Cargando…

Simultaneous strength and ductility enhancements of high thermal conductive Ag7.5Cu alloy by selective laser melting

High electrical and thermal conductive metals (HETCM) play a key role in smart electronics, green energy, modern communications and healthcare, however, typical HETCM (e.g., Ag, Au, Cu) usually have relatively low mechanical strength, hindering further applications. Selective laser melting (SLM) is...

Descripción completa

Detalles Bibliográficos
Autores principales:	Xiong, Wei, Hao, Liang, Peijs, Ton, Yan, Chunze, Cheng, Kaka, Gong, Ping, Cui, Qian, Tang, Danna, Al Islam, Shamoon, Li, Yan
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Nature Publishing Group UK 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8917165/ https://www.ncbi.nlm.nih.gov/pubmed/35277561 http://dx.doi.org/10.1038/s41598-022-08182-4

Ejemplares similares

Modulation of Multiple Precipitates for High Strength and Ductility in Al-Cu-Mn Alloy
por: Liu, Linxiang, et al.
Publicado: (2021)

Simultaneous increase in strength and ductility by decreasing interface energy between Zn and Al phases in cast Al-Zn-Cu alloy
por: Han, Seung Zeon, et al.
Publicado: (2017)

Simultaneously enhancing the ultimate strength and ductility of high-entropy alloys via short-range ordering
por: Chen, Shuai, et al.
Publicado: (2021)

Computer Alloy Design of Ti Modified Al-Si-Mg-Sr Casting Alloys for Achieving Simultaneous Enhancement in Strength and Ductility
por: Zhang, Shaoji, et al.
Publicado: (2022)

Microstructure and Dry/Wet Tribological Behaviors of 1% Cu-Alloyed Austempered Ductile Iron
por: Hsu, Cheng-Hsun, et al.
Publicado: (2023)

Hydrogen enhances strength and ductility of an equiatomic high-entropy alloy
por: Luo, Hong, et al.
Publicado: (2017)

In-situ development of a sandwich microstructure with enhanced ductility by laser reheating of a laser melted titanium alloy
por: Chen, Xu, et al.
Publicado: (2020)

Deformation Twinning Induced High Tensile Ductility of a Gradient Nanograined Cu-Based Alloy
por: Wang, Junjie, et al.
Publicado: (2021)

Simultaneously Enhanced Strength and Ductility of Al–Mg–Si Alloys during Aging Process Induced by Electro-Pulsing Treatment
por: Wang, Yitong, et al.
Publicado: (2019)

Achievement of High Strength and Ductility in Al–Si–Cu–Mg Alloys by Intermediate Phase Optimization in As-Cast and Heat Treatment Conditions
por: Zhang, Bingrong, et al.
Publicado: (2020)

Strengthening and Weakening Effects of Particles on Strength and Ductility of SiC Particle Reinforced Al-Cu-Mg Alloys Matrix Composites
por: Yang, Zhiyu, et al.
Publicado: (2021)

Preparing Thick Gradient Surface Layer in Cu-Zn Alloy via Ultrasonic Severe Surface Rolling for Strength-Ductility Balance
por: Sun, Qisheng, et al.
Publicado: (2022)

Design for Fe-high Mn alloy with an improved combination of strength and ductility
por: Lee, Seung-Joon, et al.
Publicado: (2017)

Tailoring heterogeneities in high-entropy alloys to promote strength–ductility synergy
por: Ma, Evan, et al.
Publicado: (2019)

The Effect of Cu:Ag Atomic Ratio on the Properties of Sputtered Cu–Ag Alloy Thin Films
por: Hsieh, Janghsing, et al.
Publicado: (2016)

Mechanical Properties of High-Strength Cu–Cr–Zr Alloy Fabricated by Selective Laser Melting
por: Sun, Fujia, et al.
Publicado: (2020)

Plasticity of nanocrystalline alloys with chemical order: on the strength and ductility of nanocrystalline Ni–Fe
por: Schäfer, Jonathan, et al.
Publicado: (2013)

