Cargando…

On the Structure and Properties of AlMgB(14)-TiB(2) Composites Obtained from SHS Powders by Spark Plasma Sintering

AlMgB(14)-TiB(2) composite materials were fabricated by self-propagating high-temperature synthesis (SHS) followed by spark plasma sintering of the obtained SHS products. It was found that, during the SHS, the AlMgB(14) phase is formed at a donor (Ti + 2B) to acceptor (Al(12)Mg(17)-B) mass ratio of...

Descripción completa

Detalles Bibliográficos
Autores principales:	Nikitin, Pavel, Zhukov, Ilya, Matveev, Aleksey, Sokolov, Sergei, Grigoriev, Mikhail, Vorozhtsov, Alexander
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8509751/ https://www.ncbi.nlm.nih.gov/pubmed/34639916 http://dx.doi.org/10.3390/ma14195521

Ejemplares similares

On the Tensile Strength of Spark Plasma Sintered AlMgB(14) Ceramics
por: Nikitin, Pavel, et al.
Publicado: (2022)

Phase Composition, Structure and Properties of the Spark Plasma Sintered Ceramics Obtained from the Al(12)Mg(17)-B-Si Powder Mixtures
por: Nikitin, Pavel, et al.
Publicado: (2022)

Experimental and Theoretical Study of Ultra-Hard AlMgB(14)-TiB(2) Composites: Structure, Hardness and Self-Lubricity
por: Nikitin, Pavel, et al.
Publicado: (2022)

Structure and Frictional Properties of Ultrahard AlMgB(14) Thin Coatings
por: Tkachev, Dmitrii, et al.
Publicado: (2023)

Effect of Mechanical Activation of Al-Ti-B Powder Mixture on Phase Composition and Structure of Al-TiB(2) Composite Materials Obtained by Self-Propagating High-Temperature Synthesis (SHS)
por: Matveev, Alexey, et al.
Publicado: (2022)

Processing and Characterization of Spark Plasma Sintered SiC-TiB(2)-TiC Powders
por: Grigoriev, Sergey N., et al.
Publicado: (2022)

Formation of TiB(2)–MgAl(2)O(4) Composites by SHS Metallurgy
por: Yeh, Chun-Liang, et al.
Publicado: (2023)

Effect of the Mass Fraction of NiTi–TiB(2) SHS-Particles on the Phase Composition, Structure, and Mechanical Properties of Inconel 625–NiTi–TiB(2) Composites Produced by Direct Laser Deposition
por: Matveev, Alexey, et al.
Publicado: (2022)

Hot Sliding Wear of 88 wt.% TiB–Ti Composite from SHS Produced Powders
por: Kumar, Rahul, et al.
Publicado: (2021)

Spark Plasma Sintering of Copper Matrix Composites Reinforced with TiB(2) Particles
por: Pellizzari, Massimo, et al.
Publicado: (2020)

Microstructure and Properties of TiB(2) Composites Produced by Spark Plasma Sintering with the Addition of Ti(5)Si(3)
por: Twardowska, Agnieszka, et al.
Publicado: (2021)

Structure, Properties and Phase Composition of Composite Materials Based on the System NiTi-TiB(2)
por: Promakhov, Vladimir, et al.
Publicado: (2022)

Effect of Additive Ti(3)SiC(2) Content on the Mechanical Properties of B(4)C–TiB(2) Composites Ceramics Sintered by Spark Plasma Sintering
por: Yan, Xingheng, et al.
Publicado: (2020)

p-n Control of AlMgB(14)-Based Thermoelectric Materials by Metal Site Occupancy
por: Fujima, Takuya, et al.
Publicado: (2019)

Preparation and Properties of Titanium Obtained by Spark Plasma Sintering of a Ti Powder–Fiber Mixture
por: Shi, Mingjun, et al.
Publicado: (2018)

Invar/WC Composite Compacts Obtained by Spark Plasma Sintering from Mechanically Alloyed Powders
por: Prica, Călin-Virgiliu, et al.
Publicado: (2022)

The Study of HEMs Based on the Mechanically Activated Intermetallic Al(12)Mg(17) Powder
por: Sokolov, Sergei, et al.
Publicado: (2020)

Microstructure, Mechanical Characteristics, and Wear Performance of Spark Plasma Sintered TiB(2)–Si(3)N(4) as Affected by B(4)N Doping
por: Ramesh, Balasubramanian, et al.
Publicado: (2022)

