Cargando…

Eliminating the Brittleness Constituent to Enhance Toughness of the High-Strength Steel Weld Heat-Affected Zone Using Electropulsing

The evolution of the martensite–austenite (MA) constituent in the heat-affected zone (HAZ) of high-strength steel FH690 welds when subjected to electropulsing (EP) treatment was investigated herein, with the aim of eliminating brittle MA to enhance toughness. The features induced by EPT were correla...

Descripción completa

Detalles Bibliográficos
Autores principales:	Chen, Zhanglan, Xiong, Yunfeng, Li, Xiaowen, Li, Zongmin
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2022
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC8953774/ https://www.ncbi.nlm.nih.gov/pubmed/35329583 http://dx.doi.org/10.3390/ma15062135

Ejemplares similares

Toughening and Hardening Limited Zone of High-Strength Steel through Geometrically Necessary Dislocation When Exposed to Electropulsing
por: Xiong, Yunfeng, et al.
Publicado: (2022)

Effect of Welding Peak Temperature on Microstructure and Impact Toughness of Heat-Affected Zone of Q690 High Strength Bridge Steel
por: Zhang, Yue, et al.
Publicado: (2021)

Solidification Crack Evolution in High-Strength Steel Welding Using the Extended Finite Element Method
por: Chen, Zhanglan, et al.
Publicado: (2020)

Effect of Post-Weld Heat Treatment on Microstructure and Fracture Toughness of X80 Pipeline Steel Welded Joint
por: Wang, Xueli, et al.
Publicado: (2022)

Effect of Molybdenum on the Impact Toughness of Heat-Affected Zone in High-Strength Low-Alloy Steel
por: Wu, Xiaoyan, et al.
Publicado: (2021)

Influence of Post-Weld Heat Treatment on Microstructure and Toughness Properties of 13MnNiMoR High Strength Low Alloy Steel Weld Joint
por: Tian, Songya, et al.
Publicado: (2021)

Room temperature texturing of austenite/ferrite steel by electropulsing
por: Rahnama, Alireza, et al.
Publicado: (2017)

Corrosion Behavior of an AISI/SAE Steel Cut by Electropulsing
por: Montilla, Carlos Alberto, et al.
Publicado: (2019)

Brittle fracture of welded plate
por: Hall, W J, et al.
Publicado: (1967)

Impact Toughness of Subzones in the Intercritical Heat-Affected Zone of Low-Carbon Bainitic Steel
por: Li, Zhenshun, et al.
Publicado: (2018)

Investigation of Welds and Heat Affected Zones in Weld Surfacing Steel Plates Taking into Account the Bead Sequence
por: Mičian, Miloš, et al.
Publicado: (2020)

Effect of Temperature on S32750 Duplex Steel Welded Joint Impact Toughness
por: Perković, Srđa, et al.
Publicado: (2023)

Effect of Initial Microstructure on the Toughness of Coarse-Grained Heat-Affected Zone in a Microalloyed Steel
por: Shi, Minghao, et al.
Publicado: (2021)

Influence of Electropulsing Treatments on Mechanical Properties of UNS S32750 Duplex Stainless Steel
por: Gennari, Claudio, et al.
Publicado: (2020)

Evolution of Microstructure in Welding Heat-Affected Zone of G115 Steel with the Different Content of Boron
por: Chen, Zhongyi, et al.
Publicado: (2022)

Comparison of Fracture Toughness in the Coarse-Grain Heat-Affected Zone of X80 Pipelines Girth-Welded under Conventional and Ultra-Low Heat Input
por: Liu, Shuo, et al.
Publicado: (2022)

Effect of H(2)S Corrosion on the Fracture Toughness of the X80 Pipeline Steel Welded Joint
por: Wang, Xueli, et al.
Publicado: (2022)

Characterizing Oxide Inclusions in Welded Lean Duplex Stainless Steels and Their Influence on Impact Toughness
por: Moonngam, Suphitcha, et al.
Publicado: (2023)

