High-Cycle and Very-High-Cycle Regimes

The effects of stress ratio (R), loading condition, and MnS inclusion on the fatigue behavior of a medium-carbon pearlitic wheel-steel were investigated by a combination of rotating (frequency of 52.5 Hz, 10(3)–10(8)) bending and ultrasonic (frequency of 20 kHz, 5 × 10(4)–10(9)) axial cycling tests...

Descripción completa

Detalles Bibliográficos
Autores principales:	Liu, Lu, Ma, Yifan, Liu, Shisen, Wang, Shengnan
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8347604/ https://www.ncbi.nlm.nih.gov/pubmed/34361511 http://dx.doi.org/10.3390/ma14154318

Ejemplares similares

Bending Fatigue Behavior of 316L Stainless Steel up to Very High Cycle Fatigue Regime
por: Hu, Yongtao, et al.
Publicado: (2020)

Analysis of Fatigue Crack Paths in Cold Drawn Pearlitic Steel
por: Toribio, Jesús, et al.
Publicado: (2015)

Influence of Strain Gradient on Fatigue Life of Carbon Steel for Pressure Vessels in Low-Cycle and High-Cycle Fatigue Regimes
por: Fujii, Tomoyuki, et al.
Publicado: (2022)

Genesis of Nanogalvanic Corrosion Revealed in Pearlitic Steel
por: Hayden, Steven C., et al.
Publicado: (2022)

Advanced Heat Treatment of Pearlitic Rail Steel
por: Jabłońska, Magdalena, et al.
Publicado: (2023)

Effects of Loading Frequency and Loading Type on High-Cycle and Very-High-Cycle Fatigue of a High-Strength Steel
por: Hu, Yuanpei, et al.
Publicado: (2018)

Mechanical properties of friction induced nanocrystalline pearlitic steel
por: Medina-Clavijo, B, et al.
Publicado: (2022)

Influence of the Thermal Cutting Process on Cracking of Pearlitic Steels
por: Tuz, Lechosław, et al.
Publicado: (2021)

Mechanical properties of friction induced nanocrystalline pearlitic steel
por: Medina-Clavijo, B., et al.
Publicado: (2022)

The Effect of Microstructure and Axial Tension on Three-Point Bending Fatigue Behavior of TC4 in High Cycle and Very High Cycle Regimes
por: Bao, Xuechun, et al.
Publicado: (2019)

Very High Cycle Fatigue Behavior of Additively Manufactured 316L Stainless Steel
por: Voloskov, Boris, et al.
Publicado: (2020)

Yield-Point Phenomenon and Plastic Bands in Ferrite–Pearlite Steels
por: Qiu, Hai, et al.
Publicado: (2022)

Microstructural Evolution of SK85 Pearlitic Steel Deformed by Heavy Cold Rolling
por: Yang, Cai-Ding, et al.
Publicado: (2022)

Intercolonial Microdamage and Cracking Micromechanisms during Wire Drawing of Pearlitic Steel
por: Toribio, Jesús, et al.
Publicado: (2023)

Hydrogen Assisted Cracking in Pearlitic Steel Rods: The Role of Residual Stresses Generated by Fatigue Precracking
por: Toribio, Jesús, et al.
Publicado: (2017)

The Effect of Stress Ratios on the Very High Cycle Fatigue Behavior of 9%Cr Turbine Steel at 630 °C
por: Wang, Quanyi, et al.
Publicado: (2020)

Mean‐stress sensitivity of an ultrahigh‐strength steel under uniaxial and torsional high and very high cycle fatigue loading
por: Schönbauer, Bernd M., et al.
Publicado: (2022)

Analysis of the Degradation of Pearlitic Steel Mechanical Properties Depending on the Stability of the Structural Phases
por: Šmak, Radim, et al.
Publicado: (2023)

Crack Initiation Mechanism and Life Prediction of Ti60 Titanium Alloy Considering Stress Ratios Effect in Very High Cycle Fatigue Regime
por: He, Ruixiang, et al.
Publicado: (2022)

