Cargando…

NiCoCrAlX (X = Y, Hf and Si) Bond Coats by Cold Spray for High Temperature Applications

MCrAlX powder compositions (M = Ni,Co and X = Y, Hf, Si or combination) are often thermally sprayed via vacuum plasma spray (VPS), low pressure plasma spray (LPPS) or high velocity oxy-fuel to produce high temperature oxidation and hot corrosion resistant bond coats for thermal barrier coatings (TBC...

Descripción completa

Detalles Bibliográficos
Autores principales:	Cojocaru, Cristian V., Aghasibeig, Maniya, Irissou, Eric
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Springer US 2022
Materias:	Peer Reviewed
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8853232/ https://www.ncbi.nlm.nih.gov/pubmed/37520910 http://dx.doi.org/10.1007/s11666-022-01322-2

Ejemplares similares

On the Importance of Secondary Component Properties for Cold Spray Metallization of Carbon Fiber Reinforced Polymers
por: Liberati, Andre C., et al.
Publicado: (2022)

Improvement of Tool Steel Powder Cold Sprayability Via Softening and Agglomeration Heat Treatments
por: Poirier, D., et al.
Publicado: (2022)

Intermetallic Phase Evolution of Cold-Sprayed Ni-Ti Composite Coatings: Influence of As-Sprayed Chemical Composition
por: Nikbakht, R., et al.
Publicado: (2020)

Peridynamic Simulation of Particles Impact and Interfacial Bonding in Cold Spray Process
por: Ren, Baihua, et al.
Publicado: (2022)

Ensemble Methods for APS In-Flight Particle Temperature and Velocity Prediction Considering Torch Electrodes Ageing
por: Yu, K. R., et al.
Publicado: (2023)

High-Temperature Cycling of Plasma Sprayed Multilayered NiCrAlY/YSZ/GZO/YAG Thermal Barrier Coatings Prepared from Liquid Feedstocks
por: Musalek, Radek, et al.
Publicado: (2020)

Cold Gas Spraying of Nickel-Titanium Coatings for Protection Against Cavitation
por: Mauer, Georg, et al.
Publicado: (2020)

Sealing Treatment of Plasma-Sprayed Cr(3)C(2)-NiCr/Al(2)O(3)-TiO(2) Coating by Aluminum Phosphate Sealant Containing Al(2)O(3) Nanoparticles
por: Van Nguyen, Tuan, et al.
Publicado: (2021)

Development of Bioglass/PEEK Composite Coating by Cold Gas Spray for Orthopedic Implants
por: Garrido, B., et al.
Publicado: (2022)

Effect of Powder Particle Size and Spray Parameters on the Ni/Al Reaction During Plasma Spraying of Ni-Al Composite Powders
por: Zhang, Li, et al.
Publicado: (2021)

Cavitation Resistance of WC-10Co4Cr and WC-20CrC-7Ni HVAF Coatings
por: Korobov, Yu., et al.
Publicado: (2021)

Antiviral and Antibacterial Cold Spray Coating Application on Rubber Substrate, Disruption in Disease Transmission Chain
por: Saha, D. C., et al.
Publicado: (2023)

Microstructure and Properties of Atmospheric Plasma Sprayed (Al,Cr)(2)O(3)–TiO(2) Coatings from Blends
por: Grimm, Maximilian, et al.
Publicado: (2021)

Effect of Various Heat Treatments on the Microstructure of 316L Austenitic Stainless Steel Coatings Obtained by Cold Spray
por: Brassart, Laury-Hann, et al.
Publicado: (2022)

Microstructure and Corrosion Properties of AlCrFeCoNi High-Entropy Alloy Coatings Prepared by HVAF and HVOF
por: Löbel, Martin, et al.
Publicado: (2021)

Effect of Heat Treatment on Residual Stress of Cold Sprayed Nickel-based Superalloys
por: Shrestha, Deepika, et al.
Publicado: (2021)

Mechanical and Fatigue Properties of Diamond-Reinforced Cu and Al Metal Matrix Composites Prepared by Cold Spray
por: Kovarik, O., et al.
Publicado: (2022)

Qualification of the Low-pressure Cold Gas Spraying for the Additive Manufacturing of Copper–Nickel–Diamond Grinding Wheels
por: Tillmann, W., et al.
Publicado: (2021)

Development of Thermal Spray Processes for Depositing Coatings on Thermoplastics
por: Bobzin, Kirsten, et al.
Publicado: (2021)

