Cargando…
Creation of 3D Model of Stainless-Steel Billet’s Grain after Three-High Screw Rolling
The three-high screw rolling of AISI 321 billet from 60 mm to 52 mm diameter was performed using an MISIS-100T mill. When screw rolling was carried out, a set of sections were made in the billet’s cross-section at the stationary stage of screw rolling. SolidWorks was applied to make the 3D model of...
Autores principales: | Skripalenko, Mikhail Mikhailovich, Rogachev, Stanislav Olegovich, Romantsev, Boris Alekseevich, Galkin, Sergei Pavlovich, Kaputkina, Liudmila Mikhailovna, Skripalenko, Mikhail Nikolaevich, Danilin, Andrei Vladimirovich, Fadeev, Viktor Aleksandrovich |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2022
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8838781/ https://www.ncbi.nlm.nih.gov/pubmed/35160940 http://dx.doi.org/10.3390/ma15030995 |
Ejemplares similares
-
Forming Features and Properties of Titanium Alloy Billets After Radial-Shear Rolling
por: Skripalenko, Mikhail Mikhailovich, et al.
Publicado: (2019) -
Statistical Research of Stainless Austenitic Steel Grain Size Distribution after Screw Rolling
por: Skripalenko, Mikhail Mikhailovich, et al.
Publicado: (2020) -
Simulation of the Kinematic Condition of Radial Shear Rolling and Estimation of Its Influence on a Titanium Billet Microstructure
por: Skripalenko, Mikhail M., et al.
Publicado: (2022) -
Microstructure and Hardness of Hollow Tube Shells at Piercing in Two-High Screw Rolling Mill with Different Plugs
por: Skripalenko, Mikhail M., et al.
Publicado: (2022) -
Influence of Laser Beam Wobbling Parameters on Microstructure and Properties of 316L Stainless Steel Multi Passed Repaired Parts
por: Voropaev, Artem Aleksandrovich, et al.
Publicado: (2022)