Cargando…

Influence of Carbon on the Microstructure Evolution and Hardness of Fe–13Cr–xC (x = 0–0.7 wt.%) Stainless Steel

The influence of carbon on the phase transformation behavior of stainless steels with the base chemical composition Fe–13Cr (wt.%), and carbon concentrations in the range of 0–0.7 wt.%, was studied at temperatures between −196 °C and liquidus temperature. Based on differential scanning calorimetry (...

Descripción completa

Detalles Bibliográficos
Autores principales:	Harwarth, Michael, Brauer, Adam, Huang, Qiuliang, Pourabdoli, Mehdi, Mola, Javad
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8434292/ https://www.ncbi.nlm.nih.gov/pubmed/34501153 http://dx.doi.org/10.3390/ma14175063

Ejemplares similares

Influence of 1.5 wt.% Bi on the Microstructure, Hardness, and Shear Strength of Sn-0.7Cu Solder Joints after Isothermal Annealing
por: Ramli, Mohd Izrul Izwan, et al.
Publicado: (2021)

Results on 0.7% X0 thick pixel modules for the ATLAS detector
por: Netchaeva, P, et al.
Publicado: (2001)

Investigation of the Localized Corrosion and Passive Behavior of Type 304 Stainless Steels with 0.2–1.8 wt % B
por: Ha, Heon-Young, et al.
Publicado: (2018)

Microstructural Constituents and Mechanical Properties of Low-Density Fe-Cr-Ni-Mn-Al-C Stainless Steels
por: Scherbring, Steffen, et al.
Publicado: (2022)

Tuning of the Structure and Magnetocaloric Effect of Mn(1−x)Zr(x)CoGe Alloys (Where x = 0.03, 0.05, 0.07, and 0.1)
por: Kutynia, Karolina, et al.
Publicado: (2021)

Investigation of Antibacterial Properties of Corrosion-Resistant 316L Steel Alloyed with 0.2 wt.% and 0.5 wt.% Ag
por: Kaplan, Mikhail A., et al.
Publicado: (2022)

The tunable spin reorientation, temperature induced magnetization reversal, and spontaneous exchange bias effect of Sm(0.7)Y(0.3)Cr(1−x)Ga(x)O(3)
por: Ma, Zhijie, et al.
Publicado: (2018)

Thermal activation energy of 3D vortex matter in NaFe(1−x)Co(x)As (x = 0.01, 0.03 and 0.07) single crystals
por: Choi, W. J., et al.
Publicado: (2017)

Effects of Partial Manganese Substitution by Cobalt on the Physical Properties of Pr(0.7)Sr(0.3)Mn((1−x))Co(x)O(3) (0 ≤ x ≤ 0.15) Manganites
por: Zdiri, Feriel, et al.
Publicado: (2023)

The Effect of Substitution of Mn by Pd on the Structure and Thermomagnetic Properties of the Mn(1−x)Pd(x)CoGe Alloys (Where x = 0.03, 0.05, 0.07 and 0.1)
por: Kutynia, Karolina, et al.
Publicado: (2023)

Structural, optical and microwave dielectric properties of Ba(Ti(1−x)Sn(x))(4)O(9), 0 ≤ x ≤ 0.7 ceramics
por: Ali, Asad, et al.
Publicado: (2021)

$D^*\Delta$ molecular interpretation for the $X_c$(3250)
por: Ortega, P G, et al.
Publicado: (2014)

The $X_c$(3250) as a $D^∗\Delta$ molecule
por: Ortega, P G, et al.
Publicado: (2014)

Novel Microwave Absorber of Ni(x)Mn(1–x)Fe(2)O(4)/Carbonized Chaff (x = 0.3, 0.5, and 0.7) Based on Biomass
por: Qi, Yali, et al.
Publicado: (2019)

Preferential dissolution behaviour of the austenite phase in Fe–27Cr–xC high chromium cast iron
por: Lee, Jun-Seob, et al.
Publicado: (2023)

Properties and Microstructure Evaluation in NiAl-xWC (x = 0 − 90 wt.%) Intermetallic-Based Composites Prepared by Mechanical Alloying
por: Piechowiak, Daria, et al.
Publicado: (2023)

Compositional Engineering of a La(1-x)Ba(x)CoO(3-δ)-(1-a) BaZr(0.9)Y(0.1)O(2.95) (a = 0.6, 0.7, 0.8 and x = 0.5, 0.6, 0.7) Nanocomposite Cathodes for Protonic Ceramic Fuel Cells
por: Rioja-Monllor, Laura, et al.
Publicado: (2019)

Microstructure Evolution and Mechanical Properties of X6CrNiMoVNb11-2 Stainless Steel after Heat Treatment
por: Fu, Jia, et al.
Publicado: (2021)