Optimization of Mechanical Properties of Cr(3)C(2)-Ni20Cr/Graphite Cold Sprayed Coatings
por: Żórawski, Wojciech, et al.
Publicado: (2021)

Biofilm Inhibition and Antiviral Response of Cold Sprayed and Shot Peened Copper Surfaces: Effect of Surface Morphology and Microstructure
por: Razavipour, Maryam, et al.
Publicado: (2022)

3D Microstructure-Based Finite Element Simulation of Cold-Sprayed Al-Al(2)O(3) Composite Coatings Under Quasi-Static Compression and Indentation Loading
por: Sayahlatifi, Saman, et al.
Publicado: (2021)

Thermal Spray Copper Alloy Coatings as Potent Biocidal and Virucidal Surfaces
por: Mostaghimi, J., et al.
Publicado: (2021)

Effect of Al Content on the Microstructure and Properties of As-Cast Al(x)CoCrCuFe Alloys
por: Oliveira, B. S., et al.
Publicado: (2022)

Antibacterial and Virucidal Evaluation of Ultrafine Wire Arc Sprayed German Silver Coatings
por: Bassam, Seyed Navid, et al.
Publicado: (2023)

The Effect of the Substrate on the Microstructure and Tribological Properties of Cold Sprayed (Cr(3)C(2)-25(Ni20Cr))-(Ni-graphite) Cermet Coatings
por: Trelka, Anna, et al.
Publicado: (2022)

Aging Behavior of Water-Based YSZ Suspensions for Plasma Spraying of Thermal Barrier Coatings
por: Yaghtin, Maryam, et al.
Publicado: (2021)

Use of Different Process Gases for Manufacturing Isolating Alumina Coatings by Flame Spraying with Cords
por: Hauer, Michél, et al.
Publicado: (2021)

Fabrication of Porous Aluminum Coating by Cored Wire Arc Spray for Anchoring Antifouling Hydrogel Layer
por: Wen, Jianxin, et al.
Publicado: (2021)

On the Microstructure and Properties of Nb-Ti-Cr-Al-B-Si-X (X = Hf, Sn, Ta) Refractory Complex Concentrated Alloys
por: Thandorn, Tophan, et al.
Publicado: (2021)

Microstructure and Ablation Behavior of Low-Pressure Plasma Sprayed ZrB(2) Coatings Down to 100 Pa
por: Wang, Di, et al.
Publicado: (2021)

Preparation of HfC(x)N(1−x) Nanoparticles Derived from a Multifunction Precursor with Hf-O and Hf-N Bonds
por: Zeng, Guang, et al.
Publicado: (2023)

Capturing the Influence of Jet Fluctuations on Particles in Plasma Spraying
por: Bobzin, K., et al.
Publicado: (2022)

Application of Image Segmentation to Identify In-flight Particles in Thermal Spraying
por: Yao, Yijun, et al.
Publicado: (2022)

Corrosion Behavior and Galvanic Corrosion Resistance of WC and Cr(3)C(2) Cermet Coatings in Madeira River Water
por: Luiz, Leonardo Augusto, et al.
Publicado: (2021)

Mechanical Alloying Integrated with Cold Spray Coating for Fabrication Cu(50)(Ti(50−x)Ni(x)), x; 10, 20, 30, and 40 at.% Antibiofilm Metallic Glass Coated/SUS304 Sheets
por: Aldhameer, Ahmad, et al.
Publicado: (2022)

Evaluation of the Fatigue Behaviour and Failure Mechanisms of 52100 Steel Coated with WIP-C1 (Ni/CrC) by Cold Spray
por: Goanta, Viorel, et al.
Publicado: (2022)

Evaluation of the Fatigue Behavior and Failure Mechanisms of 4340 Steel Coated with WIP-C1 (Ni/CrC) by Cold Spray
por: Goanță, Viorel, et al.
Publicado: (2022)

The Fabrication of Porous Metal-Bonded Diamond Coatings Based on Low-Pressure Cold Spraying and Ni-Al Diffusion-Reaction
por: Zhang, Zhicheng, et al.
Publicado: (2022)

NiB-CrC Coatings Prepared by Magnetron Sputtering Using Composite Ceramic NiCr-BC Target Produced by Detonation Spray Coating
por: Sirota, Viacheslav, et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_39obe3574kmri1g3d445kt1ps5