Post-Weld Heat Treatment of API 5L X70 High Strength Low Alloy Steel Welds
por: Alipooramirabad, Houman, et al.
Publicado: (2020)

Technological, Microstructural and Strength Aspects of Welding and Post-Weld Heat Treatment of Martensitic, Wear-Resistant Hardox 600 Steel
por: Konat, Łukasz
Publicado: (2021)

Voids healing and carbide refinement of cold rolled M50 bearing steel by electropulsing treatment
por: Wang, Feng, et al.
Publicado: (2019)

Microstructure Effect of Heat Input on Ballistic Performance of Welded High Strength Armor Steel
por: Souza, Elson Renato Santos, et al.
Publicado: (2021)

Fracture Toughness, Breakthrough Morphology, Microstructural Analysis of the T2 Copper-45 Steel Welded Joints
por: Ding, Hao, et al.
Publicado: (2020)

Microstructure and Properties of Heat Affected Zone in High-Carbon Steel after Welding with Fast Cooling in Water
por: Brykov, Michail Nikolaevich, et al.
Publicado: (2020)

Effects of Boron Content on the Microstructure and Impact Toughness of 12Cr1MoVR Low-Alloy Heat-Resistant Steel Weld Metals
por: Dou, Guishan, et al.
Publicado: (2021)

Role of Reversed Austenite Behavior in Determining Microstructure and Toughness of Advanced Medium Mn Steel by Welding Thermal Cycle
por: Chen, Yunxia, et al.
Publicado: (2018)

Healing of Fatigue Crack by High-Density Electropulsing in Austenitic Stainless Steel Treated with the Surface-Activated Pre-Coating
por: Hosoi, Atsushi, et al.
Publicado: (2013)

Microstructure and Local Mechanical Properties of the Heat-Affected Zone of a Resistance Spot Welded Medium-Mn Steel
por: Stadler, Manfred, et al.
Publicado: (2021)

Comparison of Microstructure and Mechanical Properties of High Strength and Toughness Ship Plate Steel
por: Wang, Dong, et al.
Publicado: (2021)

Ductile-to-Brittle Transition and Brittle Fracture Stress of Ultrafine-Grained Low-Carbon Steel
por: Inoue, Tadanobu, et al.
Publicado: (2021)

Mechanism of BN-Promoting Acicular Ferrite Nucleation to Improve Heat-Affected Zone Toughness of V-N-Ti Microalloyed Offshore Steel
por: Shi, Zhongran, et al.
Publicado: (2022)

Novel Approach of Nanostructured Bainitic Steels’ Production with Improved Toughness and Strength
por: Kirbiš, Peter, et al.
Publicado: (2020)

Alloy Partitioning Effect on Strength and Toughness of κ-Carbide Strengthened Steels
por: Field, Daniel M., et al.
Publicado: (2022)

Effect of Tempforming on Strength and Toughness of Medium-Carbon Low-Alloy Steel
por: Yuzbekova, Diana, et al.
Publicado: (2023)

Toughness and brittleness in metals: lectures delivered at the Institution of Metallurgists refresher course, 1960
por: Institution of Metallurgists. London
Publicado: (1961)

Multiblock copolymers of PPC with oligomeric PBS: with low brittle–toughness transition temperature
por: Qin, Jiaxiang, et al.
Publicado: (2018)

Numerical Investigation of the Influence of Ultimate-Strength Heterogeneity on Crack Propagation and Fracture Toughness in Welded Joints
por: Bi, Yueqi, et al.
Publicado: (2022)

Manufacture and Performance of Welds in Creep Strength Enhanced Ferritic Steels
por: Parker, Jonathan, et al.
Publicado: (2019)

Effect of Mg Addition on the Microstructure and Properties of a Heat-Affected Zone in Submerged Arc Welding of an Al-Killed Low Carbon Steel
por: Li, Yandong, et al.
Publicado: (2021)

Fracture Toughness Testing of Brittle Laminated Geomaterials Using Hollow Double-Wing Slotted Specimens
por: Yao, Zilong, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_uo3b5j6toi5ogkfr8oca4q8ukr