Cargando…

Patient-specific 3D-printed helmet for post-craniectomy defect – a case report

BACKGROUND: Patients who undergo decompressive craniectomy (DC) are often fitted with a helmet that protects the craniectomy site from injury during rehabilitation. However, conventional “one-size-fits-all” helmets may not be feasible for certain craniectomy defects. We describe the production and u...

Descripción completa

Detalles Bibliográficos
Autores principales: Pang, Sherby Suet-Ying, Fang, Evan, Chen, Kam Wai, Leung, Matthew, Chow, Velda Ling-Yu, Fang, Christian
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Springer International Publishing 2022
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8796519/
https://www.ncbi.nlm.nih.gov/pubmed/35089457
http://dx.doi.org/10.1186/s41205-022-00131-1
Descripción
Sumario:BACKGROUND: Patients who undergo decompressive craniectomy (DC) are often fitted with a helmet that protects the craniectomy site from injury during rehabilitation. However, conventional “one-size-fits-all” helmets may not be feasible for certain craniectomy defects. We describe the production and use of a custom 3D-printed helmet for a DC patient where a conventional helmet was not feasible due to the craniectomy defect configuration. CASE PRESENTATION: A 65-year-old male with ethmoid sinonasal carcinoma underwent cranionasal resection and DC with free vastus lateralis flap reconstruction to treat cerebrospinal fluid leakage. He required an external helmet to protect the craniectomy site, however, the rim of a conventional helmet compressed the craniectomy site, and the straps compressed the vascular pedicle of the muscle flap. Computed topography (CT) scans of the patient’s cranium were imported into 3D modelling software and used to fabricate a patient-specific, strapless helmet using fused deposition modelling (FDM). The final helmet fit the patient perfectly and circumvented the compression issues, while also providing better cosmesis than the conventional helmet. Four months postoperatively, the helmet remains intact and in use. CONCLUSIONS: 3D printing can be used to produce low-volume, patient-specific external devices for rehabilitation where standardized adjuncts are not optimal. Once initial start-up costs and training are overcome, these devices can be produced by surgeons themselves to meet a wide range of clinical needs.