Cargando…

Sliding Wear Performance of AlCrN Coating on TiB(2)/Ti Composites at High Temperatures

The aim of the study was to investigate effect of Ti/TiB(2) composite composition and manufacturing technology parameters on the tribological behaviour of AlCrN coating-composite system. The AlCrN coating was deposited by PVD (Physical Vapour Deposition) method. The composites were manufactured by s...

Descripción completa

Detalles Bibliográficos
Autores principales:	Michalczewski, Remigiusz, Kalbarczyk, Marek, Słomka, Zbigniew, Osuch-Słomka, Edyta, Łuszcz, Maciej, Liu, Le, Antonov, Maksim, Hussainova, Irina
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8619542/ https://www.ncbi.nlm.nih.gov/pubmed/34832177 http://dx.doi.org/10.3390/ma14226771

Ejemplares similares

Hot Sliding Wear of 88 wt.% TiB–Ti Composite from SHS Produced Powders
por: Kumar, Rahul, et al.
Publicado: (2021)

Abrasive Wear, Scuffing and Rolling Contact Fatigue of DLC-Coated 18CrNiMo7-6 Steel Lubricated by a Pure and Contaminated Gear Oil
por: Tuszyński, Waldemar, et al.
Publicado: (2021)

Improvement of Tribological Performance of TiAlNbN Hard Coatings by Adding AlCrN
por: Chang, Yin-Yu, et al.
Publicado: (2022)

Effect of AISI H13 Steel Substrate Nitriding on AlCrN, ZrN, TiSiN, and TiCrN Multilayer PVD Coatings Wear and Friction Behaviors at a Different Temperature Level
por: Özkan, Doğuş, et al.
Publicado: (2023)

Calculation of Volume Fractions of In Situ TiB and Residual Stress Distributions in Functionally Graded Composite of Ti–TiB–TiB(2)
por: Zhang, Youfeng, et al.
Publicado: (2019)

Effect of Boron and Vanadium Addition on Friction-Wear Properties of the Coating AlCrN for Special Applications
por: Nguyen, Huu Chien, et al.
Publicado: (2021)

Corrosion and wear behaviour of highly porous Ti-TiB-TiN(x) in situ composites in simulated physiological solution
por: TOPTAN, Fatih
Publicado: (2020)

Effects of Cr and Zr Addition on Microstructures, Compressive Properties, and Abrasive Wear Behaviors of In Situ TiB(2)/Cu Cermets
por: Qiu, Feng, et al.
Publicado: (2018)

Investigation of the Wear Performance of TiB(2) Coated Cutting Tools during the Machining of Ti6Al4V Alloy
por: Chowdhury, Mohammad Shariful Islam, et al.
Publicado: (2021)

Effect of VN and TiB(2)-TiC(x) Reinforcement on Wear Behavior of Al 7075-Based Composites
por: Bai, Yaping, et al.
Publicado: (2021)

Microstructure and Properties of CoCrNi/Nano-TiC/Micro-TiB2 Composite Coatings Prepared via Laser Cladding
por: Liu, He, et al.
Publicado: (2023)

In situ controlled rapid growth of novel high activity TiB(2)/(TiB(2)–TiN) hierarchical/heterostructured nanocomposites
por: Wang, Jilin, et al.
Publicado: (2017)

Sliding Wear Behavior of Intermetallic Ti-45Al-2Nb-2Mn-(at%)-0.8vol%TiB(2) Processed by Centrifugal Casting and Hot Isostatic Pressure: Influence of Microstructure
por: Shagñay, Segundo, et al.
Publicado: (2022)

Preparation and Characterization of In Situ (TiC-TiB(2))/Al-Cu-Mg-Si Composites with High Strength and Wear Resistance
por: Gao, Yu-Yang, et al.
Publicado: (2022)

In Situ Ti6Al4V/TiB Composites Prepared by Hydrogen-Assisted Sintering of Blends Containing TiH(2) and Ball-Milled Ti+TiB(2) Powders
por: Song, Yuchao, et al.
Publicado: (2022)

Influence of W Addition on Microstructure and Resistance to Brittle Cracking of TiB(2) Coatings Deposited by DCMS
por: Chudzik-Poliszak, Edyta, et al.
Publicado: (2021)

Effects of TiB(2) Particles on the Microstructure Evolution and Mechanical Properties of B(4)C/TiB(2) Ceramic Composite
por: Niu, Haiyan, et al.
Publicado: (2021)

