Effect of Cu Content on the Precipitation Behaviors, Mechanical and Corrosion Properties of As-Cast Ti-Cu Alloys

Ti-Cu alloys have broad application prospects in the biomedical field due to their excellent properties. The properties of Ti-Cu alloys are strongly dependent on Cu content, microstructures, its Ti(2)Cu phase and its preparation process. The aim of this work is to investigate the effect of Cu content on the precipitation behaviors, mechanical and corrosion properties of the as-cast Ti-Cu alloys. The microstructures and phase evolution were characterized by SEM and TEM, and the properties were studied by tensile and electrochemical test. The results show that the volume fraction of Ti(2)Cu phase increases with the increase of Cu content. The Ti(2)Cu phase presents a variety of microscopic morphologies with different Cu content, such as rod, granular, lath and block shaped. The crystal orientation relationships between the Ti(2)Cu and α-Ti matrix in Ti-4Cu and Ti-10Cu alloys are (103)(Ti2Cu/)/(0[1 [Formula: see text] 11)(α-Ti), [[Formula: see text] 01](Ti2Cu/)/[2 [Formula: see text] 0](α-Ti), and (103)(Ti2Cu/)/(0002)(α-Ti), [[Formula: see text] 31](Ti2Cu/)/[1 [Formula: see text] 10](α-Ti), respectively. The tensile strength, Vickers hardness and Young’s modulus of the Ti-Cu alloys increase with the increase of Cu content, whereas the elongation decreases. The fracture morphologies of these alloys reveal ductile, ductile-brittle hybrid, and cleavage brittle mode, respectively. The corrosion resistance of the Ti-Cu alloys in SBF solution can be described as: Ti-4Cu alloy > Ti-10Cu alloy > Ti-7Cu alloy. The volume fraction of Ti(2)Cu phases and the “protective barrier” provided by the fine lath Ti(2)Cu phases strongly affected the electrochemical performances of the alloys.