Cargando…

Influence of C and N on Strain-Induced Martensite Formation in Fe-15Cr-7Mn-4Ni-0.5Si Austenitic Steel

In this study, the effect of interstitial contents on the mechanical properties and strain-induced martensite formation in an austenitic stainless steel was investigated. The mechanical properties of solution annealed Fe-15Cr-7Mn-4Ni-0.5Si-(0.01-0.2)N-(0.01-0.2)C concentrations in weight percent sta...

Descripción completa

Detalles Bibliográficos
Autores principales:	Quitzke, Caroline, Huang, Qiuliang, Biermann, Horst, Volkova, Olena, Wendler, Marco
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8585315/ https://www.ncbi.nlm.nih.gov/pubmed/34772027 http://dx.doi.org/10.3390/ma14216502

Ejemplares similares

Deformation behavior of duplex austenite and ε-martensite high-Mn steel
por: Kwon, Ki Hyuk, et al.
Publicado: (2013)

Stress-induced detwinning and martensite transformation in an austenite Ni–Mn–Ga alloy with martensite cluster under uniaxial loading
por: Hou, Long, et al.
Publicado: (2019)

Steel forgings for pressure purposes - Part 5: martensitic, austenitic and austenitic-ferritic stainless steels
por: Association Française de Normalisation. Paris
Publicado: (2000)

Advantageous Implications of Reversed Austenite for the Tensile Properties of Super 13Cr Martensitic Stainless Steel
por: Wang, Peng, et al.
Publicado: (2022)

Microstructural Constituents and Mechanical Properties of Low-Density Fe-Cr-Ni-Mn-Al-C Stainless Steels
por: Scherbring, Steffen, et al.
Publicado: (2022)

Corrosion Behavior of High-Mn Austenitic Fe–Mn–Al–Cr–C Steels in NaCl and NaOH Solutions
por: Bosch, Juan, et al.
Publicado: (2021)

Effect of Cu on the Formation of Reversed Austenite in Super Martensitic Stainless Steel
por: Jiang, Wen, et al.
Publicado: (2023)

Effects of Austenitization Temperature and Pre-Deformation on CCT Diagrams of 23MnNiCrMo5-3 Steel
por: Schindler, Ivo, et al.
Publicado: (2020)

Data on Cu- and Ni-Si-Mn-rich solute clustering in a neutron irradiated austenitic stainless steel
por: Levine, Samara M., et al.
Publicado: (2022)

Effects of Austenitizing Temperature on Tensile and Impact Properties of a Martensitic Stainless Steel Containing Metastable Retained Austenite
por: Deng, Biao, et al.
Publicado: (2021)

Critical Redistribution of Nitrogen in the Austenitic Cr-Mn Steel under Severe Plastic Deformation
por: Shabashov, Valery, et al.
Publicado: (2021)

Simulation of an Austenite-Twinned-Martensite Interface
por: Kearsley, A.J., et al.
Publicado: (2003)

EPMA quantification on the chemical composition of retained austenite in a Fe-Mn-Si-C-based multi-phase steel
por: Heo, Yoon-Uk, et al.
Publicado: (2022)

High-Temperature Oxidation Behaviour of CrSi Coatings on 316 Austenitic Stainless Steel
por: Gurtaran, Mikdat, et al.
Publicado: (2023)

The Intergranular Corrosion Susceptibility of Metastable Austenitic Cr–Mn–Ni–N–Cu High-Strength Stainless Steel under Various Heat Treatments
por: Liu, Guangming, et al.
Publicado: (2019)

Molecular dynamics exploration of helium bubble nucleation and growth mechanisms in Fe(70)Ni(11)Cr(19) austenitic stainless steel
por: Zhou, X. W.
Publicado: (2023)

Influence of solidification structure on austenite to martensite transformation in additively manufactured hot-work tool steels
por: Chou, Chia-Ying, et al.
Publicado: (2021)

Nanoscale twinning in Fe–Mn–Al–Ni martensite: a backscatter Kikuchi diffraction study
por: Fischer, Peter D. B., et al.
Publicado: (2021)

Relationship between Microstructure and Corrosion Behavior of Martensitic High Nitrogen Stainless Steel 30Cr15Mo1N at Different Austenitizing Temperatures
por: Jiang, Zhouhua, et al.
Publicado: (2017)