Effect of Cold-Rolling Reduction on Recrystallization Microstructure, Texture and Corrosion Properties of the X2CrNi12 Ferritic Stainless Steel
por: Li, Rui, et al.
Publicado: (2022)

Carbides Dissolution in 5Cr15MoV Martensitic Stainless Steel and New Insights into Its Effect on Microstructure and Hardness
por: Liu, Wenle, et al.
Publicado: (2022)

Microstructures, Mechanical Properties, and Corrosion Behavior of As-Cast Mg–2.0Zn–0.5Zr–xGd (wt %) Biodegradable Alloys
por: Yao, Huai, et al.
Publicado: (2018)

Processing and Microstructure of As-Cast Ti-45Al-2W-xC Alloys
por: Cegan, Tomas, et al.
Publicado: (2022)

Activity and Thermal Aging Stability of La(1−x)Sr(x)MnO(3) (x = 0.0, 0.3, 0.5, 0.7) and Ir/La(1−x)Sr(x)MnO(3) Catalysts for CO Oxidation with Excess O(2)
por: Drosou, Catherine, et al.
Publicado: (2023)

Study on the preparation and properties of Sn–0.7Cu–xBi alloy
por: Shenggang, Zhou, et al.
Publicado: (2023)

Magnetic and Magnetocaloric Properties of Nano- and Polycrystalline Manganites La((0.7−x))Eu(x)Ba(0.3)MnO(3)
por: Atanasov, Roman, et al.
Publicado: (2022)

A Spectroscopic Investigation of Eu(3+) Incorporation in LnPO(4) (Ln = Tb, Gd(1-x)Lu(x), X = 0.3, 0.5, 0.7, 1) Ceramics
por: Lösch, Henry, et al.
Publicado: (2019)

High Curie temperature ferromagnetic structures of (Sb(2)Te(3))(1−x)(MnSb(2)Te(4))(x) with x = 0.7–0.8
por: Levy, Ido, et al.
Publicado: (2023)

Study of complex impedance spectroscopic properties of La(0.7−x)Dy(x)Sr(0.3)MnO(3) perovskite oxides
por: Debbebi, I. Sfifir, et al.
Publicado: (2018)

Corrosion Testing of CrN(x)-Coated 310 H Stainless Steel under Simulated Supercritical Water Conditions
por: Tudose, Aurelia Elena, et al.
Publicado: (2022)

Strengthening of 0.18 wt % C Steel by Cold Differential Speed Rolling
por: Kang, Jee-Hyun, et al.
Publicado: (2022)

Theoretical study of the mechanical properties of CrFeCoNiMo(x) (0.1 ≤ x ≤ 0.3) alloys
por: Liu, Yu, et al.
Publicado: (2020)

Synthesis and Characterization of 40 wt % Ce(0.9)Pr(0.1)O(2–δ)–60 wt % Nd(x)Sr(1−x)Fe(0.9)Cu(0.1)O(3−δ) Dual-Phase Membranes for Efficient Oxygen Separation
por: Chen, Guoxing, et al.
Publicado: (2020)

High-performance LPG sensing behaviour of CoCr(2-x)Ce(x)O(4) (x = 0 to 0.02) for sensor applications
por: Angadi, V. Jagadeesha, et al.
Publicado: (2023)

Assessment of Corrosion Resistance and Hardness of Shot Peened X5CrNi18-10 Steel
por: Walczak, Mariusz, et al.
Publicado: (2022)

Influence of C and N on Strain-Induced Martensite Formation in Fe-15Cr-7Mn-4Ni-0.5Si Austenitic Steel
por: Quitzke, Caroline, et al.
Publicado: (2021)

Microstructural Characteristics and Hardness Enhancement of Super Duplex Stainless Steel by Friction Stir Processing
por: Pan, Linlin, et al.
Publicado: (2022)

Mechanical properties of CrFeCoNiCu(x) (0 ≤ x ≤ 0.3) HEAs from first-principles calculations
por: Liu, Yu, et al.
Publicado: (2020)

Effect of Different Laser Groove Texture Collation Frequency on Tribological Properties of 0Cr17Ni7Al Stainless Steel
por: Yang, Liguang, et al.
Publicado: (2022)

Al(0.25)CoCrFeNiV High Entropy Alloy Coating Deposited by Laser Cladding on Stainless Steel
por: Samoilova, Olga, et al.
Publicado: (2022)

Synthesis and Workability Behavior of Cu-X wt.% TiC (x = 0, 4, 8, and 12) Powder Metallurgy Composites
por: Mohanavel, V., et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_o4re5f10ad0pasvtobvjonosq7