Cargando…

Experimental and Numerical Investigations on High Performance SFRC: Cyclic Tensile Loading and Fatigue

In the present study, the capability of high-strength short steel fibers to control the degradation in high-performance concrete was experimentally examined and numerically simulated. To this end, notched prismatic high-performance concrete specimens with (HPSFRC) and without (HPC) short steel fiber...

Descripción completa

Detalles Bibliográficos
Autores principales:	Schäfer, Niklas, Gudžulić, Vladislav, Breitenbücher, Rolf, Meschke, Günther
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2021
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8705799/ https://www.ncbi.nlm.nih.gov/pubmed/34947187 http://dx.doi.org/10.3390/ma14247593

Ejemplares similares

Numerical and FEA investigation of sectional capacity and moment redistribution behavior of steel fiber reinforced concrete (SFRC) beam
por: Shewalul, Yohannes Werkina
Publicado: (2021)

The Development of Controlled Orientation of Fibres in SFRC
por: Ďubek, Marek, et al.
Publicado: (2021)

Fatigue Performance of a Step-Lap Joint under Tensile Load: A Numerical Study
por: Demiral, Murat, et al.
Publicado: (2023)

Experimental and Numerical Investigation of Intact, Defective and Repaired Countersunk Composite Joints under Tensile Loading
por: Huang, Yongjie, et al.
Publicado: (2022)

Relation between Shear Stresses and Flexural Tensile Stresses from Standardized Tests of Extracted Prismatic Specimens of an SFRC Bridge Girder
por: Quiroga Flores, Alfredo, et al.
Publicado: (2022)

Effect of the Microsand Fraction on the Ballistic Resistance of UHP-SFRC
por: Kheml, Přemysl, et al.
Publicado: (2022)

Cementitious Composites with High Compaction Potential: Modeling and Calibration
por: Vu, Giao, et al.
Publicado: (2020)

Experimental and Numerical Investigation of Tensile and Flexural Behavior of Nanoclay Wood-Plastic Composite
por: Golmakani, Mohammad E., et al.
Publicado: (2021)

Numerical Study on the Fatigue Limit of Metallic Glasses under Cyclic Tension-Compression Loading
por: Yan, Jinfeng, et al.
Publicado: (2020)

Behavior Study of Commercial Polyurea under Monotonic, Rate Dependent, Cyclic, and Fatigue Tensile Loading for Potential Structural Applications
por: Acharya, Pawan, et al.
Publicado: (2022)

Study on Adaptability of Test Methods for Workability of Fresh Self-Compacting SFRC
por: Ding, Xinxin, et al.
Publicado: (2021)

The Effect of Weld Reinforcement and Post-Welding Cooling Cycles on Fatigue Strength of Butt-Welded Joints under Cyclic Tensile Loading
por: Araque, Oscar, et al.
Publicado: (2018)

Lightweight SFRC Benefitting from a Pre-Soaking and Internal Curing Process
por: Hornakova, Marie, et al.
Publicado: (2019)

Shrinkage and Mechanical Properties of Self-Compacting SFRC With Calcium-Sulfoaluminate Expansive Agent
por: Li, Changyong, et al.
Publicado: (2020)

Study on Axial Tensile Strain Rate Effect on Concrete Based on Experimental Investigation and Numerical Simulation
por: Sun, Bi, et al.
Publicado: (2022)

Mechanical Properties of GFRPs Exposed to Tensile, Compression and Tensile–Tensile Cyclic Tests
por: Stanciu, Mariana Domnica, et al.
Publicado: (2021)

Inverse Method to Determine Fatigue Properties of Materials by Combining Cyclic Indentation and Numerical Simulation
por: Sajjad, Hafiz Muhammad, et al.
Publicado: (2020)

Experimental and numerical investigation of the fatigue behaviour and crack evolution mechanism of granite under ultra-high-frequency loading
por: Zhou, Yu, et al.
Publicado: (2020)

Ratcheting Strain and Microstructure Evolution of AZ31B Magnesium Alloy under a Tensile-Tensile Cyclic Loading
por: Yan, Zhifeng, et al.
Publicado: (2018)