Microstructure Evolution at Ni/Fe Interface in Dissimilar Metal Weld between Ferritic Steel and Austenitic Stainless Steel
por: Li, Xiaogang, et al.
Publicado: (2023)

The Formation of Crystal Defects in a Fe-Mn-Si Alloy Under Cyclic Martensitic Transformations
por: Bondar, Vladimir I., et al.
Publicado: (2016)

Investigation of Parent Austenite Grains from Martensite Structure Using EBSD in a Wear Resistant Steel
por: Gyhlesten Back, Jessica, et al.
Publicado: (2017)

Controllable Martensite Transformation and Strain-Controlled Fatigue Behavior of a Gradient Nanostructured Austenite Stainless Steel
por: Lei, Yunbo, et al.
Publicado: (2021)

Dilatometric and Microstructural Study of Martensite Tempering in 4% Mn Steel
por: Grajcar, Adam, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of the 6 wt% Mn-Doped Martensitic Steel Strengthened by Cu/NiAl Nanoparticles
por: Jiang, Yan, et al.
Publicado: (2022)

Effects of Mn content on austenite stability and mechanical properties of low Ni alumina-forming austenitic heat-resistant steel: a first-principles study
por: Zhao, Yanjun, et al.
Publicado: (2023)

Kinetics of Austenite Decomposition in 54SiCr6 Steel during Continuous Slow Cooling Conditions
por: Gokhman, Aleksandr, et al.
Publicado: (2023)

Effect of Metallic Coatings on the Wear Performance and Mechanism of 30CrMnSiNi2A Steel
por: Zu, Huicheng, et al.
Publicado: (2023)

Improved Mechanical and Corrosion Properties of Powder Metallurgy Austenitic, Ferritic, and Martensitic Stainless Steels by Liquid Phase Sintering
por: Ku, Ming-Hsiang, et al.
Publicado: (2022)

Tracer diffusion in single crystalline CoCrFeNi and CoCrFeMnNi high entropy alloys
por: Gaertner, Daniel, et al.
Publicado: (2018)

The Effect of the In-Situ Heat Treatment on the Martensitic Transformation and Specific Properties of the Fe-Mn-Si-Cr Shape Memory Alloys Processed by HSHPT Severe Plastic Deformation
por: Gurau, Carmela, et al.
Publicado: (2021)

Prediction of the Non-Isothermal Austenitization Kinetics of Fe-C-Cr Low Alloy Steels with Lamellar Pearlite Microstructure
por: Li, Zhiqiang, et al.
Publicado: (2022)

Effect of Al Additions and Cooling Rate on the Microstructure and Mechanical Properties of Austenite FeMnAlC Steels
por: Wang, Cunyu, et al.
Publicado: (2022)

Corrosion Behavior of CrFeCoNiV(0.5) and CrFeCoNiV Alloys in 0.5 M and 1 M Sodium Chloride Solutions
por: Tsau, Chun-Huei, et al.
Publicado: (2023)

Improving the Shape Memory Effect of a Fe-Mn-Si-Cr-Ni Alloy through Shot Peening
por: Yang, Huanping, et al.
Publicado: (2022)

Composition and Structure of NiCoFeCr and NiCoFeCrMn High-Entropy Alloys Irradiated by Helium Ions
por: Amanzhulov, Bauyrzhan, et al.
Publicado: (2023)

Austenite Grain Growth Analysis in a Welded Joint of High-Strength Martensitic Abrasion-Resistant Steel Hardox 450
por: Konat, Łukasz, et al.
Publicado: (2021)

A machine learning aided interpretable model for rupture strength prediction in Fe-based martensitic and austenitic alloys
por: Mamun, Osman, et al.
Publicado: (2021)

Grain boundary decohesion by nanoclustering Ni and Cr separately in CrMnFeCoNi high-entropy alloys
por: Ming, Kaisheng, et al.
Publicado: (2019)

Unraveling the Phase Stability and Physical Property of Modulated Martensite in Ni(2)Mn(1.5)In(0.5) Alloys by First-Principles Calculations
por: Liang, Xin-Zeng, et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_7e4pdumnrhjjcprmub8akf1gfj