Sustainable Hydrates for Enhanced Carbon Dioxide Capture from an Integrated Gasification Combined Cycle in a Fixed Bed Reactor

[Image: see text] An increase in temperature of up to 2 °C occurs when the amount of CO(2) reaches a range of 450 ppm. The permanent use of mineral oil is closely related to CO(2) emissions. Maintaining the sustainability of fossil fuels and eliminating and reducing CO(2) emissions is possible through carbon capture and storage (CCS) processes. One of the best ways to maintain CCS is hydrate-based gas separation. Selected type T1-5 (0.01 mol % sodium dodecyl sulphate (SDS) + 5.60 mol % tetrahydrofuran (THF), with the help of this silica gel promotion was strongly stimulated. A pressure of 36.5 bar of CO(2) is needed in H(2)O to investigate the CO(2) hydrate formation. Therefore, ethylene glycol monoethyl ether (EGME at 0.10 mol %) along with SDS (0.01 mol %) labeled as T1A-2 was used as an alternative to THF at the comparable working parameters in which CO(2) uptake of 5.45 mmol of CO(2)/g of H(2)O was obtained. Additionally, it was found that with an increase in tetra-n-butyl ammonium bromide (TBAB) supplementation of CO(2), the hydrate and operating capacity of the process increased. When the bed height was reduced from 3 cm to 2 cm with 0.1 mol % TBAB and 0.01% SDS (labelled as T3-2) in fixed bed reactor (FBR), the outcomes demonstrated a slight expansion in gas supply to 1.54 mmol of CO(2)/g of H(2)O at working states of 283 K and 70 bar. The gas selectivity experiment by using the high-pressure volume analysis through hydrate formation was performed in which the highest CO(2) uptake for the employment of silica contacts with water in fuel gas mixture was observed in the non-IGCC conditions. Thus, two types of reactor configurations are being proposed for changing the process from batch to continuous with the employment of macroporous silica contacts with new consolidated promoters to improve the formation of CO(2) hydrate in the IGCC conditions. Later, much work should be possible on this with an assortment of promoters and specific performance parameters. It was reported in previous work that the repeatability of equilibrium moisture content and gas uptake attained for the sample prepared by the highest rates of stirring was the greatest with the CIs of ±0.34 wt % and ±0.19 mmol of CO(2)/g of H(2)O respectively. This was due to the amount of water occluded inside silica gel pores was not an issue or in other words, vigorous stirring increased the spreadability. The variation of pore size to improve the process can be considered for future work.