Optimization of Taxol Extraction Process Using Response Surface Methodology and Investigation of Temporal and Spatial Distribution of Taxol in Taxus mairei

Taxus mairei is an important source for industrial extraction of taxol in China. However, the standard and steps of extraction are currently not uniform, which seriously affects the taxol yield. In the present study, the influence of four factors (methanol concentration, solid-liquid ratio, ultrasonic extraction temperature, and ultrasonic extraction time) on the taxol yield was successively explored in T. mairei. A response surface methodology (RSM) was used to optimize the extraction process based on the single-factor experiments above. The optimal conditions were as follows: methanol concentration was 90%, solid-liquid ratio was 1:15 (g/mL), ultrasonic extraction temperature was 40 °C and ultrasonic extraction time was 60 min. Moreover, the twigs and needles from T. mairei with different tree ages were treated by the optimum extraction process, which further revealed temporal and spatial distribution of taxol in the reproducible tissues. Interestingly, the taxol content was relatively higher in needles of T. ‘Jinxishan’ (a cultivar from T. mairei with yellow aril, FY), but was less in FY twigs. The accumulation of taxol in twigs and leaves of females (with red aril, FR) was significantly higher than that of males (M); however, the content showed a decreasing trend with the increasing tree ages. Therefore, it is suitable to increase the proportion of female trees especially the FY leaves as raw materials for the industrial production of taxol from T. mairei, and the tree ages should be better controlled at 3–7 years.