The Effect of Sn Addition on Zn-Al-Mg Alloy; Part II: Corrosion Behaviour

Corrosion behaviour of Sn (0.0, 0.5, 1.0, 2.0 and 3.0 wt.%)-doped Zn 1.6 wt.% Al 1.6 wt.% Mg alloys exposed to salt spray testing was investigated. Intergranular corrosion was observed for all alloys in both as-cast and annealed states. However, due to microstructure spheroidisation in the annealed...

Descripción completa

Detalles Bibliográficos
Autores principales: Gabalcová, Zuzana, Gogola, Peter, Kusý, Martin, Suchánek, Henrich
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2021
Materias:
Article
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8469453/
https://www.ncbi.nlm.nih.gov/pubmed/34576521
http://dx.doi.org/10.3390/ma14185290
Descripción
Sumario:Corrosion behaviour of Sn (0.0, 0.5, 1.0, 2.0 and 3.0 wt.%)-doped Zn 1.6 wt.% Al 1.6 wt.% Mg alloys exposed to salt spray testing was investigated. Intergranular corrosion was observed for all alloys in both as-cast and annealed states. However, due to microstructure spheroidisation in the annealed samples, potential intergranular corrosion paths are significantly reduced. Samples with 0.5 wt.% of Sn showed the best corrosion properties. The main corrosion products identified by XRD analysis for all samples were simonkolleite and hydrozincite. Occasionally, ZnO and AlO were identified in limited amounts.

Ejemplares similares