Theory-guided design of high-entropy alloys with enhanced strength-ductility synergy
por: Pei, Zongrui, et al.
Publicado: (2023)

Highly-Ductile Magnesium Alloys: Atomistic-Flow Mechanisms and Alloy Designing
por: Hamad, Kotiba
Publicado: (2019)

Au-Ag-Cu nano-alloys: tailoring of permittivity
por: Hashimoto, Yoshikazu, et al.
Publicado: (2016)

Microstructure, grain and nanowire growth during selective laser melting of Ag–Cu/diamond composites
por: Xin, Chenxing, et al.
Publicado: (2023)

Microalloying Ultrafine Grained Al Alloys with Enhanced Ductility
por: Jiang, L., et al.
Publicado: (2014)

Achieving High Strength and Good Ductility in As-Extruded Mg–Gd–Y–Zn Alloys by Ce Micro-Alloying
por: Gao, Zhengyuan, et al.
Publicado: (2018)

Achieving High Yield Strength and Ductility in As-Extruded Mg-0.5Sr Alloy by High Mn–Alloying
por: Zhou, Shibo, et al.
Publicado: (2020)

Influence of Si, Cu, B, and Trace Alloying Elements on the Conductivity of the Al-Si-Cu Alloy
por: Yang, Zhao, et al.
Publicado: (2022)

Nanostructured laminar tungsten alloy with improved ductility by surface mechanical attrition treatment
por: Guo, Hong-Yan, et al.
Publicado: (2017)

Dynamically reinforced heterogeneous grain structure prolongs ductility in a medium-entropy alloy with gigapascal yield strength
por: Yang, Muxin, et al.
Publicado: (2018)

A cross-shear deformation for optimizing the strength and ductility of AZ31 magnesium alloys
por: Hamad, Kotiba, et al.
Publicado: (2016)

Enhancing strength and ductility via crystalline-amorphous nanoarchitectures in TiZr-based alloys
por: Ming, Kaisheng, et al.
Publicado: (2022)

Manipulating the ordered oxygen complexes to achieve high strength and ductility in medium-entropy alloys
por: Jiao, Meiyuan, et al.
Publicado: (2023)

How Can We Overcome the Strength–Ductility Tradeoff in Light Alloys and Related Composites?
por: Gao, Tong, et al.
Publicado: (2023)

Nano‐Dual‐Phase Metallic Glass Film Enhances Strength and Ductility of a Gradient Nanograined Magnesium Alloy
por: Liu, Chang, et al.
Publicado: (2020)

Influence of Solidification Conditions on the Microstructure of Laser-Surface-Melted Ductile Cast Iron
por: Janicki, Damian, et al.
Publicado: (2020)

Design and Ductile Behavior of Torsion Configurations in Material Extrusion to Enhance Plasticizing and Melting
por: Jian, Ranran, et al.
Publicado: (2021)

Viscosity and Electrical Conductivity of the Liquid Sn-3.8Ag-0.7Cu Alloy with Minor Co Admixtures
por: Yakymovych, A., et al.
Publicado: (2016)

Colorful Conductive Threads for Wearable Electronics: Transparent Cu–Ag Nanonets
por: Tang, Yan, et al.
Publicado: (2022)

Cu Nanowires and Nanoporous Ag Matrix Fabricated through Directional Solidification and Selective Dissolution of Ag–Cu Eutectic Alloys
por: Xu, Jiaxing, et al.
Publicado: (2022)

The Influence of Ag on the Microstructure and Properties of Cu-Ni-Si Alloys
por: Krupińska, Beata, et al.
Publicado: (2020)

Relationship between Microstructure and Properties of Cu–Cr–Ag Alloy
por: Liang, Dong, et al.
Publicado: (2020)

Effect of Ag on Properties, Microstructure, and Thermostability of Cu–Cr Alloy
por: Sun, Yuqing, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_2r708p7o5m2365mia0r3kv76ia