Cargando…

Spray mist reduction by means of a high-volume evacuation system—Results of an experimental study

OBJECTIVES: High-speed tooth preparation requires effective cooling to avoid thermal damage, which generates spray mist, which is a mixture of an aerosol, droplets and particles of different sizes. The aim of this experimental study was to analyze the efficacy of spray mist reduction with an intraor...

Descripción completa

Detalles Bibliográficos
Autores principales: Koch, Martin, Graetz, Christian
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Public Library of Science 2021
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8415595/
https://www.ncbi.nlm.nih.gov/pubmed/34478480
http://dx.doi.org/10.1371/journal.pone.0257137
Descripción
Sumario:OBJECTIVES: High-speed tooth preparation requires effective cooling to avoid thermal damage, which generates spray mist, which is a mixture of an aerosol, droplets and particles of different sizes. The aim of this experimental study was to analyze the efficacy of spray mist reduction with an intraoral high-volume evacuation system (HVE) during simulated high-speed tooth preparation for suboptimal versus optimal suction positions of 16 mm sized cannulas and different flow rates of the HVE. MATERIAL AND METHODS: In a manikin head, the upper first premolar was prepared with a dental turbine, and generated particles of 5–50 microns were analyzed fifty millimeters above the mouth opening with the shadow imaging technique (frame: 6.6×5.3×1.1 mm). This setup was chosen to generate a reproducible spray mist in a vertical direction towards an imaginary operator head (worst case scenario). The flow rate (FR) of the HVE was categorized into five levels (≤120 l/min up to 330 l/min). The number of particles per second (NP; p/s) was counted, and the mass volume flow of particles per second (MVF; μg/s*cm(3)) was calculated for 10 sec. Statistical tests were nonparametric and two-sided (p≤0.05). RESULTS: With increasing flow rate, the NP/MVF values decreased significantly (eta: 0.671/0.678; p≤0.001). Using a suboptimally positioned cannula with an FR≤160 l/min, significantly higher NP values (mean±SD) of 731.67±54.24 p/s (p≤0.019) and an MVF of 3.72±0.42 μg/s*cm(3) (p≤0.010) were measured compared to those of the optimal cannula position and FR≥300 l/min (NP/MVF: 0/0). No significant difference in NP and MVF was measurable between FR≥250 l/min and FR>300 l/min (p = 0.652, p = 0.664). CONCLUSION: Within the limitations of the current experimental study, intraoral high-flow rate suction with ≥300 l/min with an HVE effectively reduced 5–50 μm sized particles of the spray mist induced by high-speed tooth preparation with a dental turbine.