Cargando…

Regularities of Structure Formation in 30 mm Rods of Thermoelectric Material during Hot Extrusion

In this study, Ingots of (Bi, Sb)(2)Te(3) thermoelectric material with p-type conductivity have been obtained by hot extrusion. The main regularities of hot extrusion of 30 mm rods have been analyzed with the aid of a mathematical simulation on the basis of the joint use of elastic-plastic body appr...

Descripción completa

Detalles Bibliográficos
Autores principales: Lavrentev, Mikhail G., Bublik, Vladimir T., Milovich, Filipp O., Panchenko, Viktoriya P., Parkhomenko, Yuri N., Prostomolotov, Anatoly I., Tabachkova, Nataliya Yu., Verezub, Nataliya A., Voronov, Mikhail V., Yarkov, Ivan Yu.
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2021
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8621126/
https://www.ncbi.nlm.nih.gov/pubmed/34832459
http://dx.doi.org/10.3390/ma14227059
Descripción
Sumario:In this study, Ingots of (Bi, Sb)(2)Te(3) thermoelectric material with p-type conductivity have been obtained by hot extrusion. The main regularities of hot extrusion of 30 mm rods have been analyzed with the aid of a mathematical simulation on the basis of the joint use of elastic-plastic body approximations. The phase composition, texture and microstructure of the (Bi, Sb)(2)Te(3) solid solutions have been studied using X-ray diffraction and scanning electron microscopy. The thermoelectric properties have been studied using the Harman method. We show that extrusion through a 30 mm diameter die produces a homogeneous strain. The extruded specimens exhibit a fine-grained structure and a clear axial texture in which the cleavage planes are parallel to the extrusion axis. The quantity of defects in the grains of the (Bi, Sb)(2)Te(3) thermoelectric material decreases with an increase in the extrusion rate. An increase in the extrusion temperature leads to a decrease in the Seebeck coefficient and an increase in the electrical conductivity. The specimens extruded at 450 °C and a 0.5 mm/min extrusion rate have the highest thermoelectric figure of merit (Z = 3.2 × 10(−3) K(−1)).