In Situ Ti6Al4V/TiB Composites Prepared by Hydrogen-Assisted Sintering of Blends Containing TiH(2) and Ball-Milled Ti+TiB(2) Powders
por: Song, Yuchao, et al.
Publicado: (2022)

TiB(2)-Based Composites for Ultra-High-Temperature Devices, Fabricated by SHS, Combining Strong and Weak Exothermic Reactions
por: Ziemnicka-Sylwester, Marta
Publicado: (2013)

Hard and Highly Adhesive AlMgB(14) Coatings RF Sputtered on Tungsten Carbide and High-Speed Steel
por: Grishin, Alexander M., et al.
Publicado: (2023)

In-Situ Synthesis, Microstructure, and Mechanical Properties of TiB(2)-Reinforced Fe-Cr-Mn-Al Steel Matrix Composites Prepared by Spark Plasma Sintering
por: Liu, Jian, et al.
Publicado: (2021)

Planetary Milling and Self-Propagating High-Temperature Synthesis of Al-TiB(2) Composites
por: Matveev, Alexey, et al.
Publicado: (2020)

Fabrication of Fe-Si-B Based Amorphous Powder Cores by Spark Plasma Sintered and Their Magnetic Properties
por: Yan, Liang, et al.
Publicado: (2022)

Sintering, Mechanical and Optical Properties of TiB(2) Composites with and without High-Energy Milling
por: Taraborelli, Simone, et al.
Publicado: (2023)

Effect of TiB(2) Nanoparticle Content on the Microstructure and Mechanical Properties of TiB(2)/Mg-4Al-1.5Si Composites
por: Liu, Jian, et al.
Publicado: (2023)

Properties of PBZTS Ferroelectric Ceramics Obtained Using Spark Plasma Sintering
por: Brzezińska, Dagmara, et al.
Publicado: (2023)

Synthesis of Dense MgB(2) Superconductor via In Situ and Ex Situ Spark Plasma Sintering Method
por: Dadiel, Joseph Longji, et al.
Publicado: (2021)

High Critical Current Density of Nanostructured MgB(2) Bulk Superconductor Densified by Spark Plasma Sintering
por: Xing, Yiteng, et al.
Publicado: (2022)

Calculation of Volume Fractions of In Situ TiB and Residual Stress Distributions in Functionally Graded Composite of Ti–TiB–TiB(2)
por: Zhang, Youfeng, et al.
Publicado: (2019)

Influence of Cryomilling on Crystallite Size of Aluminum Powder and Spark Plasma Sintered Component
por: Kushwaha, Amanendra K., et al.
Publicado: (2022)

Bulks of Al-B-C obtained by reactively spark plasma sintering and impact properties by Split Hopkinson Pressure Bar
por: Vasylkiv, O., et al.
Publicado: (2019)

Reaction Sintering of Machinable TiB(2)-BN-C Ceramics with In-Situ Formed h-BN Nanostructure
por: Popov, Oleksii, et al.
Publicado: (2022)

ZrB(2)-CNTs Nanocomposites Fabricated by Spark Plasma Sintering
por: Jin, Hua, et al.
Publicado: (2016)

Spark Plasma Sintering of Commercial Zirconium Carbide Powders: Densification Behavior and Mechanical Properties
por: Wei, Xialu, et al.
Publicado: (2015)

Effect of Short Attritor-Milling of Magnesium Alloy Powder Prior to Spark Plasma Sintering
por: Minárik, Peter, et al.
Publicado: (2020)

Mechanical Alloying and Electrical Current-Assisted Sintering Adopted for In Situ Ti-TiB Metal Matrix Composite Processing
por: Miklaszewski, Andrzej, et al.
Publicado: (2019)

Nanostructure and nanoindentation study of pulse electric-current sintered TiB(2)–SiC–C(f) composite
por: Shokouhimehr, Mohammadreza, et al.
Publicado: (2023)

Investigation of the Densification Behavior of Alumina during Spark Plasma Sintering
por: Boldin, Maksim S., et al.
Publicado: (2022)

SHS-Derived Powders by Reactions’ Coupling as Primary Products for Subsequent Consolidation
por: Aydinyan, Sofiya, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_1ru6kc5ucb45jpmspjtpp1e42d