Cargando…

Heat Transfer and Entropy in a Vertical Porous Plate Subjected to Suction Velocity and MHD

This article presents an investigation of heat transfer in a porous medium adjacent to a vertical plate. The porous medium is subjected to a magnetohydrodynamic effect and suction velocity. The governing equations are nondepersonalized and converted into ordinary differential equations. The resultin...

Descripción completa

Detalles Bibliográficos
Autores principales:	Ahammad, N. Ameer, Badruddin, Irfan Anjum, Kamangar, Sarfaraz, Khaleed, H.M.T., Saleel, C. Ahamed, Mahlia, Teuku Meurah Indra
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8392053/ https://www.ncbi.nlm.nih.gov/pubmed/34441209 http://dx.doi.org/10.3390/e23081069

Ejemplares similares

Leverage of Environmental Pollutant Crump Rubber on the Dry Sliding Wear Response of Epoxy Composites
por: Shahapurkar, Kiran, et al.
Publicado: (2021)

Surface Functionalization of Magnetite Nanoparticles with Multipotent Antioxidant as Potential Magnetic Nanoantioxidants and Antimicrobial Agents
por: Shah, Syed Tawab, et al.
Publicado: (2022)

Investigation of Self-Healing Mortars with and without Bagasse Ash at Pre- and Post-Crack Times
por: Tesfamariam, Belay Brehane, et al.
Publicado: (2022)

Size Effect of Nanoceria Blended with CIME Biodiesel on Engine Characteristics
por: Pandey, Vivek, et al.
Publicado: (2022)

Utilizing heat pipe heat exchanger to reduce the energy consumption of airborne infection isolation hospital room HVAC system
por: Sukarno, Ragil, et al.
Publicado: (2021)

Facile Preparation of Carbon Microcapsules Containing Phase-Change Material with Enhanced Thermal Properties
por: Tahan Latibari, Sara, et al.
Publicado: (2014)

Synthesis and characterization of rice husk biochar via hydrothermal carbonization for wastewater treatment and biofuel production
por: Hossain, Nazia, et al.
Publicado: (2020)

Integration of Phase Change Material in the Design of Solar Concentrator-Based Water Heating System
por: Rizal, Teuku Azuar, et al.
Publicado: (2021)

Effects of MHD and porosity on entropy generation in two incompressible Newtonian fluids over a thin needle in a parallel free stream
por: Ali, Farhad, et al.
Publicado: (2020)

Accelerated Thermal Cycling Test of Microencapsulated Paraffin Wax/Polyaniline Made by Simple Preparation Method for Solar Thermal Energy Storage
por: Silakhori, Mahyar, et al.
Publicado: (2013)

Membrane Surface Patterning as a Fouling Mitigation Strategy in Liquid Filtration: A Review
por: Barambu, Nafiu Umar, et al.
Publicado: (2019)

Merits and Limitations of Mathematical Modeling and Computational Simulations in Mitigation of COVID-19 Pandemic: A Comprehensive Review
por: Afzal, Asif, et al.
Publicado: (2021)

Scientific Advancements in Composite Materials for Aircraft Applications: A Review
por: Parveez, Bisma, et al.
Publicado: (2022)

The Yield Prediction of Synthetic Fuel Production from Pyrolysis of Plastic Waste by Levenberg–Marquardt Approach in Feedforward Neural Networks Model
por: Abnisa, Faisal, et al.
Publicado: (2019)

Numerical Investigation of the Effect of Stenosis Geometry on the Coronary Diagnostic Parameters
por: Kamangar, Sarfaraz, et al.
Publicado: (2014)

Mathematical Modelling and Optimization for Facile Synthesis of Structured Activated Carbon (ACs) from Adansonia kilima (Baobab) Wood Chips Integrating Microwave-Assisted Pyrolysis for the Elimination of Lead (II) Cations from Wastewater Effluents
por: Sellamuthu, Santhana, et al.
Publicado: (2023)

Mechanical Properties of PC-ABS-Based Graphene-Reinforced Polymer Nanocomposites Fabricated by FDM Process
por: Tambrallimath, Vijay, et al.
Publicado: (2021)

Insight into the Sustainable Integration of Bio- and Petroleum Refineries for the Production of Fuels and Chemicals
por: Dwi Prasetyo, Wegik, et al.
Publicado: (2020)

