Cargando…

Tribo-oxide Competition and Oxide Layer Formation of Ti(3)SiC(2)/CaF(2) Self-Lubricating Composites during the Friction Process in a Wide Temperature Range

Ti(3)SiC(2)/CaF(2) composites were prepared by the spark plasma sintering (SPS) process. Both the microstructure of Ti(3)SiC(2)/CaF(2) and the influence of test temperature on the tribological behavior of the Ti(3)SiC(2)/CaF(2) composites were investigated. The synergistic effect of friction and oxi...

Descripción completa

Detalles Bibliográficos
Autores principales:	Zhang, Rui, Feng, Wei, Liu, Fuyan
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8658893/ https://www.ncbi.nlm.nih.gov/pubmed/34885621 http://dx.doi.org/10.3390/ma14237466

Ejemplares similares

Synthesis of CaF(2) Nanoparticles Coated by SiO(2) for Improved Al(2)O(3)/TiC Self-Lubricating Ceramic Composites
por: Chen, Zhaoqiang, et al.
Publicado: (2019)

Addition of Nano CaF(2)@SiO(2) and SiC Whiskers in Ceramic Tools for Wear Reduction and Improved Machinability
por: Zhang, Wenhao, et al.
Publicado: (2022)

C(0.3)N(0.7)Ti-SiC Toughed Silicon Nitride Hybrids with Non-Oxide Additives Ti(3)SiC(2)
por: Luo, Heng, et al.
Publicado: (2020)

Friction and lubrication
por: Bowden, Frank Philip, et al.
Publicado: (1956)

Influence of CaF(2)@Al(2)O(3) on Cutting Performance and Wear Mechanism of Al(2)O(3)/Ti(C,N)/CaF(2)@Al(2)O(3) Self-Lubricating Ceramic Tools in Turning
por: Zhang, Shuai, et al.
Publicado: (2020)

Oxidation Resistance of a Si–TiSi(2)–MoSi(2)–TiB(2)–CaSi(2) Coating on a C(f)/C–SiC Substrate in High-Speed High-Enthalpy Air Plasma Flows
por: Astapov, Alexey, et al.
Publicado: (2021)

SiC/MoSi(2)-SiC-Si Oxidation Protective Coatings for HTR Graphite Spheres with Residual Si Optimized
por: Wei, Xiaoyu, et al.
Publicado: (2022)

Microstructure and Tribological Properties of Spark-Plasma-Sintered Ti(3)SiC(2)-Pb-Ag Composites at Elevated Temperatures
por: Zhang, Rui, et al.
Publicado: (2022)

Synthesis and Mechanical Characterization of a Ti(C,N)/Mo–Co–Ni/CaF(2)@Al(2)O(3) Self-Lubricating Cermet
por: Li, Chuanhao, et al.
Publicado: (2019)

The friction and lubrication of solids
por: Bowden, Frank Philip, et al.
Publicado: (1950)

Radiation-Induced Nucleation and Growth of CaSi(2) Crystals, Both Directly during the Epitaxial CaF(2) Growth and after the CaF(2) Film Formation
por: Dvurechenskii, Anatoly V., et al.
Publicado: (2022)

Tribo-mechanical properties evaluation of HA/TiO(2)/CNT nanocomposite
por: Zalnezhad, Erfan, et al.
Publicado: (2021)

Characterization of Wear Properties of Pure Nickel Modified by Ni-Cr Composite and CaF(2) Solid Lubricant Addition
por: Kotkowiak, Mateusz, et al.
Publicado: (2022)

SiC-IrSi(3) for High Oxidation Resistance
por: Camarano, Antonio, et al.
Publicado: (2019)

Synthesis of Ti(3)SiC(2) Phases and Consolidation of MAX/SiC Composites—Microstructure and Mechanical Properties
por: Wozniak, Jaroslaw, et al.
Publicado: (2023)

Lubricated friction around nanodefects
por: Cafolla, Clodomiro, et al.
Publicado: (2020)

Influence of Oxidation Damages on Mechanical Properties of SiC/SiC Composite Using Domestic Hi-Nicalon Type SiC Fibers
por: Jin, Enze, et al.
Publicado: (2020)

Understanding friction mechanisms of Si-DLC/steel interfaces under aqueous lubrication
por: Lanigan, J. L., et al.
Publicado: (2023)