Numerical Investigation of the Performance of Segmental CFST Piers with External Energy Dissipators under Lateral Cyclic Loadings
por: Wang, Chengquan, et al.
Publicado: (2022)

Fundamental Investigations of Bond Behaviour of High-Strength Micro Steel Fibres in Ultra-High Performance Concrete under Cyclic Tensile Loading
por: Lanwer, Jan-Paul, et al.
Publicado: (2021)

Experimental and numerical modeling approach for thermomechanical low cycle fatigue analysis of cyclically non-stabilized steels
por: Egner, Władysław, et al.
Publicado: (2021)

A Comprehensive Analysis of the Use of SFRC in Structures and Its Current State of Development in the Construction Industry
por: Vijayan, Dhanasingh Sivalinga, et al.
Publicado: (2022)

Experimental and Numerical Study on Tensile Strength of Concrete under Different Strain Rates
por: Min, Fanlu, et al.
Publicado: (2014)

Micro-Scale Numerical Simulation of Fatigue Failure for CFRP Subjected to Multiple-Amplitude Cyclic Loadings Based on Entropy Damage Criterion
por: Deng, Huachao, et al.
Publicado: (2023)

Self-Sensing of Damage Progression in Unidirectional Multiscale Hierarchical Composites Subjected to Cyclic Tensile Loading
por: Ku-Herrera, J. J., et al.
Publicado: (2016)

Acquired contractile ability in human endometrial stromal cells by passive loading of cyclic tensile stretch
por: Kim, Jeonghyun, et al.
Publicado: (2020)

Tensile Fatigue Properties of Ordinary Plain Concrete and Reinforced Concrete under Flexural Loading
por: Chen, Huating, et al.
Publicado: (2023)

Experimental and Numerical Investigation of Effect of Static and Fatigue Loading on Behavior of Different Double Strap Adhesive Joint Configurations in Fiber Metal Laminates
por: Azeem, Muhammad, et al.
Publicado: (2022)

Experimental investigation on fatigue life and tensile strength of carbon fiber-reinforced PLA composites based on fused deposition modeling
por: Kargar, Ehsan, et al.
Publicado: (2023)

Numerical and Experimental UAV Structure Investigation by Pre-Flight Load Test
por: Kurnyta, Artur, et al.
Publicado: (2020)

Numerical Study of the Plastic Zone at the Crack Front in Cylindrical Aluminum Specimens Subjected to Tensile Loads
por: Abatta-Jacome, Lenin, et al.
Publicado: (2023)

Concrete-to-concrete shear friction behavior under cyclic loading: experimental investigation
por: Taklas, Mohamad, et al.
Publicado: (2022)

Numerical and Experimental Study on the Steel Strands under the Coupling Effect of a Salt Spray Environment and Cyclic Loads
por: Yu, Xuanrui, et al.
Publicado: (2020)

Robust Machine Learning Framework for Modeling the Compressive Strength of SFRC: Database Compilation, Predictive Analysis, and Empirical Verification
por: Abbas, Yassir M., et al.
Publicado: (2023)

Experimental /numerical study of a circular rib-stiffened flange connection with inner and outer flange plates under combined bending and tensile loading
por: Chen, Yong, et al.
Publicado: (2022)

Experimental and Numerical Investigation on Fatigue Properties of Carbon Fiber Cross-Ply Laminates in Hygrothermal Environments
por: Xu, Mingrui, et al.
Publicado: (2022)

Numerical Simulation of the Mechanical Behavior of a Weft-Knitted Carbon Fiber Composite under Tensile Loading
por: Ravandi, Mohammad, et al.
Publicado: (2022)

Experimental and Numerical Investigation of the Tensile and Failure Response of Multiple-Hole-Fiber-Reinforced Magnesium Alloy Laminates under Various Temperature Environments
por: Lin, Zhongzhao, et al.
Publicado: (2023)

Enhancing Mechanical Behavior and Energy Dissipation in Fiber-Reinforced Polymers through Shape Memory Alloy Integration: A Numerical Study on SMA-FRP Composites under Cyclic Tensile Loading
por: Eilbeigi, Saeed, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_bp4jak9i5mp08tud0e6rgs8v41