Crystallographic and electronic properties of AlCrN films that absorb visible light
por: Tatemizo, N., et al.
Publicado: (2017)

Removal Mechanism and Electrochemical Milling of (TiB+TiC)/TC4 Composites
por: Fan, Shukai, et al.
Publicado: (2022)

Tribo-Mechanical Properties of HVOF Deposited Fe(3)Al Coatings Reinforced with TiB(2) Particles for Wear-Resistant Applications
por: Amiriyan, Mahdi, et al.
Publicado: (2016)

Effect of TiB Orientation on Near-Threshold Fatigue Crack Propagation in TiB-Reinforced Ti-3Al-2.5V Matrix Composites Treated with Heat Extrusion
por: Kikuchi, Shoichi, et al.
Publicado: (2019)

Effect of TiB(2) Nanoparticle Content on the Microstructure and Mechanical Properties of TiB(2)/Mg-4Al-1.5Si Composites
por: Liu, Jian, et al.
Publicado: (2023)

Effect of the Mass Fraction of NiTi–TiB(2) SHS-Particles on the Phase Composition, Structure, and Mechanical Properties of Inconel 625–NiTi–TiB(2) Composites Produced by Direct Laser Deposition
por: Matveev, Alexey, et al.
Publicado: (2022)

Fabrication and Characterization of In Situ Zn-TiB(2) Nanocomposite
por: Guan, Zeyi, et al.
Publicado: (2020)

Thermomechanical Processing of a Near-α Ti Matrix Composite Reinforced by TiB(w)
por: Feng, Hong, et al.
Publicado: (2020)

Evaluation of Usefulness of AlCrN Coatings for Increased Life of Tools Used in Friction Stir Welding (FSW) of Sheet Aluminum Alloy
por: Lacki, Piotr, et al.
Publicado: (2020)

Study of PVD AlCrN Coating for Reducing Carbide Cutting Tool Deterioration in the Machining of Titanium Alloys
por: Cadena, Natalia L., et al.
Publicado: (2013)

Adhesive assisted TiB(2) coating effects on friction stir welded joints
por: Kundu, Amit Kumar, et al.
Publicado: (2022)

Hard Wear-Resistant Ti-Si-C Coatings for Cu-Cr Electrical Contacts
por: Kiryukhantsev-Korneev, Ph., et al.
Publicado: (2023)

Morphological Evolution of TiB(2) and TiAl(3) in Al–Ti–B Master Alloy Using Different Ti Adding Routes
por: Zhao, Yanjun, et al.
Publicado: (2022)

Effects of Aluminum Addition on Microstructure and Properties of TiC-TiB(2)/Fe Coatings In Situ Synthesized by TIG Cladding
por: Ma, Ning, et al.
Publicado: (2023)

Fabrication of TiC(x)-TiB(2)/Al Composites for Application as a Heat Sink
por: Shu, Shili, et al.
Publicado: (2016)

Processing and Characterization of Spark Plasma Sintered SiC-TiB(2)-TiC Powders
por: Grigoriev, Sergey N., et al.
Publicado: (2022)

Structure, Properties and Phase Composition of Composite Materials Based on the System NiTi-TiB(2)
por: Promakhov, Vladimir, et al.
Publicado: (2022)

Wear Behavior of Fiber Laser Textured TiN Coatings in a Heavy Loaded Sliding Regime
por: Vandoni, Laura, et al.
Publicado: (2012)

Quantifying Cutting and Wearing Behaviors of TiN- and CrN-Coated AISI 1070 Steel
por: Cakan, Ahmet, et al.
Publicado: (2008)

Effect of High-Pressure Torsion on Structure and Properties of Ti-15Mo/TiB Metal-Matrix Composite
por: Zherebtsov, Sergey, et al.
Publicado: (2018)

Evolution of the Strengthening Effects of In Situ TiB Fibers in a Ti Composite with Various Levels of Thermal Processing
por: Zhao, Peifeng, et al.
Publicado: (2023)

Comparative Investigations of AlCrN Coatings Formed by Cathodic Arc Evaporation under Different Nitrogen Pressure or Arc Current
por: Gilewicz, Adam, et al.
Publicado: (2021)

Improved Strength-Ductility of Ti-6Al-4V Casting Alloys with Trace Addition of TiC-TiB(2) Nanoparticles
por: Zhu, Yunlong, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_f99lda4p8g230o6dag2316g7hn