Microstructure and Mechanical Properties of Composites Obtained by Spark Plasma Sintering of Ti(3)SiC(2)-15 vol.%Cu Mixtures
por: Zhang, Rui, et al.
Publicado: (2022)

The Conditions Necessary for the Formation of Dissipative Structures in Tribo-Films on Friction Surfaces That Decrease the Wear Rate
por: Gershman, Iosif S., et al.
Publicado: (2023)

Low Friction of Graphene Oxide Aggregates in Lubricant Oil between a Steel Ball and Glass Disk under Boundary Lubrication
por: Kinoshita, Hiroshi, et al.
Publicado: (2022)

Effects of TiC, Si, and Al on Combustion Synthesis of Ti(3)SiC(2)/TiC/Ti(5)Si(3) Composites
por: Yeh, Chun-Liang, et al.
Publicado: (2023)

Study on Lubrication and Friction Reduction Properties of ZIF-8 Nanoparticles as Si(3)N(4) Ceramic Water Lubrication Additives
por: Sui, Tianyi, et al.
Publicado: (2021)

Friction wear lubrication: tribology handbook
por: Kragelsky, I V, et al.
Publicado: (1982)

Wear Behaviour of ZA27/SiC/Graphite Composites under Lubricated Sliding Conditions
por: Miloradović, Nenad, et al.
Publicado: (2020)

Investigation of oxidation mechanism of SiC single crystal for plasma electrochemical oxidation
por: Yin, Xincheng, et al.
Publicado: (2021)

Effect of Ti(3)SiC(2) and Ti(3)AlC(2) Particles on Microstructure and Wear Resistance of Microarc Oxidation Layers on TC4 Alloy
por: Gu, Gaoyang, et al.
Publicado: (2022)

Oxidation Behavior of Tyranno ZMI-SiC Fiber/SiC-SiBC Matrix Composite from 800 to 1200 °C
por: Zhao, Donglin, et al.
Publicado: (2018)

Effect of different oxide thickness on the bending Young’s modulus of SiO(2)@SiC nanowires
por: Ma, Jinyao, et al.
Publicado: (2016)

Comparative Study on Micro-Grinding Performance of 2.5D C(f)/SiCs, 2.5D SiC(f)/SiCs, and SiC Ceramics
por: Wen, Quan, et al.
Publicado: (2023)

Proliferation and osteogenic differentiation of rat BMSCs on a novel Ti/SiC metal matrix nanocomposite modified by friction stir processing
por: Zhu, Chenyuan, et al.
Publicado: (2016)

Effects of the surface processing on the tribological performance of C/SiCs under dry friction
por: Lin, Bin, et al.
Publicado: (2020)

Influence of High-Temperature Oxidation and Test Conditions on the Dynamic Mechanical Properties of 2.5D SiC(f)/SiC(m) Composites
por: Yang, Chenxi, et al.
Publicado: (2020)

Sintering and Mechanical Properties of (SiC + TiC(x))(p)/Fe Composites Synthesized from Ti(3)AlC(2), SiC, and Fe Powders
por: Wang, Mingtao, et al.
Publicado: (2021)

In Situ Construction of TiC-Ti(3)SiC(2) Gradient Hybrid Interphase Coated SiC Fibers for Suppression of Specular Reflection and Non-Specular Scattering
por: Yang, Haitang, et al.
Publicado: (2022)

First-Principles Study of Vacancies in Ti(3)SiC(2) and Ti(3)AlC(2)
por: Wang, Hui, et al.
Publicado: (2017)

Processing and Characterization of Spark Plasma Sintered SiC-TiB(2)-TiC Powders
por: Grigoriev, Sergey N., et al.
Publicado: (2022)

The Influence of Ball Burnishing on Friction in Lubricated Sliding
por: Swirad, Slawomir, et al.
Publicado: (2020)

Ultralow Interlayer Friction of Layered Electride Ca(2)N: A Potential Two-Dimensional Solid Lubricant Material
por: Wang, Jianjun, et al.
Publicado: (2018)

Friction Stir Processing of Copper-Coated SiC Particulate-Reinforced Aluminum Matrix Composite
por: Huang, Chih-Wei, et al.
Publicado: (2018)

Cannot write session to /tmp/vufind_sessions/sess_mmvfqmag3sg4ku2cgs709noknp