Use of two vertical injectors in place of a horizontal injector to improve the efficiency and stability of THAI in situ combustion process for producing heavy oils

The current commercial technologies used to produce heavy oils and bitumen are carbon-, energy-, and wastewater-intensive. These make them to be out of line with the global efforts of decarbonisation. Alternative processes such as the toe-to-heel air injection (THAI) that works as an in situ combustion process that uses horizontal producer well to recover partially upgraded oil from heavy oils and bitumen reservoirs are needed. However, THAI is yet to be technically and economically well proven despite pilot and semi-commercial operations. Some studies concluded using field data that THAI is a low-oil-production-rate process. However, no study has thoroughly investigated the simultaneous effects of start-up methods and wells configuration on both the short and long terms stability, sustainability, and profitability of the process. Using THAI validated model, three models having a horizontal producer well arranged in staggered line drive with the injector wells are simulated using CMG STARS. Model A has two vertical injectors via which steam was used for pre-ignition heating, and models B and C each has a horizontal injector via which electrical heater and steam were respectively used for pre-ignition heating. It is found that during start-up, ultimately, steam injection instead of electrical heating should be used for the pre-ignition heating. Clearly, it is shown that model A has higher oil production rates after the increase in air flux and also has a higher cumulative oil recovery of 2350 cm(3) which is greater than those of models B and C by 9.6% and 4.3% respectively. Thus, it can be concluded that for long-term projects, model A settings and wells configuration should be used. Although it is now discovered that the peak temperature cannot in all settings tell how healthy a combustion front is, it has revealed that model A does indeed have far more stable, safer, and efficient combustion front burning quality and propagation due to the maintenance of very high peak temperatures of mostly greater than 600 °C and very low concentrations of produced oxygen of lower than 0.4 mol% compared to up to 2.75 mol% in model C and 1 mol% in model B. Conclusively, since drilling of, and achieving uniform air distribution in horizontal injector (HI) well in actual field reservoir are costly and impracticable at the moment, and that electrical heating will require unphysically long time before mobilised fluids reach the HP well as heat transfer is mainly by conduction, these findings have shown decisively that the easy-and-cheaper-to-drill two vertical injector wells configured in a staggered line drive pattern with the horizontal producer should be used, and steam is thus to be used for pre-ignition heating.