Chemical Composition, Antioxidant, Antibacterial, and Antibiofilm Activities of Backhousia citriodora Essential Oil
por: Lim, Ann Chie, et al.
Publicado: (2022)

Analysis of the Effect of Parameters on Fracture Toughness of Hemp Fiber Reinforced Hybrid Composites Using the ANOVA Method
por: Madhusudhana, H. K., et al.
Publicado: (2021)

Significance low oscillating magnetic field and Hall current in the nano-ferrofluid flow past a rotating stretchable disk
por: Ramzan, Muhammad, et al.
Publicado: (2021)

Mechanical and Thermal Properties of Montmorillonite-Reinforced Polypropylene/Rice Husk Hybrid Nanocomposites
por: Majeed, Khaliq, et al.
Publicado: (2019)

On the Influence of Soret and Dufour Effects on MHD Free Convective Heat and Mass Transfer Flow over a Vertical Channel with Constant Suction and Viscous Dissipation
por: Uwanta, Ime Jimmy, et al.
Publicado: (2014)

The intelligent networks for double-diffusion and MHD analysis of thin film flow over a stretched surface
por: Uddin, Iftikhar, et al.
Publicado: (2021)

On the Residual Stresses and Fracture Toughness of Glass/Carbon Epoxy Composites
por: Umarfarooq, M. A., et al.
Publicado: (2022)

Development of A Novel Corrugated Polyvinylidene difluoride Membrane via Improved Imprinting Technique for Membrane Distillation
por: Mat Nawi, Normi Izati, et al.
Publicado: (2019)

Corrosion Characterization at Surface and Subsurface of Iron-Based Buried Water Pipelines
por: Yeshanew, Dessalegn Ahmed, et al.
Publicado: (2021)

Mechanical Response of Glass–Epoxy Composites with Graphene Oxide Nanoparticles
por: Uppin, Vinayak S., et al.
Publicado: (2022)

Entropy Generation Analysis of Peristaltic Flow of Nanomaterial in a Rotating Medium through Generalized Complaint Walls of Micro-Channel with Radiation and Heat Flux Effects
por: Ali, Aamir, et al.
Publicado: (2022)

Explicit Solutions of MHD Flow and Heat Transfer of Casson Fluid over an Exponentially Shrinking Sheet with Suction
por: Liu, Ling, et al.
Publicado: (2022)

Development and Characterization of Biocompatible Membranes from Natural Chitosan and Gelatin for Pervaporative Separation of Water–Isopropanol Mixture
por: Kulkarni, Akshay S., et al.
Publicado: (2021)

Entropy optimization and heat transfer analysis in MHD Williamson nanofluid flow over a vertical Riga plate with nonlinear thermal radiation
por: Rooman, Muhammad, et al.
Publicado: (2021)

Entropy generation analysis for MHD flow of water past an accelerated plate
por: Abdelhameed, Tarek N.
Publicado: (2021)

Electromagnetic Characterization of a Multiwalled Carbon Nanotubes–Silver Nanoparticles-Reinforced Polyvinyl Alcohol Hybrid Nanocomposite in X-Band Frequency
por: Yusof, Yusliza, et al.
Publicado: (2021)

Characteristics of Conventional and Microwave Sintered Iron Ore Preform
por: Equbal, Azhar, et al.
Publicado: (2022)

Evaluating CNC Milling Performance for Machining AISI 316 Stainless Steel with Carbide Cutting Tool Insert
por: Equbal, Azhar, et al.
Publicado: (2022)

Entropy generation in nanofluid flow due to double diffusive MHD mixed convection
por: Mondal, Priyajit, et al.
Publicado: (2021)

MHD Double-Diffusive Carreau Fluid Flow through a Porous Medium with Variable Thermal Conductivity and Suction/Injection
por: Zeb, Salman, et al.
Publicado: (2022)

Suction catheter coiling in i-gel
por: Naaz, Shagufta, et al.
Publicado: (2021)

Fabrication and Physicochemical Study of B2SA-Grafted Poly(vinyl Alcohol)–Graphene Hybrid Membranes for Dehydration of Bioethanol by Pervaporation
por: Kalahal, Prakash B., et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_enkrrkhi4f1clnso6gtba7bmlh