Investigation on Residual Strength and Failure Mechanism of the Ceramic/UHMWPE Armors after Ballistic Tests

In this paper, the ballistic damage mechanism and residual bearing capacity of ceramic/backing plate armor were investigated. First, a series of lightweight armors were prepared, consisting of ceramic and ultra-high molecular weight polyethylene fiber-reinforced resin matrix composite (UHMWPE) plates, and were wrapped in a high-strength fabric. Then, the ceramic/UHMWPE armors were hit by one or two bullets, and finally subjected to compression testing. The results showed that the main failure mode of integral ceramic/UHMWPE armors was ceramic brittle fracture. Many zigzag patterns on the compression curve indicated that the specimens had undergone the stages of crack propagation, ceramic fragment reorganization, plastic deformation of UHMWPE backing plate, interlaminar tearing, and overall fracture. The failure of spliced ceramic/UHMWPE armors was mainly due to the dislocation between ceramic sheets; the smooth compression curves indicated that there was no recombination of ceramic fragments and obvious interlayer debonding during the compression. Under the maximum load, each ceramic/UHMWPE armor with ballistic damage did not suddenly break and fail. The structure and thickness of ceramic plates all had an impact on residual strength: under the same structure, the greater the thickness, the greater the residual strength, but the relationship between them was not linear; under the same thickness, the residual strength of the spliced ceramic/UHMWPE armor was higher. The residual strength was also related to the number of shots: after two bullets hit, its value was only one-third of that after one bullet hit.