Influence of Heat Treatment on Cyclic Response of Nickel-Based Superalloy Inconel 718 up to Very-High Cycle Regime
por: Zhao, Mengxiong, et al.
Publicado: (2020)

Improvement of wear resistance in a pearlitic rail steel via quenching and partitioning processing
por: Masoumi, Mohammad, et al.
Publicado: (2019)

Effect of pearlitic morphology with varying fineness on the cavitation erosion behavior of eutectoid rail steel
por: Rajput, Arun, et al.
Publicado: (2020)

On the Change in Hydrogen Diffusion and Trapping Behaviour of Pearlitic Rail Steel at Different Stages of Production
por: Eichinger, Matthias, et al.
Publicado: (2023)

Effect of Low Cycle Fatigue Predamage on Very High Cycle Fatigue Behavior of TC21 Titanium Alloy
por: Nie, Baohua, et al.
Publicado: (2017)

Enhancing Strain Capacity by the Introduction of Pearlite in Bainite and Polygonal Ferrite Dual-Phase Pipeline Steel
por: Tu, Xingyang, et al.
Publicado: (2021)

Effects of Inoculation on the Pearlitic Gray Cast Iron with High Thermal Conductivity and Tensile Strength
por: Wang, Guiquan, et al.
Publicado: (2018)

Prediction of the Non-Isothermal Austenitization Kinetics of Fe-C-Cr Low Alloy Steels with Lamellar Pearlite Microstructure
por: Li, Zhiqiang, et al.
Publicado: (2022)

Effects of Loading Frequency and Specimen Geometry on High Cycle and Very High Cycle Fatigue Life of a High Strength Titanium Alloy
por: Li, Yanqing, et al.
Publicado: (2018)

High-Cycle, Low-Cycle, Extremely Low-Cycle Fatigue and Monotonic Fracture Behaviors of Low-Carbon Steel and Its Welded Joint
por: Kim, Younghune, et al.
Publicado: (2019)

Study on micro crack propagation mechanism of ferrite–pearlite gas transmission pipeline steel with lamellar structure
por: Xu, Taolong, et al.
Publicado: (2022)

Development of Temperature-Controlled Shear Tests to Reproduce White-Etching-Layer Formation in Pearlitic Rail Steel
por: Thiercelin, Léo, et al.
Publicado: (2022)

Synergistic Effect of Al(2)O(3) Inclusion and Pearlite on the Localized Corrosion Evolution Process of Carbon Steel in Marine Environment
por: Liu, Chao, et al.
Publicado: (2018)

Ultra-strong and damage tolerant metallic bulk materials: A lesson from nanostructured pearlitic steel wires
por: Hohenwarter, A., et al.
Publicado: (2016)

Application Research on Nb Microalloying of High-Carbon Pearlite Bridge Cable Wire Rods
por: Zhu, Xiaoxiong, et al.
Publicado: (2023)

Ultrafast plasmonic photoemission in the single-cycle and few-cycle regimes
por: Kiss, G. Zs, et al.
Publicado: (2022)

Very High Cycle Fatigue Failure Analysis and Life Prediction of Cr-Ni-W Gear Steel Based on Crack Initiation and Growth Behaviors
por: Deng, Hailong, et al.
Publicado: (2015)

Usability of Ultrasonic Frequency Testing for Rapid Generation of High and Very High Cycle Fatigue Data
por: Fitzka, Michael, et al.
Publicado: (2021)

Effect of Cold Rolling Reduction Rate on the Microstructure and Properties of Q&P Steel with a Ferrite-Pearlite Initial Structure
por: Wang, Shengwei, et al.
Publicado: (2023)

Learning to Cycle: From Training Wheels to Balance Bike
por: Mercê, Cristiana, et al.
Publicado: (2022)

Comparison on Tensile Characteristics of Plain C–Mn Steel with Ultrafine Grained Ferrite/Cementite Microstructure and Coarse Grained Ferrite/Pearlite Microstructure
por: Tian, Yan, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_hgqmhu3rdshmuk2snkksg58mkg